钢管拱吊装阶段中温度的影响分析

就缆索吊装钢管拱的施工方法，以工程实例讨论钢管拱在吊装阶段中温度对安装精度和应力测试结果的影响。     

用示波器对柴油机喷油系统进行故障检测与诊断

阐述利用示波器对柴油发动机喷油系统压力波形进行检测,并利用检测的压力波形对其故障进行诊断的基本原理和方法。     

广州本田雅阁轿车空调系统的检修

给出广州本田雅阁轿车空调系统在车上的布置情况及控制电路图,具体介绍其电动机的检修、继电器的检测、功率晶体管与电子控制器的检修及空调系统的故障自诊断,并围绕这4部分内容分别展开探讨。     

桑塔纳汽车后桥强度有限元分析及改进方案

根据桑塔纳2000汽车后桥的实际结构，利用通用有限元软件ANSYS，对后桥进行了弹塑性静态结构有限元分析。主要研究了结构焊接处强度、横梁破坏处在半个周期载荷波内应力状态变化；给出了在最大剪应变幅平面上，影响疲劳强度及寿命的基本参量的计算结果；提出了提高后桥强度的改进方案。     

Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

一种确定高圆簧横向刚度的有效方法

文中将高圆簧简化为等截面弹性直杆，导出高圆簧横向刚度计算式，并用试验结果进行修正，提出高圆横向刚度分析方法。理论分析和试验结果表明：高圆簧横向刚度的大小取愉于高圆簧的自由高度和工作高度，即由其结构几何参数和工作载荷决定。按文中方法确定的高圆簧横向刚度理论值与试验结果间的最大误差不超过１０％，满足工程理论分析要求。     

汽车车身结构碰撞性能的试验研究

为了在碰撞事故中有效地保护乘员的生命安全，汽车首先必须具备安全车身，以确保事故中乘员的生存空间及缓和冲击，其后应配置合理的乘员约束条件，以避免或减缓乘员与车内结构二次碰撞造成的灾害。详细介绍了车身构件碰撞性能的试验方法和研究结果。     

汽车轮胎结构非线性有限元分析

本文综述了轮胎力学的发展历史与现状，阐明了轮胎结构分析的几各主要方法、研究内容及其优缺点，并重点介绍了在子午三维非线性有限元结构分析方面的工作，包括轮胎的充气，竖直加载、稳态滚动、滚动阻力及温度场分析，给出了相应的算例。由于采用一些新的方法和技术，考虑了更真实的轮胎材料模型，结构和载荷，使得分析更为有效、精确，分析结果可作为轮胎的设计，试验与改进的依据。     

国内外汽车碰撞计算机模拟研究的现状及趋势

本文论述和剖析了国内外利用计算机进行汽车碰撞模拟和建立汽车、乘员及汽车安全约束系统数学模型的研究进展。提出了我国开展汽车碰撞计算机模拟研究的发展趋势和应解决的问题。     

驾驶员统计特性对人—车闭环系统响应的影响与汽车主动安全性评价

基于预瞄跟随理论，本文应用一般随机摄动法，对考虑驾驶员不确定性的人－车闭环系统进行响应分析，结合实例，说明该方法在汽车主动安全性评价中的应用。