An Optimal Self-Tuning Controller for an Active Suspension

An optimal self-tuning control algorithm is presented for vehicle suspension design. The controller, incorporating a weighting controller, state observer and parameter estimator, is designed according to linear optimal control (LQG) theory. Based on the updated estimates of vehicle parameters and states, and the adapted weighting parameters, the LQG controller provides the optimal set of gains over different operating conditions. The feasibility and effectiveness of the proposed self-tuning system was investigated and proved by simulation studies.     

含水率对路用水泥混凝土的影响及微波在线测湿系统

在讨论了含水率对路用土质量的影响因素后，通过对不同种类测试器的分析，确定了较为适用的微波传感器，并给出了微波传感器的输出电压与集料含水率之间的关系式，进而对测试准确度进行计算。     

Fuzzy Logic Active and Semi-Active Control of Off-Road Vehicle Suspensions

For off-road vehicles, minimizing the absorbed power is the main objective of suspension control. The primary cause of increase in the absorbed power in off-road vehicles driven at high speeds on harsh courses is the exhaustion of the suspension travel. Fuzzy-logic approach to active and semi-active off-road vehicle suspension control, with the goal of improving the speed of the vehicle over rough terrains are developed. The ride metric used for quantifying improvements is the absorbed power of the sprung mass. Particular attention is paid to the proper modeling of the suspension using both the full kinematic constraints and the more convenient two degree of freedom linear model of the quarter vehicle suspension. The nonlinearities due to the kinematic constraints on motion are accounted for by modifying the stiffness and damping coefficients of the suspension spring and dashpot in the linear model. The control laws are developed using the less complex model and demonstrated in the fully constrained environment. Nonlinearities of the suspension, including tire stiffness/damping and bumpstops are included at all stages of controller development.     

柴油机曲轴有限元计算与台架试验数据对比分析

目前，国内柴油机行业普遍使用的曲轴弯曲疲劳强度试验台架，均采用音叉共振板结构。该试验台架对于大多数常规结构曲轴的连杆轴颈圆角疲劳强度的测定是比较准确的，但对于有些特殊结构曲轴的试验，却未能取得理想结果。以某曲轴台架试验、台架仿真模型及有限元计算模型数据为基础，分析对比了不同模型数据的差异及产生原因。     

An adaptive lateral preview driver model

Successful modelling and simulation of driver behaviour is important for the current industrial thrust of computer-based vehicle development. The main contribution of this paper is the development of an adaptive lateral preview human driver model. This driver model template has a few parameters that can be adjusted to simulate steering actions of human drivers with different driving styles. In other words, this model template can be used in the design process of vehicles and active safety systems to assess their performance under average drivers as well as atypical drivers. We assume that the drivers, regardless of their style, have driven the vehicle long enough to establish an accurate internal model of the vehicle. The proposed driver model is developed using the adaptive predictive control (APC) framework. Three key features are included in the APC framework: use of preview information, internal model identification and weight adjustment to simulate different driving styles. The driver uses predicted vehicle information in a future window to determine the optimal steering action. A tunable parameter is defined to assign relative importance of lateral displacement and yaw error in the cost function to be optimized. The model is tuned to fit three representative drivers obtained from driving simulator data taken from 22 human drivers.     

Wheel-rail contact models for vehicle system dynamics including multi-point contact

Advanced modelling of rail vehicle dynamics requires realistic solutions of contact problems for wheels and rails that are able to describe contact singularities, encountered for wheels and rails. The basic singularities demonstrate themselves as double and multiple contact patches. The solutions of the contact problems have to be known practically in each step of the numerical integration of the differential equations of the model. The existing fast, approximate methods of solution to achieve this goal have been outlined. One way to do this is to replace a multi-point contact by a set of ellipses. The other methods are based on so-called virtual penetration. They allow calculating the non-elliptical, multiple contact patches and creep forces online, during integration of the model. This allows nearly real-time simulations. The methods are valid and applicable for so-called quasi-Hertzian cases, when the contact conditions do not deviate much from the assumptions of the Hertz theory. It is believed that it is worthwhile to use them in other cases too.     

Fuzzy-logic applied to yaw moment control for vehicle stability

In this paper, we propose a new yaw moment control based on fuzzy logic to improve vehicle handling and stability. The advantages of fuzzy methods are their simplicity and their good performance in controlling non-linear systems. The developed controller generates the suitable yaw moment which is obtained from the difference of the brake forces between the front wheels so that the vehicle follows the target values of the yaw rate and the sideslip angle. The simulation results show the effectiveness of the proposed control method when the vehicle is subjected to different cornering steering manoeuvres such as change line and J-turn under different driving conditions (dry road and snow-covered).     

Target priority determination methods by interval-valued intuitionistic fuzzy sets with unknown attribute weights

The paper aims at the problem of multi-targets threat degree being hard to be evaluated accurately in complex air defense battlefield environments. Combined with multi-sensors information fusion and interval-valued intuitionistic fuzzy sets (IVIFS) theories, the target priority determination is studied. The score and accuracy functions of IVIFS are improved with thinking about the hesitating information in order to increase the rationality. Then, the influence factors of target priority and the nonlinear relationship between the influence factors and target priority are analyzed. Next, the algorithms for calculating the factor weights and sensor weights are given. Based on the theory of IVIFS and technique for order preference by similarity to an ideal solution (TOPSIS), two methods of target priority determination based on the IVIFS and TOPSIS are proposed. At last, an application example verifies the effectiveness and flexibility of the proposed algorithms.     

The merits of accelerated depreciation for promoting investment in clean transport technologies: A simulation study in the Australian rail freight industry

This article ascertains the viability of promoting accelerated depreciation for newly acquired locomotives and other rolling stock as a means of encouraging technological investment in more efficient and environmentally friendly assets. The study uses a tax-adjusted asset replacement model to evaluate the merits of accelerated depreciation, and then compares the outcomes with alternative incentive schemes. It also examines what would occur if various schemes were used simultaneously.     

Redefining activity types: Who participates in which leisure activity?

This paper analyzes the activity choices of individuals and the links between socio-demographics, daily schedules and activity attributes using a new activity choice framework. Activities are first clustered into groups based on their salient attributes, such as duration, frequency, flexibility, planning times, and number of involved persons, rather than their functional types (work, leisure and household obligations), using a K-means cluster technique. This led to the creation of several new activity groups such as “long, temporally fixed, personally flexible activities”, “short and flexible activities”. These activity groups form the choice set for the mixed logit activity choice modeling structure developed for the leisure activities in the second part of the paper. The model results reveal the significant relationships between socio-demographics, temporal characteristics, and characteristics of the schedules on leisure activity choice. The results demonstrate how changing demographics and other activities in individuals’ schedules may affect the nature of the leisure activities and present the substitution and complimentary effects that these new activity groups have on one another.