Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

Policy considerations for wetland wastewater treatment in the coastal zone: A case study for Louisiana

Two major environmental problems currently affecting the Louisiana coastal zone are a high rate of wetland loss and high levels of surface water pollution. The application of secondarily treated wastewater to wetlands can be a means of dealing with both of these problems. The benefits of wetland wastewater treatment include improved surface water quality, increased accretion rates to balance a high relative water level rise due mainly to subsidence, improved plant productivity and habitat quality, and decreased capital outlays for conventional engineering treatment systems. Wetland treatment systems can, therefore, be designed and operated to restore deteriorating wetlands. Hydrologically altered wetlands, which are common in the Louisiana coastal zone, are appropriate for receiving municipal and some types of industrial effluent. While the U.S. Environmental Protection Agency has determined wetland wastewater treatment is effective in treating municipal effluent, it has discouraged the use of natural wetlands for this purpose. At the same time, funds are being used for the construction of artificial wetlands to treat municipal effluent. In the Louisiana coastal zone, however, wetlands are deteriorating and disappearing due to hydrological alteration and a high rate of relative sea level rise. If no action is taken, these trends will continue. Effluent discharge to existing wetlands should be incorporated into a comprehensive management plan designed to increase sediment and nutrient input into subsiding wetlands in the Louisiana coastal zone, improve water quality, and result in more economical waste‐water treatment. The authors believe that the Louisiana example serves as a model for other coastal areas especially in light of projections of accelerated sea level rise.     

Changing ownership structures in the Dutch fleet

The new Dutch shipping policy has given rise to high expectation and curiosity in the world of shipping. This, together with the obvious difficulties of an ex-post study of the effectiveness of such innovative policy, has prompted the authors to take an interest in attempting to investigate changes in ownership of the Dutch fleet 2 years after the new policy has been introduced. To do this, a rather new concept of ‘flagging out’ has been adopted, which is interpreted as a process leading to different degrees of ‘foreignness’ in a shipping operation. In this paper, a method to structure is presented, and ownership information, and changes in it are presented, that are essentially based on the theory of stochastic processes. The data used is the Dutch fleet data, which includes information on the nationality of the flag, parent ownership and management over the period 1994–1998. The results yield interesting insights in the shifts in the ownership and operational structure of shipping companies induced by the new policy. In particular, they allow one to establish the origin of new vessels, in which stage of ownership/operation it is most likely that shifts occur, and to determine the relationship between the different stages of the ‘flagging out’ process. These results, thus, enable an evaluation of the areas in which the policy can be expected to yield results.     

Management of corals and coral ecosystems in the United States

Abstract

Corals and coral communities provide substantial societal benefits by virtue of their recreational and esthetic appeal, the habitat provided for commercially harvested fish and shellfish, the structural foundation provided for productive coastal ecosystems, and the market value of harvested coral specimens. Coral resources are subject to adverse effects from pollution, dredging, specimen collecting, anchor damage, commercial fishing, overharvesting, and activities related to offshore petroleum development. Management programs which protect coral resources in the United States comprise a patchwork of separate federal and state programs. They attempt to adapt broad regulatory authorities for parks, fisheries, offshore mineral resources, and other subjects for the purpose of coral conservation. These programs embody species‐specific, area‐specific, and generic approaches to coral management. This paper traces the evolution of U.S. coral management programs and comments on their respective strengths and weaknesses. Alternative approaches for strengthening management systems could include new coordinating committees, legislation, memoranda of agreement between involved agencies, and others.     

Analysis of single pipeline pull-in procedure using small scale models

The structural elastic behaviour of steel pipelines during on-bottom pull-in procedure is investigated experimentally by using small scale models. Despite the lack of a sea-bed soil pipeline interaction effect in the model, it is possible to show that the unevenness of the sea-bed surface and the non-uniform distribution of friction forces can lead to large deflection bending stresses, higher than the numerical results yielded by standard software packages commonly used for design calculations. Due to foreseen difficulties in overcoming the drawbacks in practical and numerical procedures, the off-bottom pull-in operation arises as an attractive alternative even for shallow waters.     

Dynamics of inorganic nutrient species in the Bohai seawaters

Within the frame of a Sino-German Joint Research Program, two cruises of “R/V Dong Fang Hong 2” were carried out in September–October 1998 and April–May 1999, respectively, to understand the dynamics of nutrients in the Bohai. Nutrient species (NO₃⁻, NO₂⁻, NH₄⁺, PO₄³⁻ and SiO₃²⁻) are determined colorimetrically on board for five anchor and 30 grid stations. In situ incubation experiments are performed to determine planktonic nutrient uptake and benthic exchange flux. Nutrient concentrations display short-term variability and seasonal change in the Bohai, with higher levels in shallow coastal waters than in the Central Bohai. The influence of riverine discharge on nutrient levels can be seen from salinity isopleths, nutrient distribution and species ratios. Near-bottom (nb) waters have similar nutrient concentrations as to the surface waters in the Central Bohai, whereas stratification takes place in the Bohai Strait and North Yellow Sea. In situ incubation experiments provide evidence that the uptake ratio (i.e. N, P) by phytoplankton is proportional to the ratios among nutrient species in ambient waters. Based on the data of this study and previously publications, a preliminary estimate of nutrient budgets via riverine input and atmospheric deposition is established. The results indicate that atmospheric deposition gains importance over rivers in delivering nutrients into the Bohai and sustain the new production, following recent decrease in riverine inflow caused by drought periods in North China and damming practices. A historical review of nutrient data indicates that concentrations of nitrogen increase and phosphorus and silica decrease in the Central Bohai over last 40 years. This potentially has an important influence on the health of ecosystem in Bohai (e.g. food web and community structure), though further study is needed to examine the scenario in more detail.     

