主动铰接盾构在连续小半径曲线中风化泥岩的掘进控制技术

武汉市轨道交通11号线东段工程光谷四路站—光谷五路站区间为"S"型连续曲线,最小平曲线半径为350 m,采用盾构法施工。通过对主动铰接盾构机掘进控制的难点分析,从土压力、千斤顶推力、千斤顶行程差、水平铰接角度和前盾水平趋向等方面采取有针对性的技术控制措施,使成型隧道轴线、管片错台控制在规范允许范围之内,成功解决了连续小半径曲线隧道盾构施工轴线难以控制、管片容易错台等大问题。     

Simulation of mixed gas formation for a spray-wall complex guided LPG direct injection engine

To obtain an ultralean air-fuel ratio and to reduce engine-out NOX and HC emissions induced by the richer mixture near the spark plug, a spray and wall complex guided combustion system has been developed by utilizing the fuel characteristics of LPG. The new combustion system configuration is optimized by using a commercial CFD code, FIRE V2013, and the reliability of the system has been experimentally demonstrated by Plane Laser-Induced Fluorescence (PLIF). The mixture formation in the new combustion system under part load (2,000 rpm) is numerically simulated. With an injection timing of 40°CA BTDC, the LPG spray which is injected from two upper holes, reaches the ignition point, and the other part of the LPG spray which is injected from the bottom hole, is directed to the ignition point through the vertical vortices at the same time. At the ignition timing of about 20°CA BTDC, the two-part mixtures have been shown to form a stable and richer stratified mixture around the ignition point, and the maximum global air-fuel ratio reaches to 60: 1.     

某深基坑开挖数值模拟与实测对比分析

通过FLAC3D对现场工况进行了开挖模拟,与实测结果进行了对比分析。围护结构型式采用单排桩+锚索和双排桩,开挖到坑底时,计算的桩身水平位移最大值分别为8.73 mm和10.19 mm,实测值分别为10.57 mm和12.05 mm,实测值稍大于计算值,桩身整体侧向变形规律一致。围护结构型式采用单排桩+锚索,不同开挖阶段坑外地表沉降的计算值与实测值对比,整体沉降均随着开挖深度增加而增大;沿基坑方向的分布规律也大致相同,都是呈凹槽型分布,最大沉降值出现在距桩后3~4 m范围内。     

废弃泥浆在盾构壁后注浆中的应用

在泥水盾构施工过程中不可避免地会产生大量的废弃泥浆,处理泥浆一是需要较高的资金投入,二是可能会对环境造成严重污染。利用废弃泥浆配制壁后注浆砂浆,利用盾构弃浆代替砂浆中的膨润土和水,研究弃浆对壁后注浆砂浆工程性能的影响。结果表明:1)相对体积质量为1.16、黏度为22 s的泥浆配制壁后注浆材料可得到较好的流动性和稠度,并且泌水率优于原配比;2)相对体积质量为1.27、黏度为24 s的泥浆会明显降低砂浆的流动度,对砂浆可泵送能力有一定的影响;3)适当调整水胶比和泥浆相对体积质量,配制壁后注浆材料各方面性能均能达到壁后注浆材料的要求;4)废弃泥浆配制砂浆是一种既经济又环保的弃浆处理回收再利用的工艺工法。     

使用聚合物对纯砂层进行渣土改良的试验研究

土压平衡盾构在不同的地层进行渣土改良的关键是选择合适的改良剂,纯砂层施工中最常用的改良剂就是膨润土泥浆,目前已开始尝试使用聚合物进行改良。本文选取3种典型的聚合物,研究聚合物溶液特性与聚合物浓度、搅拌时间和静置时间的关系,并选择合适的聚合物对粗砂试样进行塌落度试验、渗透试验和直剪试验的室内试验研究。研究结果表明,针对粗砂地层(含水率10%左右),0.3%的PAM聚合物溶液注入率为20%~25%时,能有效增强粗砂的流动性和黏聚性,降低渗透系数和摩擦因数,满足土压平衡盾构施工要求。     

