交流电力功率智能传感器粗信号处理

为提高交流电力功率性能指标的测试精度和实时性,基于相关性分析和最小二乘误差理论,研究了交流电力智能传感器的粗信号处理方法.采用最小二乘特征参数法,对交流电压和电流值的初始采样点进行估算,获得了电力功率参数.在此基础上,将最小二乘特征参数法与相关分析法进行了比较,给出了基于相关分析法和最小二乘特征参数法进行功率测试的运算量公式,并分析了运算的复杂度.实验结果表明,当干扰幅值从信号幅值的3%放宽至12%时,基于最小二乘特征参数法的粗信号处理方法与现有方法相比,其计算工作量可减少49.4%,测试误差减少了2/3,同时降低了系统的信/噪比要求.     

Time-variant ultimate longitudinal strength of corroded bulk carriers

Many bulk carrier losses have been reported of late, and one of the possible causes of such casualties is thought to be the structural failure of aging hulls in rough weather. In aging ships, corrosion and fatigue cracks are the two most important factors affecting structural safety and integrity. This paper uses a set of the time-dependent corrosion wastage models for 23 different member locations/categories of bulk carriers previously developed by the authors, based on the available corrosion measurements for existing large bulk carrier structures. Differences due to the location and corrosion severity of every member type are taken into account. The nominal design corrosion values for the primary members are suggested based on the annualized corrosion rates obtained in the present study. The effect of time-variant corrosion wastage on the ultimate hull girder strength as well as the section moduli is studied. The criteria for repair and maintenance of heavily corroded structural members so as to keep the ultimate longitudinal strength at an acceptable level are discussed. Important insights and conclusions developed are summarized.     

Estimation of road profile variability from measured vehicle responses

When assessing the statistical variability of fatigue loads acting throughout the life of a vehicle, the question of the variability of road roughness naturally arises, as both quantities are strongly related. For car manufacturers, gathering information on the environment in which vehicles evolve is a long and costly but necessary process to adapt their products to durability requirements. In the present paper, a data processing algorithm is proposed in order to estimate the road profiles covered by a given vehicle, from the dynamic responses measured on this vehicle. The algorithm based on Kalman filtering theory aims at solving a so-called inverse problem, in a stochastic framework. It is validated using experimental data obtained from simulations and real measurements. The proposed method is subsequently applied to extract valuable statistical information on road roughness from an existing load characterisation campaign carried out by Renault within one of its markets.     

不同雷诺数下车辆队列尾车发动机舱盖气动特性研究

数值仿真与模型风洞试验相结合研究了典型工况下两车队列中尾车发动机舱盖气动特性和两车间隔区域的流场,对比了缩比模型和实车模型对应雷诺数下车辆队列的流动形态。缩比模型仿真结果与风洞试验结果一致表明采用数值方法的可行。对比不同雷诺数下车辆队列气动特性发现,缩比模型与实车模型发动机舱盖表面平均静压分布基本相同,但在纵向对称面上,实车模型的前车尾迹比缩比模型更加上扬,底部区域气流速度更高。非定常条件下,实车模型前车尾涡相对尺度明显小于缩比模型,且扩散得更充分,尾迹区涡的分布状态更加混沌,发动机舱盖表面脉动能量的分布更加混乱。涡在两车间隔区域的运动并非简单的移动,而是一个由涡破裂、涡配对和涡融合构成的复杂过程。     

The impact of job assignment rules for straddle carriers on the throughput of container terminals

