高强钢筋混凝土非线性力学模型研究

针对高强钢筋混凝土非线性分析，对非线性分析中裂缝的模拟、钢筋混凝土材料本构关系及其非线性问题求解方法的改进进行研究，提出了适用于高强混凝土的本构曲线，并将混合法用于非线性问题，为高强钢筋混凝土梁非线性分析提供了理论基础。     

支持协同设计的船舶设计过程模型研究

船舶设计过程模型是在网络环境下开展船舶并行和协同设计系统的基础.本文根据船舶设计的特点,提出了将船舶设计过程按照项目、设计任务和设计活动三个层次进行分解的方法,并给出了船舶设计过程模型形式化定义.该模型明确了设计任务间的并行、顺序和协同关系,可以直接按设计任务构成活动网络图进行规划、分析、管理等工作,使设计过程具有良好的可变更性和可控性.     

用高温超导线圈和常导线圈构成的混合式电磁悬浮系统

常导电磁吸力悬浮系统悬浮气隙小、悬浮功率大,电动斥力悬浮系统不能实现静止悬浮、磁场污染大。由于受电流变化率限制,单独采用高温超导线圈构成的电磁吸力悬浮系统不能实现稳定悬浮。经分析比较,提出了一种用高温超导线圈和常导线圈构成的混合式电磁吸力型悬浮系统方案。采用这种混合式悬浮方案可增大悬浮气隙、实现稳态"零"功率悬浮、减轻车体重量、降低制冷费用、且无磁场污染。     

京秦线提速路涵过渡段动力仿真与试验对比

结合京秦线提速改造工程进行了列车 路基动力仿真计算。在不同速度条件下,通过对路涵过渡段加固前后状态下机车车辆运行安全舒适性指标、轨道及路基主要动力性能指标的分析计算,对京秦既有线路涵过渡段提速到200km/h的适应性及加固方案的可行性提出了相应评价意见与建议,并与随后的实车试验进行了对比。试验测试结果验证了仿真分析的可靠性。     

车体材质对城轨车辆运行阻力的影响

介绍了铝合金、不锈钢和耐候钢等三种车体材质对车体质量及城轨车辆运行阻力的影响。     

Experimental ivnestigation on flow fields of viscous fluid around two-dimensional wings and comparison with computational results

To examine the flow field of a viscous fluid around the trailing edge of a wing with respect to the Kutta condition or the Joukowski hypothesis, an experimental investigation into the velocity fields around two-dimensional (2D) wings NACA0012 and NACA4412 was carried out using an X-type hot-wire anemometer in a wind tunnel and the method of colored milk injection in a circulating water channel. The results of these investigations revealed that the flow of a viscous fluid at the trailing edge of a 2D wing is tangential to the face on the pressure side, and that the flow is very slow or reversed on the suction side due to separation when the angle of attack is greater than 7.5°. By flow visualization, a Kármán vortex street was found in the wake of both wings (NACA0012 and NACA4412) when the angle of attack was 5°. These results show that the ordinary Kutta condition with respect to the direction of outflow at the trailing edge is not necessarily satisfied in a viscous fluid, but the Kutta condition with respect to the pressure at the trailing edge is satisfied as usual. Numerical results, which have been obtained as the solution of Reynolds-averaged Navier-Stokes equations, show good agreement with above-mentioned experimental results. Therefore, CFD (Computational Fluid Dynamics) simulation has proved to be very effective for studying steady viscous flow around the trailing edge of a 2D wing.     

编组站驼峰车辆溜放速度控制系统的研究

以计算机和红外线传感器为主，研制了编组站驼峰车组溜放速度控制系统，系统通过检测车辆溜放的速度，计算出所需制动力的大小，通过缓器对车辆溜放进行速度控制，并具有对解体车辆自动计数，各种故障报警等功能。     

使用构件和零件的实际疲劳特性进行车辆疲劳寿命预测

疲劳寿命计算是机械设计的重要步骤,而利用标称应力和可比构件或零件的实际疲劳特性这一疲劳分析方法是疲劳寿命计算的有效方法。本文详细地阐述其计算原理和具体步骤,并将此疲劳分析方法应用于货车车辆实际的疲劳计算中,验证了该方法具有很好的应用价值。     

Impacts of motor vehicle operation on water quality in the US – Cleanup costs and policies

This paper investigates the costs of controlling some of the environmental impacts of motor vehicle transportation on groundwater and on surface waters. We estimate that annualized costs of cleaning-up leaking underground storage tanks range from $0.8 billion to $2.1 billion per year over 10 years. Annualized costs of controlling highway runoff from principal arterials in the US are much larger: they range from $2.9 billion to $15.6 billion per year over 20 years (1.6–8.3% of annualized highway transportation expenditures). Some causes of non-point source pollution were unintentionally created by regulations or could be addressed by simple design changes of motor vehicles. A review of applicable measures suggests that effective policies should combine economic incentives, information campaigns, and enforcement, coupled with preventive environmental measures. In general, preventing water pollution from motor vehicles would be much cheaper than cleaning it up.     

成昆线红层地区泥石流沟侵蚀程度量化分析

以成昆铁路红层地区的3个小流域为研究区,计算3个年份的地面割裂度及其年平均变化率,分析用地面割裂度表征泥石流沟侵蚀程度的不足及其原因。基于泥石流沟发育的物理模型,以原来的地面割裂度定义为基础,引入表述沟谷分布零散程度的异型度因子,导出新侵蚀系数公式。以3个小流域固体物质的年平均流失量作为侵蚀程度强弱的标准,采用非参数统计推断方法,将侵蚀系数、地面割裂度的年变化值和固体物质的年平均流失量作秩统计和次序统计。对秩统计参数和次序统计参数比较结果表明:在表征泥石流沟侵蚀程度方面,侵蚀系数优于地面割裂度。