空气罐控制输液管道水击研究

采用特征线法对瞬时关闭管道终端阀门 ,在安装和不安装空气罐两种状况时 ,管道压力的变化情况进行了数值模拟 ,并分析了空气罐初始容积、空气罐安装位置等参数对管道瞬态水击压力变化的影响 ,结果表明 :在输液管道的适当位置安装容积一定的空气罐能较好地控制水击的产生     

含水率对路用水泥混凝土的影响及微波在线测湿系统

在讨论了含水率对路用土质量的影响因素后，通过对不同种类测试器的分析，确定了较为适用的微波传感器，并给出了微波传感器的输出电压与集料含水率之间的关系式，进而对测试准确度进行计算。     

重载水泥混凝土路面损坏机理及对策研究

随着交通量的增加、轴载的增大和车速的提高,按照传统水泥混凝土路面规范修筑的道路出现了严重的早期破坏。本文通过分析重载交通作用下现有混凝土路面出现的早期破坏特征及其机理,从材料与结构上提出防止水泥混凝土路面在重载作用下发生早期破坏的对策。     

A regression and beam theory based approach for fatigue assessment of containership structures including bending and torsion contributions

Container shipping has been expanding dramatically during the last decade. Due to their special structural characteristics, such as the wide breadth and large hatch openings, horizontal bending and torsion play an important role to the fatigue safety of containerships. In this study the fatigue contributions from vertical bending, horizontal bending and torsion are investigated using full-scale measurements of strain records on two containerships. Further, these contributions are compared to results from direct calculations where a nonlinear 3D panel method is used to compute wave loads in time domain. It is concluded that both bending and torsion have significant impacts on the fatigue assessment of containerships. The stresses caused by these loads could be correctly computed by full-ship finite element analysis. However, this requires large computational effort, since for fatigue assessment purposes the FE analysis needs to be carried out for all encountered sea states and operational conditions with sufficient time steps for each condition. In this paper, a new procedure is proposed to run the structure finite element analysis under only one sea condition for only a few time steps. Then, these results are used to obtain a relationship between wave loads and structural stresses through a linear regression analysis. This relation can be further used to compute stresses for arbitrary sea states and operational conditions using the computed wave loads (bending and torsion moments) as input. Based on this proposed method for structure stress analysis, an efficient procedure is formulated and found to be in very good agreement with the full-ship finite element analysis. In addition it is several orders of magnitude more time efficient for fatigue assessment of containership structures.     

基于ANN的船舶撞击高桩码头群桩损伤位置预测

本文采用有限元软件ABAQUS建立了船舶撞击高桩码头群桩的空间有限元模型。通过计算评估了撞击力、桩体刚度、撞击位置和撞击角度下对群桩结构损伤位置的影响。基于人工神经网络(ANN)方法,对不同参数组合下的群桩结构损伤位置进行了预测,并对ANN方法的可行性进行了评估。     

Towards a model of hydrodynamic damping for a circular cylinder with helical strakes at low KC

This paper investigates the hydrodynamic damping of a circular cylinder with helical strakes at Keulegan-Carpenter (KC) number from 0.07 to 3 in the presence of steady currents. Experiments were performed with a straked cylinder oscillating in either in-line or cross currents over Reynolds number (based on the oscillating velocity amplitude) varying from 1260 to 54,000. With in-line current being present, the measured drag coefficients of the straked cylinder are found to depend on the ratio between the oscillating velocity amplitude and the steady current velocity. This phenomenon is further confirmed by computational fluid dynamics using large-eddy simulations. The drag coefficients obtained from the numerical simulations agree well with the experimentally determined values. Similar phenomenon is observed for the cases with cross background current. Based on the experimental data, empirical formulae are proposed to evaluate drag coefficients. These results are of importance in estimating the resonant motion and the fatigue life of risers, e.g. water intake risers, in the flow regime of low KC. Finally, recommendations are provided for fatigue analysis of risers with helical strakes from the perspective of engineering practice.     

Modeling free-flow speed according to different water depths—From the viewpoint of dynamic hydraulic pressure

In this paper, we propose a method of modeling free flow speed from the viewpoint of hydroplaning. First, the lift forces for different water depths were estimated using Bernoulli’s equation. Compared with the result of the experimental test performed by the Japan Automobile Research Institute, the hydrodynamic pressure coefficient was determined to be 0.03 (tf s²/m⁴). The validation of the predicted lift force is found in another published paper. A very good match is found between the computed values by the proposed numerical model and the data in other published papers. Then, the loss of contact force is considered to evaluate the hydroplaning performance of a tire. To simulate the hydroplaning speed, a tire-sliding model was utilized to obtain the traction and friction forces between the road surface and the tire. The observation data obtained in Japan in 2009 is compared with the physically computed hydroplaning speed, yielding the conclusion that the traction force at the measured desired speed is, on average, 23.4% of the traction force at hydroplaning speed. The analytical model offers a useful tool to quantitatively show that the free flow speed changes as the water depth increase.     

Layout optimization of an inertial energy harvester for miniature underwater mooring platforms

Comprehensive analyses of the layout influence on power performance of a low-frequency miniature horizontal-pendulum-type inertial energy harvester for underwater mooring platforms are presented in this article. The mathematical models are obtained utilizing the Newton-Euler method. The power performance is evaluated by simulations over different parameters, such as damping, excitation frequency, and layout position. Simulation results indicate that the harvester can extract energy from low-frequency excitations over the range of 0.1 Hz–0.4 Hz, and maximum output power can reach to 0.7 W under excitation frequency f = 0.4 Hz. Different layout positions influence the energy harvesting performance of the harvester dramatically. Changing the layout position to positive value can enhance and broaden the power performance. The amplitude responses with different layout positions do not show resonant characteristics, even near the natural frequency of the harvester, due to large amplitude vibrations and strong nonlinear characteristic. As excitation frequency f = 0.4 Hz, there is a zero output power point appears at layout position d = −1.3 m. Moreover, the harnessed power has a quadratic relationship with the layout position value.     

中韩船舶油污损害赔偿制度的比较

韩国不论是从地理位置还是经济贸易往来,对于我国是很重要的邻国.由于海上运输的国际性,我国的船东有在该国卷入油污损害赔偿案件的可能,研究其油污损害赔偿制度能够更好的保护我国船东的权益,而且对于我国完善油污民事赔偿立法有一定的借鉴作用.本篇论文比较了中韩油污损害赔偿制度,并对完善我国油污损害赔偿制度提出几点建议.