CCS水电站引水隧洞双护盾TBM施工围岩分类研究

为了对双护盾TBM隧洞施工中的围岩进行分类,以厄瓜多尔CCS水电站引水隧洞为例,参考RMR围岩分类方法,通过伸缩护盾的间隙和刀盘的空隙对洞壁和掌子面围岩进行观测,结合岩渣及掘进参数,获取岩石的质量指标RQD、节理间距和节理性状等信息。通过综合分析,选取岩石的回弹值、围岩的完整性、岩石的质量指标RQD、刀盘推力、刀盘扭矩、片状岩渣含量和地下水渗流量作为围岩分类的指标,然后对7个指标分别赋值,建立围岩的分类标准,并通过求和的方法进行综合围岩分类。分类结果表明:选取的7个指标可以克服双护盾TBM施工时无法对围岩进行全面地质素描的困难,可以满足TBM快速施工的需要,并且能较真实地反映围岩的情况,分类结果可靠。     

薄基岩顶板隧道爆破施工围岩稳定性分析

为更有效地进行薄基岩顶板条件下隧道施工安全控制,以某高速公路隧道为工程背景,运用数值模拟的方法,分别研究不同顶板厚度下隧道爆破施工引起的围岩振速分布特征及其对围岩的损伤情况,并进行围岩稳定性分析。结果表明:1)当顶板厚度在5 m及以上时,围岩是稳定的;2)当顶板厚度为3 m时,最危险横断面上基岩顶板内开始产生严重的拉伸裂缝及一些径向裂缝,将形成超挖;3)当顶板厚度≤2 m时,径向裂缝贯穿顶板岩体,围岩稳定性较差,在掌子面后1 m内可能发生塌落、掉块等事故。     

基于地基回弹因素的盾构隧道管片上浮预测

针对软弱地层盾构隧道管片脱出盾尾后出现的上浮问题,分析盾构施工过程中管片上浮的诱因,得出软弱地层中管片的上浮主要是地层应力重分布产生的地基回弹力引起的。在此基础上建立隧道开挖动态模型,分析隧道上浮量变化规律以及地层特性对管片上浮量的影响规律,得出地层弹性模量和管片上浮量呈一定的指数关系,且弹性模量对管片上浮量的影响远大于地层黏聚力和内摩擦角。通过力平衡理论计算盾构开挖引起的地层回弹力、管片上浮量以及隧道上浮影响的地层高度范围,并通过对珠江狮子洋工程管片上浮量的计算与实测对比,证明该公式的合理性,为盾构隧道工程中考虑地基抗力引起的管片上浮量预测提供一种新的方法。     

拱架式预切槽施工机械在黄土隧道施工中的应用

隧道预切槽施工技术在国外应用比较广泛,但在我国应用还较少。针对黄土地质专项研制了国内首台拱架式预切槽机,并在黄土隧道进行了施工试验。通过施工试验,掌握设备定位、分区切灌、设备行走、施工作业组织等关键技术,并提出应用改进及优化措施。试验结果表明切槽系统工作状态和设备切削、喷灌功能满足设计及施工试验要求,为预切槽同步切削喷灌一体化研究提供了数据支撑和研究方向。     

A new model for temporal–spatial stochastic analysis of vehicle–track coupled systems

The vehicle–track coupled system has a random nature in the time–space domain. This paper proposes a computational model to analyse the temporal–spatial stochastic vibrations of vehicle–track systems, where the vehicle–track system is divided into a vehicle subsystem, track subsystem, and interfacial subsystem between the wheel and rail. In this model, the time-varying randomicity of dynamical parameters of the vehicle system, correlation, and randomness of the track structural parameters in the time–space joint dimensions, and randomness of the track random irregularities are considered. A probability dimension-reduction method was used to randomly combine different random variables. Furthermore, the probability density evolution method was applied to solve the delivery problem of probabilities between excitation inputs and response outputs. The temporal–spatial stochastic vibrations of the vehicle–track system with different coefficients of variation were studied, in which we assumed that the dynamic parameters obeyed the normal distribution, and the stochastic simulation method of the track random irregularities is probed into. The calculated results from this model are consistent with the actual measured results and physical conceptions. Thus, the temporal–spatial stochastic evolutionary mechanism can be explored, and the limits of dynamic indices can be formulated by using this developed model.