搅拌桩处理公路软弱地基施工工艺的探讨

以搅拌桩工艺处理软土地基,使其承压性能达到道路施工的必要条件。基于工程实践对其使用工艺进行技术优化,对于提高作业效率和降低工程成本是十分必要的。     

软基路段水泥稳定碎石基层裂缝处治方法探讨

水泥稳定碎石基层作为公路的基础结构层发挥着很大的作用.在道路建设工程中,水泥稳定碎石基层的裂缝现象十分普遍.探讨水泥稳定碎石基层裂缝的处治方法,对指导实际工作有一定的意义.     

Corrosion rate measurements in steel sheet pile walls in a marine environment

Corrosion of steel structures in the marine environment is a major problem. The deterioration of this kind of structures is costly and difficult to predict both when designing new structures and when estimating the remaining service life time for existing structures. The aim of this investigation was to find indicative values for the corrosion rate of steel sheet piles on the Swedish west coast. Such corrosion rates (mm/year) can be used both when designing new structures by oversizing the steel thickness and when estimating the bearing capacity of existing sheet pile structures. Earlier investigations on the corrosion rates along the Swedish east coast – with salinity from about 0.2% to 0.8% – are still used today as guidelines for the corrosion rate of all steel structures in the Swedish maritime environment even though the salinity on the west coast can be as high as 3.0%.Steel sheet pile wharfs located in the port of Halmstad on the Swedish west coast were inspected by ultrasonic measurements. Three wharf structures with a total length of about 700 m were inspected. None of the inspected wharfs had or have had cathodic protection. The thickness measurements of the steel sheet pile structures were performed by divers.The age of the three inspected sheet pile structures ranged from 36 to 51 years. The dimensions of the original sheet pile sections are known. One of the quay structures is located along a river. The salinity at all wharfs varied from low values at the surface to approx. 2% at the bottom (also in the river outflow).The measured average corrosion rates were in the same order as the design values in the European code. However, the results indicate increased corrosion rates about 1 m below the mean water surface and at the level of the propellers from the ships berthing the most frequented of the inspected wharfs, 3–6 m below water surface.The tolerances of steel sheet thicknesses – usually in the order of ±6% – are often neglected when investigating the remaining thickness in steel sheet piles. A simple calculation model shows that the sheet pile must be almost 50 years of age before an accurate estimation on the corrosion rate can be made, considering the tolerances, if the true original sheet pile thickness is not known.     

高铁湿陷性黄土隧道地基处理浅析

根据湿陷性黄土隧道工程特点,结合宝兰客专客运专线王家岔湿陷性黄土隧道地基加固处理的工程实例,阐述了洞口和洞内两种施工工艺不同的水泥土挤密桩施工方案,分析了隧道内水泥土挤密桩施工对其它工序的干扰和对工期的影响,以及施工振动对初支结构和围岩稳定的危害,提出了有效的控制措施.     

水泥混凝土路面病害的预防及处理措施

随着我国公路建设的快速发展,水泥混凝土路面的铺筑越来越广泛。目前,我国各省市二级公路大部分采用水泥混凝土刚性路面,在部分省市如广西、广东,水泥混凝土刚性路面还广泛运用于高速公路。因此,水泥砼路面的质量对投资和运营至关重要。     

水泥混凝土路面破碎板处理技术浅析

以SL沿海高速抚宁连接线为例,分析病害形式和产生原因,以及在破碎板处理中出现的质量问题,提出解决问题的最佳方法.     

水泥混凝土面板裂缝处治施工技术

分析了旧水泥混凝土路面板产生裂缝的原因及破坏类型,对实体工程裂缝进行调查分析,介绍了在旧路加铺改造中采用的针对轻、中、重裂缝的处治方法与施工工艺,通过实体工程应用对其使用效果进行了评价。     

就地水泥冷再生施工技术在路面大中修养护中的应用

结合国道202线吉林省磐石段路面维修工程,对冷再生施工工艺及其性能指标进行了探讨,为就地冷再生技术在吉林省的推广应用提供参考经验。工程实践证明,旧路面就地冷再生技术具有成本低、工期短、节约材料、不损坏路基、消除污染保护环境、交通安全等特点,对于节约自然资源、保护生态环境具有极大的意义。     

沥青搅拌设备燃烧系统的使用维护及故障排查研究

随着我国公路建设的快速发展，越来越多的施工技术应用于公路的建设中，因此施工设备面临着很大的挑战。针对施工中沥青搅拌设备燃烧系统发生的开启风门较大、设备内部阀芯被杂质或者油品堵塞以及无法点火等问题进行了细致的探讨，分析故障排查方法，以保障路面施工不受影响。     

Estimates of vertical mixing during a Lagrangian experiment off the Galician coast

An adjoint 1-D model was used to determine vertical diffusivity coefficients from temperature profiles collected within a filament escaping from the Galician coast following an upwelling event. The optimisation scheme ended with relatively high diffusivity values within the thermocline (9×10⁻⁵ m² s⁻¹). Such high values are relevant for biogeochemical exchanges between surface and deep waters in stratified areas.The optimised values were several orders of magnitude higher than the bulk of diffusivity measurements recorded with a free-falling device; however, the optimisation solution was consistent with the arithmetic mean of the measurements in the thermocline (7.7×10⁻⁵ m² s⁻¹), giving more weight to the few largest values. Below the thermocline, the data assimilation method failed because of the three-dimensional nature of the advective field of the upwelling system. Ignoring this advective forcing in the model led to estimates that were two orders of magnitude too high.The results suggest that turbulent mixing is a random process where a few intense events determine the average mixing that drives the long-term evolution of the water column structure. This statistical property is very important when one wants to use instantaneous diffusivity measurements for modelling purposes.