Numerical Study for Brake Squeal by Machining Patterns on Frictional Surface

Automotive brake noise has become a stubborn problem as automotive cars achieve higher driving torques, since that the increased torque induces the generation of severe noise dissipation during brake operation. Moreover, the global brake tuning market for achieving higher performance of the vehicle has expanded recently. The need to control the noise grows more in this connection. The tuning brake kits have employed cross-drilled and slotted machining pattern on the surface of the rotor. These designs have advantages to improve air ventilation, temperature control, and surface cleaning of brake pad. However, the effects of modal frequency by patterned rotor surfaces are rarely discussed, even if it is highly related with brake squeal phenomenon. Therefore, this study deals with the relationship between patterned surfaces and brake squeal through the numerical methods. The commercial software of a finite element analysis is employed for calculation by varying geometric design factors of each rotor pattern. As a result, the cross-drilled machining patterns are concluded to be an influential factor for in-plane mode frequency while the slotted patterns have more leverage for out-of-plane mode frequency.     

Revisiting the application of simultaneous perturbation stochastic approximation towards signal timing optimization

Simultaneous Perturbation Stochastic Approximation (SPSA) has gained favor as an efficient optimization method for calibrating computationally intensive, “black box” traffic flow simulations. Few recent studies have investigated the efficiency of SPSA for traffic signal timing optimization. It is important for this to be investigated, because significant room for improvement exists in the area of signal optimization. Some signal timing methods and products perform optimization very quickly, but deliver mediocre solutions. Other methods and products deliver high-quality solutions, but at a very slow rate. When using commercialized desktop signal timing products, engineers are often forced to choose between speed and solution quality. Real-time adaptive control products, which must optimize timings within seconds on a cycle-by-cycle basis, have limited time to reach a high-quality solution. The existing literature indicates that SPSA provides the potential for upgrading both off-line and on-line solutions alike, by delivering high-quality solutions within seconds. This article describes an extensive set of optimization tests involving SPSA and genetic algorithms (GAs). The final results suggest that GA was slightly more efficient than SPSA. Moreover, the results suggest today's signal timing solutions could be improved significantly by incorporating GA, SPSA, and “playbooks” of preoptimized starting points. However, it may take another 5–10 years before our computers become fast enough to simultaneously optimize coordination settings (i.e., cycle length, phasing sequence, and offsets) at numerous intersections, using the most powerful heuristic methods, at speeds that are compatible with real-time adaptive solutions.     

Exhaust nanoparticle emissions from internal combustion engines: A review

This paper reviews the particle emissions formed during the combustion process in spark ignition and diesel engine. Proposed legislation in Europe and California will impose a particle number requirement for GDI (gasoline direct injection) vehicles and will introduce the Euro 6 and LEV-III emission standards. More careful optimization for reducing particulate emission on engine hardware, fuel system, and control strategy to reduce particulate emissions will be required during cold start and warm-up phases. Because The diesel combustion inherently produces significant amounts of PM as a result of incomplete combustion around individual fuel droplets in the combustion zone, much attention has been paid to reducing particle emissions through electronic engine control, high pressure injection systems, combustion chamber design, and exhaust after-treatment technologies. In this paper, recent research and development trends to reduce the particle emissions from internal combustion engines are summarized, with a focus on PMP activity in EU, CARB and SAE papers and including both state-of-the-art light-duty vehicles and heavy-duty engines.