Straddle carriers represent a critical resource in the handling of containers within a container terminal. It is essential that they are deployed in an as efficient manner as possible. The research presented in this paper is motivated by the need to critically evaluate job assignment rules for straddle carriers that operate in a multiple straddle environment. This is achieved by developing a discrete event simulation model using industrial simulation software to model a container terminal located in Melbourne, Australia. The model accounts for variables such as the number of straddle carriers needed, the speed of straddle carriers, the arrival rate of trucks, and the job assignment rule. A principal finding of the study is that increasing the number of straddles in the present set‐up from 6 to 7 has a negligible effect on daily throughput. However, an increase in the number of straddles to 7 is expected to have a profound effect on reducing the average waiting time of trucks within the terminal from over 16 minutes to under 9 minutes, a decrease of 46.5%. However, a further increase in the number of straddles results in no further increase in daily throughput. It was observed that the throughput of the terminal is very sensitive to the speeds at which straddles travel. The management of the terminal has proposed a new heuristic job assignment rule for straddles, because the present rule does not assign the jobs to straddles closest to the truck requesting to load or unload a container. As a result a new heuristic job assignment rule was tested. The simulation results revealed that both the old and new rules performed equally well using performance indicators such as average container flow time, daily throughput, average waiting time of jobs, number of jobs in the queue, and straddle utilisation. Therefore, the new rule will not improve these performance measures if implemented     

基于卡尔曼滤波算法的电机转速精确估计

从无刷直流电机入手建立数学模型，利用卡尔曼Kalman（EKF）滤波原理算法，对无刷直流电机的转速进行精确估计，然后在Matlab环境下仿真，验证卡尔曼滤波算法对电机转速估计的精确性。     

Container terminals in South Korea: problems and panaceas

Korea has achieved remarkable economic growth over the last three decades. This has largely been due to the adoption of export-oriented economic policies. This economic development has resulted in a rapid increase in export and import cargos. Since the foreign trade of Korea is carried predominantly by sea transport (approximately 99.8% in terms of volume), ports play a crucial role in this process. Although recent port developments are aimed at keeping pace with ever-growing seaborne cargoes, problems persist, especially insufficient port capacity and inefficient management and operations. As a consequence, the ports of Korea suffer from serious port congestion. This problem is particularly acute in Pusan, the fifth largest container port in the world. In the past, all ports in Korea were controlled and administered by the Korea Maritime and Port Administration which was a public port authority. In August 1996, the Korean government established a new government organization, the Ministry of Maritime Affairs and Fisheries (MMAF), with a remit to control and manage its seaports and other related activities and to improve management efficiency in the maritime area. As a way of solving problems related to port congestion and other sources of inefficiency, the new MMAF has launched several new port development schemes. In this context, this paper will discuss (1) the extent of congestion in Korean ports, especially Pusan, the major seaport of the country; and (2) governmental and commercial reaction to solving the problems, including measures such as new port development schemes aimed at attracting private and foreign finance. From this analysis, a strategy for port development in developing countries may be inferred.     

冷再生试验段铺筑及施工工艺浅析

通过对永峰线峰峰段冷再生试验路段的旧路结构调查、分析，经过现场铺筑试验段，检验室内试验的结论，对室内试验的结论进行修正和补充。并对冷再生施工工艺在施工中应如何操作、应注意的问题等进行了探讨。     

皮卡:回顾2002,展望2003

2002年是我国皮卡增长的又一个高峰期,激烈的竞争促进了皮卡行业整体的发展,也促使皮卡新品层出,产品呈现多元化。2003年将是皮卡的巩固阶段,皮卡国内外市场将会稳定增长,竞争层面将会拉开,各有侧重。继2002年低价位SUV畅销后,2003年皮卡向多功能商务车升级将是一个热点,另外在竞争方面将更多地打服务牌。     

软开关变流器的稳态分析(一)

讨论软开关变流器的稳态分析.由于分别由软开关变流器的Lr-Cr单元和大的L-C滤波器单元决定的快、慢固有频率的共存,通过启动瞬态仿真程序寻找软开关变流器的稳态解可能会造成繁琐的计算和收敛失败.由于采用了基于暂态分析的换相检测技术和基于补偿原理的换相分析技术,文章所提出的数值法显示了高可靠性和快速收敛性.对两个直流变换器、一台逆变器和一台功率因数补偿装置作的稳态分析,突出显示了仿真算法的良好性能.