Nanoparticle emission characteristics and reduction strategies by boost pressure control and injection strategies in a passenger diesel engine

This research attempted to analyze nanoparticles and other harmful exhaust emissions in accordance with injection strategies and air-fuel ratio (AFR) changes for small diesel engines. The emission characteristics were analyzed in the medium-speed condition, which is the main driving range of a diesel engine. In the case of particulate matter (PM), the number of particles was measured, analyzed, and compared to identify the correlation and emission characteristics of nanoparticles by using a dilution device and condensation particle counter (CPC), which are international standards for particle measurement recommended by the Particulate Measurement Programme (PMP). The engine torque tended to be reduced as pilot injections were added, and the torque was increased by the increased boost pressure, but reduced by the exhaust pressure increase in a part of the low-load range. The number of nanoparticles was not influenced greatly by the change in AFR, but the reduction effect on the PM weight was great depending on the boost pressure increase. In addition, the number of nanoparticles tended to increase as the fuel injection timing became closer to TDC in all conditions, and its difference became larger with an increase in AFR. In addition, in the case of the pilot injection, nanoparticle emission showed similar characteristics depending on the main injection timing, but it was increased by advanced injection timing when performing the main injection only, and the number of the nanoparticles increased as pilot injections were added. Last, the optimal conditions for EMS calibration were analyzed by selecting the conditions of torque reduction and NOx increase within 5 % from all of the engine operating conditions; optimized conditions are presented.     

The structure of dissipation in the western Irish Sea front

We report on an intensive campaign in the summer of 2006 to observe turbulent energy dissipation in the vicinity of a tidal mixing front which separates well mixed and seasonally stratified regimes in the western Irish Sea. The rate of turbulent dissipation ε was observed on a section across the front by a combination of vertical profiles with the FLY dissipation profiler and horizontal profiles by shear sensors mounted on an AUV (Autosub). Mean flow conditions and stratification were obtained from a bed mounted ADCP and a vertical chain of thermistors on a mooring. During an Autosub mission of 60 h, the vehicle, moving at a speed of ~ 1.2 m s^− 1, completed 10 useable frontal crossings between end points which were allowed to move with the mean flow. The results were combined with parallel measurements of the vertical profile of ε which were made using FLY for periods of up to 13 h at positions along the Autosub track. The two data sets, which show a satisfactory degree of consistency, were combined to elucidate the space–time variation of dissipation in the frontal zone. Using harmonic analysis, the spatial structure of dissipation was separated from the strong time dependent signal at the M₄ tidal frequency to yield a picture of the cross-frontal distribution of energy dissipation. A complementary picture of the frontal velocity field was obtained from a moored ADCP and estimates of the mean velocity derived from the thermal wind using the observed density distribution. which indicated the presence of a strong (0.2 m s^− 1) jet-like flow in the high gradient region of the front. Under neap tidal conditions, mean dissipation varied across the section by 3 orders of magnitude exceeding 10^− 2 W m^− 3 near the seabed in the mixed regime and decreasing to 10^− 5 W m^− 3. in the strongly stratified interior regime. The spatial pattern of dissipation is consistent in general form with the predictions of models of tidal mixing and does not reflect any strong influence by the frontal jet.     

Model Test on Grouting Law in Dynamic Water-Rich Sand Layers by the Electric Resistance Method北大核心CSCD

In order to study the diffusion law of grouting slurry in the water-rich sand layer under flowing water conditions, a grouting test model consisting of a main test system, a grouting system, and a measurement system was developed. And for detecting the diffusion scope of the grouts, a new resistivity method was proposed. It is found that the relationship between grouting pressure and grouting rate during the test is strong. Under hydrodynamic conditions, the grouting slurry diffuses elliptically. Due to gravity and the effect of the upper water flow, the center of gravity of the ellipsoid is below the grouting outlet, and the grouting effectively improves the physical and mechanical properties of water-rich sand bodies. At the same time, the resistivity method has a good application effect on the detection of grouting diffusion range. The range of slurry diffusion obtained by the resistivity method is basically consistent with the boundary of the stone body after excavation, indicating that the resistivity method is reliable for detection of grouting range in dynamic water-rich sand layer. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.