微注射成形实验与数值模拟

为研究注射料的流动性和模腔形状的复制能力,加工了含有微流道的模具,在微注射系统上进行了微注射实验.应用基于矢量化显式算法的程序,在不同壁面边界条件下,对微注射实验进行了模拟.结果表明:在注射料温度220 ℃、模具温度40 ℃、注射流量为20 mm3/s、注射时间1 s、保压时间10 s的注射工艺条件下,聚丙烯能较好的复制长5 mm,宽1.5 mm和厚0.8 mm的微流道形状.采用滑移边界条件的微注射模拟结果与实验结果一致,说明微注射中存在边界滑移速度.     

In situ colonization of marine biofilms on UNS S32760 duplex stainless steel coupons in areas with different water qualities: Implications for corrosion potential behavior

In the presence of biofilms, stainless steels （SS） exhibits an increase in corrosion potential, called ennoblement. In the present study, the corrosion potential （Eco,） behavior of the duplex SS UNS S32760 was recorded simultaneously with the in situ marine biofilm formation in two areas at Arraial do Cabo, Southeastern Brazil. The biofilm at Forno Harbor （an anthropogenically disturbed area） was characterized by higher relative abundances of Bacteria at day 2, followed by diatoms （especially Navicula sp.） on day 10 and dinoflagellates on day 18, whereas no clear trend was recorded at Cabo Frio Island （an undisturbed area）. The ennoblement of Ecor values was site-dependent. In a complementary laboratory assay, biofilms were removed and the Eco values registered in sterile conditions for the subsequent 10 days and corroborated in situ results. Understanding biofilms and SS interactions has important implications for materials science and engineering decisions as well as helping to fill in imnortant gaps in this knowledge.     

Mixing over the steep side of the Cycladic Plateau in the Aegean Sea

Intensive microstructure sampling over the southern slope of the Cycladic Plateau found very weak mixing in the pycnocline, centered on a thin minimum of diapycnal diffusivity with Kρ=1.5×¹⁰−6 m² s^− 1. Below the pycnocline, Kρ increased exponentially in the bottom 200 m, reaching 1 × 10^− 4 m² s^− 1 a few meters above the bottom. Near-bottom mixing was most intense where the bottom slope equaled the characteristic slope of the semi-diurnal internal tide. This suggests internal wave scattering and/or generation at the bottom, a conclusion supported by near-bottom dissipation rates increasing following rising winds and with intensifying internal waves. Several pinnacles on the slope were local mixing hotspots. Signatures included a vertical line of strong mixing in a pinnacle's wake, an hydraulic jump or lee wave over a downstream side of the summit, and a ‘beam’ sloping upward at the near-inertial characteristic slope. Because dissipation rate averages were dominated by strong turbulence, ?/νN² > 100, the effect on Kρ of alternate mixing efficiencies proposed for this range of turbulent intensity is explored.     

Impact of phytoplankton community size on a linked global ocean optical and ecosystem model

We isolated the effect phytoplankton cell size has on varying remote sensing reflectance spectra (R_rs(λ)) in the presence of optically active constituents by using optical and radiative transfer models linked in an offline diagnostic calculation to a global biogeochemical/ecosystem/circulation model with explicit phytoplankton size classes. Two case studies were carried out, each with several scenarios to isolate the effects of chlorophyll concentration, phytoplankton cell size, and size-varying phytoplankton absorption on R_rs(λ). The goal of the study was to determine the relative contribution of phytoplankton cell size and chlorophyll to overall R_rs(λ) and to understand where a standard band ratio algorithm (OC4) may under/overestimate chlorophyll due to R_rs(λ) being significantly affected by phytoplankton size. Phytoplankton cell size was found to contribute secondarily to R_rs(λ) variability and to amplify or dampen the seasonal cycle in R_rs(λ), driven by chlorophyll. Size and chlorophyll were found to change in phase at low to mid-latitudes, but were anti-correlated or poorly correlated at high latitudes. Phytoplankton size effects increased model calculated R_rs(443) in the subtropical ocean during local spring through early fall months in both hemispheres and decreased R_rs(443) in the Northern Hemisphere high latitude regions during local summer to fall months. This study attempts to tease apart when/where variability about the OC4 relationship may be associated with cell size variability. The OC4 algorithm may underestimate [Chl] when the fraction of microplankton is elevated, which occurs in the model simulations during local spring/summer months at high latitudes in both hemispheres.     

