全文获取类型
收费全文 | 8472篇 |
免费 | 728篇 |
专业分类
公路运输 | 3427篇 |
综合类 | 1959篇 |
水路运输 | 1852篇 |
铁路运输 | 1758篇 |
综合运输 | 204篇 |
出版年
2024年 | 35篇 |
2023年 | 44篇 |
2022年 | 244篇 |
2021年 | 341篇 |
2020年 | 385篇 |
2019年 | 271篇 |
2018年 | 239篇 |
2017年 | 195篇 |
2016年 | 155篇 |
2015年 | 278篇 |
2014年 | 723篇 |
2013年 | 489篇 |
2012年 | 742篇 |
2011年 | 855篇 |
2010年 | 635篇 |
2009年 | 509篇 |
2008年 | 552篇 |
2007年 | 675篇 |
2006年 | 577篇 |
2005年 | 345篇 |
2004年 | 236篇 |
2003年 | 164篇 |
2002年 | 101篇 |
2001年 | 87篇 |
2000年 | 51篇 |
1999年 | 31篇 |
1998年 | 30篇 |
1997年 | 29篇 |
1996年 | 37篇 |
1995年 | 18篇 |
1994年 | 29篇 |
1993年 | 24篇 |
1992年 | 17篇 |
1991年 | 10篇 |
1990年 | 9篇 |
1989年 | 15篇 |
1988年 | 6篇 |
1986年 | 10篇 |
1985年 | 1篇 |
1984年 | 6篇 |
排序方式: 共有9200条查询结果,搜索用时 31 毫秒
701.
对水泥乳化沥青砂浆的拌和工艺、配合比的选取、试验数据以及技术参数之间的关系进行系统的对比和统计分析,利用正交试验方法初步确定可行的配合比。通过多次试验,确定水泥、乳化沥青、掺合料、细骨料、表面活性剂、减水剂和铝粉等材料的选取和投料顺序、搅拌速度、搅拌时间及配合比,然后考察各组配比的主要性能指标,对配比进行微调,最终确定最佳配比。 相似文献
702.
《铁道标准设计通讯》2015,(7):23-27
拟建阳安二线沿线膨胀土广泛分布,膨胀土不能直接作为路基填料,如果选取合格填料,运距较远、投资大,而且挖方地段的膨胀土又得弃掉、占地多,极不经济。通过选取现场两处代表性取土场取样,生石灰粉作添加剂,按4%、6%、8%、10%四个级别的掺入比做室内改良试验,试验表明:生石灰掺入比大于4%改良后,能达到消除膨胀性的目的,改良土有较好的水稳性和较高的强度,能满足设计要求;改良土较原膨胀土有较高的抗压强度和剪切强度,且随生石灰的掺入比增加而增大;得出了路基不同部位、不同膨胀级别膨胀土的生石灰粉掺入比,为阳安二线路基填料设计提供了理论依据。 相似文献
703.
针对黄土隧道开挖这一施工领域中的难题,依托地坑院隧道,对隧道穿越沿线地质地形的施工风险进行分析,同时基于监控量测数据,对典型横断面和纵向段的初期支护变形规律进行研究,得出初期支护沿时空分布的变形特征。分析结果表明: 1)围岩变形持续时间长、变形速率大,有时具有突变性; 2)初期支护横断面收敛不均,纵向变形与断面距掌子面距离直接相关; 3)隧道变形受地形、地下水和施工的影响较大。根据现场围岩大变形规律针对性地制定相关控制措施,研究成果可为现场施工提供技术性指导。 相似文献
704.
705.
120阀试验过程的计算机仿真——紧急阀模型及仿真结果 总被引:3,自引:1,他引:2
建立了120紧急阀和试验台计算仿真模型,仿真了120紧急阀在试验台上的试验过程,结果表明:该模型能很好的仿真120阀在试验台上紧急阀试验,利用模型预测了试验台管径变化对紧急阀试验性能的影响,计算发现:管径主要影响紧急灵敏度和列车管排气时间。压力表安装位置分析表明:对于气体流速较快工况,测量结果与压力表的位置相关性较大,需要慎性确定压力表位置。该工作为试验台设计、试验规范制定和120紧急阀性能改进提 相似文献
706.
为了正确控制橡胶沥青工艺,采用不同胶粉种类、胶粉细度、拌和温度、基质沥青类型等制备橡胶沥青,进行针入度、软化点、弹性恢复以及SHRP等试验,分别测试橡胶沥青的高温性能、低温性能、抗老化性能等,研究各因素对橡胶沥青性能的影响,得出20目橡胶粉掺量以16%~18%较为合适的结果。 相似文献
707.
《Vehicle System Dynamics: International Journal of Vehicle Mechanics and Mobility》2012,50(11):1061-1082
The dynamic model was developed to evaluate vibration accelerations and ride comforts during the running of the Korean-standardised rubber-tired light rail vehicle. Ride comfort indexes were analysed and tested in accordance with UIC 513R by using the dynamic model and the actual vehicle in the test track. Based on the comparisons between analysis results and test results, the validity of the developed dynamic model was evaluated. It was verified whether or not the developed Korean-standardised rubber-tired light rail vehicle met the specified target specification on ride comfort. In addition, the influence of the wearing of guide wheels on ride comfort was estimated. 相似文献
708.
《Vehicle System Dynamics: International Journal of Vehicle Mechanics and Mobility》2012,50(12):1622-1641
Wheel set flange derailment criteria for railway vehicles are derived and the influence of wheel–rail contact parameters is studied. An indirect method for wheel–rail force measurement based on these derailment evaluation criteria is proposed. Laboratory tests for the calibration of strain–force devices on the bearing box are carried out to determine the relationship between the applied force and the measured strain. The simulation package, SIMPACK, is used to develop a passenger car model to generate wheel–rail forces and vibration signals. Different cases are considered in this model to provide an accurate validation of the identified wheel–rail forces. A feasibility test is conducted in the Beijing Loop test line using a passenger car equipped with a set of strain gauges on the wheel set. The comparison of the force time history applied to the instrumented wheel set and that obtained using the indirect method is presented. 相似文献
709.
关泽萍 《内蒙古公路与运输》2010,(1):38-39
通过进行砂、石材料坚固性直接冻融和硫酸钠法的对比试验,总结出对工程耐久性的影响和两种方法不可替代的关系。 相似文献
710.
朱靖伟 《内蒙古公路与运输》2011,(3):41-43
简述了公路面层及基层施工控制要点,并介绍了施工过程中需要的各种检测,以便及时反馈,做好施工控制工作,对保证沥青混凝土路面的施工质量,具有一定的指导意义。 相似文献