牙周炎患者红细胞免疫功能及发病机理研究

采用酵母菌花环试验对31例牙周炎患者红细胞免疫粘附功能、循环免疫复合物、补体C_3含量进行了检测,并与正常组进行了比较。结果显示:牙周炎患者红细胞膜免疫复合物及循环免疫复合物均升高,补体C_3含量降低,且皆与正常组有显著性差异。作者认为:免疫复合物在牙周炎发病机理中有一定的意义,牙周炎患者红细胞免疫对清除循环免疫复合物起着重要作用。     

Experimental ivnestigation on flow fields of viscous fluid around two-dimensional wings and comparison with computational results

To examine the flow field of a viscous fluid around the trailing edge of a wing with respect to the Kutta condition or the Joukowski hypothesis, an experimental investigation into the velocity fields around two-dimensional (2D) wings NACA0012 and NACA4412 was carried out using an X-type hot-wire anemometer in a wind tunnel and the method of colored milk injection in a circulating water channel. The results of these investigations revealed that the flow of a viscous fluid at the trailing edge of a 2D wing is tangential to the face on the pressure side, and that the flow is very slow or reversed on the suction side due to separation when the angle of attack is greater than 7.5°. By flow visualization, a Kármán vortex street was found in the wake of both wings (NACA0012 and NACA4412) when the angle of attack was 5°. These results show that the ordinary Kutta condition with respect to the direction of outflow at the trailing edge is not necessarily satisfied in a viscous fluid, but the Kutta condition with respect to the pressure at the trailing edge is satisfied as usual. Numerical results, which have been obtained as the solution of Reynolds-averaged Navier-Stokes equations, show good agreement with above-mentioned experimental results. Therefore, CFD (Computational Fluid Dynamics) simulation has proved to be very effective for studying steady viscous flow around the trailing edge of a 2D wing.     

模拟异种钢接头蠕变力学特性的数值分析

利用有限元数值模拟了高强匹配异种的接头在弹性－蠕变条件下的应力／应变场，结果表明，接头的应力／应变分布不均匀，在焊缝界面上，应力和应变分别呈不连续和不协调分布特性，并随着拦头各区蠕变强度差别的增大，其分布梯度增大，峰值应力／应变提高，因此，蠕变强度梯度大的高强焊缝和低强母材的界面是接头的薄弱部位。     

Dynamic Simulation of a Smart Crank and Slider Mechanism

In this paper, a smart crank and slider mechanism is analyzed mostly from a dynamic view. By means of dynamic explicit finite element method, 3D nonlinear structure is simulated. It is proved that the mechanism can effectively accomplish smart movement prescribed. And in order to ensure reciprocal movement with higher frequency, measures should be taken to avoid over heating of parts. Compared with internal energy, kinetic energy of total rigid body is dominating, and Y direction equivalent rigid velocity is much higher than X direction velocity. Equivalent rigid velocity of all parts is consistent with respective movement condition. For both energy and velocity, slider effect is dominating. Three direction equivalent inertia force oscillates. Force amplitude in Y -direction is comparitively the greatest.     

应用复合梁单元实现钢管混凝土拱桥的极限承载力分析

进行大跨度钢管混凝土拱桥的极限承载力分析,需要综合考虑几何和材料非线性、混凝土收缩和徐变、温度变化等多种因素的影响。本文从固体力学的基本理论出发,建立适于考虑上述诸多因素的复合梁单元,阐述了基于该单元的钢管混疑土拱桥极限承载力分析程序的实现方法,并通过与一个哑铃形截面钢管混凝土组合式拱肋极限承载力试验结果的对比验证了其可行性。     

装配式公路钢桥承载力的有限元分析

指出装配式公路钢桥设计中所采用的简化计算方法的不足,使用大型有限元软件ANSYS对其受力情况和承载力进行了分析,并与简化计算方法作了对比,得出了一些规律性的结论,对实际应用具有指导意义。     

有限元和条分结合法计算边坡静力稳定性探讨

对于边坡稳定性计算通常采用不平衡推力法（如瑞典圆弧法和Bisho法等）和有限元计算方法，两者在计算本质上没有区别，但在计算过程中都存在不足。不平衡推力法在稳定性计算时要对潜在的滑面进行假设搜索，相对计算工作量较大，然而采用有限元分析的方法，在计算过程中往往由于判断收敛标准的不同，会出现不同的稳定性计算结果。文章利用两者的优点进行结合，分析计算得到边坡在静力条件下的稳定性。     

桩架改造设计方案的有限元分析

为了满足深水码头建设的需要,"航工桩二号"必须进行加高改造。本文利用大型有限元软件ANSYS对改造前桩架模型的结构强度进行了校核分析,确立了合理的加固改造方案。最后结合实际工程,通过对改造后桩架在不同的荷载工况条件下,对其强度进行了综合分析研究,验证了改造方案的可行性及合理性。     

基于光流法的舰船运动要素测定原理研究

对基于光流法的舰船运动要素测定原理进行了研究，主要包括光流法测定舰船运动要素的思想、光流场解算、三维运动参数解算和舰船运动要素解算。该方法的提出，提高了运动要素测定的自主性，而且满足新型全封闭舰船的测定要求。     

内河航道齿坎式护岸结构分析及应用

齿坎式护岸结构是一种新型挡墙结构,但目前齿坎式挡墙缺乏理论设计规范。在进行抗滑稳定性计算时仍按照无齿坎结构进行计算,把齿坎当成安全储备,造成断面设计的浪费。通过对齿坎式护岸结构的有限元计算,得出比较经济的护岸断面结构型式。