09-3X捣固装置振动轴轴承故障分析

结合09-3X捣固装置振动轴轴承的2起故障,通过对振动轴总成的结构及其作业、维修等特点进行分析,探讨故障产生的的原因,提出防范措施,以期减少或避免类似故障的发生。     

IGBT逆变器供电的电力机车转向架轴承失效分析

对由IGBT变流元件构成的交流传动逆变器供电的电力机车转向架的驱动装置轴承和轴箱轴承的电流通路进行探索、分析,特别对Electric Discharge Machining(EDM)电流进行了分析,提出了判断轴承电蚀失效的依据及相应的解决措施。     

HX_D3型机车牵引电机故障的预防探讨

通过对HXD3机车牵引电机窜轴、轴承固着等故障的分析研究以及机车电机与齿轮箱结构、电路控制等的分析,提出如何在大整备格局的生产布局下提前发现和预防该故障的机理、思想和方法,最大程度地降低其对生产运输的影响。     

汽车空调维护要点

汽车空调系统一般应注意以下维护要点：压缩机：压缩机的安装支架不得松动。传动皮带松紧度要适宜，过松会引起打滑，造成压缩机转速下降，制冷量不足；过紧又加剧皮带磨损以及造成曲轴轴承过早损伤。压缩机冷冻机油油面高度应在规定范围内，在正静情况下冷冻机油消耗量极少，如果从压缩机的视油镜片中看不到冷冻机油，则说明冷气系统中存在泄漏现象，应及时维修。     

船用柴油机增压系统常见故障分析

分析了船用柴油机增压系统的常见故障及原因,并提出了相应的解决办法。     

THE EDDY LOSSES OF A MAGNETIC THRUST BEARING

Accurate calculations of losses associated with the operation of magnetic bearings are particularly important for high speed applications where the rotor losses are expected to be large and for some particular applications where even low power losses will be critical. Power losses in the magnetic thrust bearing is often neglected, but if there is misaligned in the rotor and bearing, the magnetic field in the thrust bearing is no longer axisymmetric one, or the dynamic control current in the winding is time dependent one, eddy currents are caused to flow inside the conducting material, then the power losses are very important for magnetic bearing design. This paper presents an analytical model of a thrust magnetic bearing, and the magnetic fields, forces and losses of thrust magnetic bearing are calculated. In the calculations the frequency of dynamic control current is up to 1 000 Hz, rotating speed is from 60 rpm to 1 200 rpm, and the non-linearity of material is also taken into consideration. The results shows that if the magnetic field is not saturation, the eddy losses is proportional to dynamic control current frequency and a square function of dynamic control current, and also 5/2 power function of shafts speed.     

300TEU船艉轴承液压安装技术

本文对大直径、小过盈、薄壁套筒工件的过盈装配问题进行了探讨,应用液压技术成功地解决了300TEU船的艉轴承安装问题,并将该安装技术与以往的传统安装方法进行了比较.     

逆变器驱动电机系统中共模耦合电流的研究

在电机驱动系统中，共模电压将会在电机内部的共模耦合回路中产生共模耦合电流，共模耦合电流将对系统构成共模干扰，并影响电机的使用寿命，因此对共模耦合电流的研究显得非常重要．文中分析了三相逆变器驱动电机系统中的共模激励源，发现共模响应只与系统的零序阻抗和共模阻抗有关，可以用等效的集总参数模型来模拟系统的共模耦合．在对电机内部的共模回路进行分析计算的基础上，得出了地电流及电机轴承电流的集总参数电路模型和参数确定方法，仿真和实验结果显示，该模型能对逆变器驱动电机系统中的地电流和轴承电流进行有效的预测。