光纤传感器系统在土工结构的静动应变测量上的应用

评估了光纤传感器作为完整的结构部件在恶劣的环境条件下,进行长期或短期应变监测的可行性.不同的规模和材料的土工试验过程中已经使用了光纤传感器.实例研究包括静力轴向的钻孔桩测试、钻孔测斜、试验室的单轴压缩测试.     

Further study on the ultimate strength analysis of spherical pressure hulls

From a comparative study it is concluded that current design rules for the spherical pressure hull of manned submersible need to be updated and unified. In this paper, a series of spherical pressure hulls are calculated by nonlinear FEM. Based on these numerical results, the influence of critical arch length and the relationship of ultimate strength with t/R and structural imperfection are studied. Finally, empirical formulae for the ultimate strength of the titanium alloy spherical pressure hull of deep manned submersible based on numerical computations are given. The formulae can be used as the core equations to update current design rules.     

���߽�ͨ���ź��Ż�����:�ع���ǰհ

概括地回顾了一些关于离线(或脱机)交通信号灯优化设计的方法.其中包括用于在孤立交叉口的单点和区域性的联动控制系统.离线方法在设计时一般利用已有调查出来的交通数据作为固定的输入资料，这个跟实时设计方法所要求的从感应器即时检浏出来的情况作为设计依据是有本质上的区别.但一般沿用的信号配时设计方法都需要依靠已刻在行车线道上(允许通行)的方向指示标志为设计基础，但这个方向指示在确定后在整个优化过程中是维持不变的，这就限制了交通流量在线道上的分布，从而大大减低配时的灵活性，在这样情况下优化出来的结果肯定不会是最好的.直至近期，以行车线道为基本单位的配时设计方法(英文名称为Lane-based method;中文可称为线道法)发展起来.这个方法是由传统的Phase-based method(相位法)所演变出来的.线道法不但包含所有相位法的特点，而且更能为原本受约束的线道和配时设计进行全面优化.线道法可在单点交叉口和区域性的联动控制系统上应用.文末提出一些未来研究发展的新方向.     

Examining the influence of firm performance on business risk-taking and the mediation effect of scale of operations in the container terminal industry

Container shipping and its related service sectors help accelerate globalization of the world economy. This industry has been experiencing rapid growth, prompting container terminal operators to increase their handling capacity in response. Providing container terminal services requires substantial capital investment in physical assets such as cargo handling facilities and information systems. On the other hand, operating container terminals is a long-term investment that typically spans several business cycles. Hence prudent asset management using appropriate tools is critical for container terminal operators to sustain their businesses. Generally, due to risk-adverseness, investors are unwilling to take more risk in their investment unless they can reap a higher return. Contrary to this argument, this study finds no direct influence of better firm performance as a proxy of higher return on business risk-taking by container terminal operators. Instead, scale of operations is positively associated with business risk-taking, suggesting that container terminal operators with a larger scale of operations are willing to take more business risk.     

Black Boxes - Pathetic progress but some success now in sight

Little has been written about the ship demolition market, an essential element in the supply/demand balance for shipping. Either technical or economic obsolescence may be the cause for scrapping a ship, where the latter is strongly influenced not only by anticipated freight market levels, but the rate at which more efficient ships are being introduced. The scrap value of a ship is a function both of the realizable value of the materials within the ship and cost of demolition. Both are strongly influenced by the cost structures prevailing in the likely country of demolition. The paper explores not only the fundamentals of the ship demolition market, but the trends from the 1960s to the present. The shipbreaking market has moved in that time from being West European-centred to Asian-centred, concentrating for some years in Taiwan, but now shifting to the Indian subcontinent.     

Evaluation of factors for carrier selection in the China Pearl River delta

The efficient integration of logistics modes is critical for international cargo shipping. The local transportation connecting to the export port then plays a vital role in such integration. This paper investigates the problems of carrier selection in the China Pearl River delta area, with respect to international shipping. The analytical hierarchy process (AHP) model is constructed based on a comprehensive industrial interviews and statistical analysis. Rather than simply ranking the given alternatives, we use AHP is used to analyse the weakness and strength of impacting factors in carrier selection. The model is implemented under different types of shipper. Seven criteria are statistically summarized from the questionnaire for evaluating eight different modes. The results are useful to those liner companies serving the PRD region in relationship to port selection and fleet deployment.