A model for prediction of the transient rolling resistance of tyres based on inner-liner temperatures

Measurements of rolling resistance in thermal equilibrium of a tyre, like measurements according to ISO 28580, do not allow statements about rolling resistances under other driving conditions. Such statements, however, are necessary to determine the energy consumption in driving cycles. Especially for the proper calculation of electric-vehicle remaining ranges and the selection of the respective driving strategies, the real amount of energy consumption is required. This paper presents a model approach, which by means of only one standardised rolling resistance measurement can be parameterised and, considering the present driving speed and tyre temperature, can predict the respective current rolling resistance.     

第三轨供电系统中受流器与第三轨的接触压力及其对受流性能的影响分析

介绍了第三轨受流器的结构原理。分析比较了弹簧式和气压式受流器与第三轨接触压力调节方式的特点。基于电接触基本理论详细的阐述了受流滑板与第三轨接触区的导电机理。接触区域的导电电路由无数微小的电阻及电容并联而成,接触压力通过影响微小电阻、电容的数量比例,进而影响接触面上的导电能力和磨损性能。标称静态接触压力的设计值接近或等于法向压应力临界值时,导电能力和磨损特性取得均衡。     

带缺陷隧道底板结构空气耦合冲击回波响应特性研究

针对隧道底板中空腔、含水、裂缝等结构内部损伤情况,为提高传统接触式冲击回波方法的检测效率,从气-固耦合的角度出发,以空气作为底板结构与检测系统之间应力波传播的耦合介质,开展隧道底板结构内部缺陷的空气耦合冲击回波响应特性研究。研究结果表明： 1）采用空气耦合冲击回波的方法确定的底板结构内部缺陷深度与缺陷理论深度值基本吻合; 2）检测系统的精度与缺陷尺寸及深度有关,随着缺陷尺寸的减小及深度增加,检测精度逐渐降低; 3）空气耦合冲击回波方法对空腔和含水缺陷的检测效果优于裂缝缺陷检测效果。     

TLA/SBR复合改性沥青性能试验研究

为了改善特立尼达湖沥青(简称TLA)改性沥青低温抗裂性,提出用丁苯橡胶(SBR)对其改性,期望综合两种改性剂的优点。对不同掺量的TLA与SBR复合改性沥青进行了常规试验(针入度、软化点、延度、旋转粘度)、DSR试验、BBR试验,并测试了短期老化与长期老化后的残留针入度比,研究TLA与SBR掺量对高、低温性以及抗老化性能的影响。研究结果表明:①掺入SBR与TLA均能改善沥青的高温抗变形能力和感温性,对比TLA,SBR对沥青高温性能的改善效果更显著;②TLA对复合改性沥青的低温性能有不利影响,但掺入SBR可以抵消这种不利影响;③掺加5%~20%的TLA能改善复合改性沥青的抗老化性能,在此TLA掺量下,SBR也能改善沥青的抗老化性能。④综合高、低温性能和老化性能的表现,最佳掺量为20%的TLA+3%的SBR。     

Equivalent design pressure for ship plates subjected to moving slamming impact loads

When a ship navigates at sea, the slamming impact can generate significant load pulses which move up along the hull plating. The effect of the moving pressure has so far not been explicitly considered in the Rules and Regulations for the Classification of Ships. Based on a modal superposition method and the Lagrange equation, this paper derives analytical solutions to study the elastic dynamic responses of fully clamped rectangular plates under moving pressure impact loads. The spatial variation of the moving slamming impact pressure is simplified to three types of impact loads, i.e. a rectangular pulse, a linearly decaying pulse and an exponentially decaying pulse. The dynamic responses of fully clamped rectangular plates under the moving slamming impact pressure are calculated in order to investigate the influence of the load pulse shapes and moving speed on the plate structural behaviour. It is found that the structural response of the plate increases with the increase of the moving speed. The response of the plate subjected to a moving pressure impact load is smaller than the case when the plate is subjected to a spatially uniform distributed impact load with the same load amplitude and load duration. In order to quantify the effect of the moving speed on the dynamic load, a Dynamic Moving Load Coefficient (DMLC) is introduced as the ratio between the dynamic load factor for the moving impact load and that under the spatially uniform distributed impact load. An expression for DMLC is proposed based on analyses of various scenarios using the developed analytical model. Finally an empirical formula which transforms the moving impact loads to an equivalent static load is proposed.     

深海耐压舱室寿命估算

耐压舱室在深海中下潜一定深度和收回过程中,受到的水压可以简化为底周期循环应力。在该循环应力作用下,根据断裂力学理论和结构损伤-安全设计原理,以临界裂纹尺寸的设计方法结合具体工程应用案例计算设备寿命,得出在一定初始裂纹深度和长度下设备的理论使用次数。采用计算机程序实现迭代计算。此应用案例在疲劳的可靠性计算中具有一定的工程指导意义。     

燃气调压器声发射信号特征与流量关系分析

文中提取燃气调压器声发射信号的标准差、峭度这两个时域特征及重心频率、均方根频率这两个频域特征,分析特征与流量的对应关系,使用相关系数进行评价。基于北京某调压站采集的声发射信号及流量数据,实验结果表明,流量与标准差、峭度、重心频率、均方根频率的相关系数分别为0.8192、0.2889、0.7745、0.641。可见标准差、重心频率及均方根频率与流量相关性较强,峭度与流量相关性较弱。     

内压载荷下X80管道裂纹应力分布规律研究

为了研究内压作用下管道裂纹应力场分布规律,以含有表面裂纹的X80管道为研究对象,对不同形状、不同方向、不同内压、不同尺寸的含裂纹管道进行仿真分析和实验验证。结果表明:裂纹尖端处应力远大于裂纹中心应力。裂纹形状对应力影响作用较小,随着裂纹方向与管道轴向夹角增大,裂纹尖端应力先增大后减小,随着管道内压、裂纹深度、裂纹长度的增大,裂纹尖端处应力随之线性增大。其中,裂纹长度对裂纹尖端应力的影响小于管道内压和裂纹深度。     

地下工程注浆技术研究新进展

注浆是土木、水利和矿山等工程建设中重要的防渗和加固技术。文章基于国内外注浆技术研究文献,总结了水泥等颗粒性浆液的“渗滤效应”及“黏度时空变异性”等理论研究成果,论述了非水反应高聚物、CW环氧树脂和微生物菌液等注浆新材料的应用现状及发展前景,介绍了细观力学数值模拟研究的突破性进展,可为地下工程注浆技术发展提供借鉴和启发作用。     

隧道口减光设施对照明的影响研究

近年来,伴随着我国基础设施建设的不断推进,隧道里程不断增多,隧道照明系统的重要性日益突出,因此对隧道洞口驾驶员视觉特性、减光设施的特点及减光效果进行研究,具有重要的意义。本文通过对隧道洞口驾驶员的视觉特性进行研究,分别论述各种洞口减光设施的特点,并以南京扬子江路隧道、富贵山隧道、双龙街立交隧道的检测数据为基础,计算减光设施对洞口亮度的影响,以及隧道内加强照明的亮度需求的降低程度,进一步分析得出采用减光设施对照明设施建设的投资影响以及可节约的照明养护成本等。