挂篮底模纵梁受力简化计算方法及承重分配系数

以一桥梁施工工程实例为依托,采用有限元软件ANSYS对桥梁悬臂施工中使用的菱形挂篮进行仿真分析.提出3种简化模式计算底模纵梁的承重分配,对比发现将底模纵梁承受的外荷载简化为集中荷载,并分配至挂篮下前后横梁的方法是最优简化计算方法.在此基础上对挂篮底模纵梁承重分配系数进行优化,从而简化了繁琐的挂篮底模纵梁受力分析计算,保证了挂篮结构设计和施工的安全.     

Simulation on progressive collapse behaviour of whole ship model under extreme waves using idealized structural unit method

To ensure the safety of navigating ship, working loads and structural load-carrying capacity are two important aspects. In the present paper, a total simulation system combing load calculation and structural collapse analysis is applied to simulate progressive collapse behaviour of a single-hull Kamsarmax type bulk carrier. A three dimensional singularity distribution method is adopted to calculate pressure distribution with time history. A mixed structural model, collapse part simulated by ISUM elements and remaining part by elastic FEM elements with relative coarse mesh, is proposed for collapse analysis. Progressive collapse behaviour obtained by ISUM is good agreement with that by nonlinear software package, MARC. However, the calculation time of ISUM analysis is about 1/70 of MARC analysis. The applicability to structure system, high accuracy and sufficient efficiency of ISUM had been demonstrated.     

某散货船试航中主机滑油低压故障的排除

文章分析了某散货轮在试航中主机多次出现因滑油低压而报警停车的故障现象,并将该故障出现的原因及排除过程进行了总结和思考,以期为船厂、船东以及试航的相关人员提供参考。     

内压载荷下X80管道裂纹应力分布规律研究

为了研究内压作用下管道裂纹应力场分布规律,以含有表面裂纹的X80管道为研究对象,对不同形状、不同方向、不同内压、不同尺寸的含裂纹管道进行仿真分析和实验验证。结果表明:裂纹尖端处应力远大于裂纹中心应力。裂纹形状对应力影响作用较小,随着裂纹方向与管道轴向夹角增大,裂纹尖端应力先增大后减小,随着管道内压、裂纹深度、裂纹长度的增大,裂纹尖端处应力随之线性增大。其中,裂纹长度对裂纹尖端应力的影响小于管道内压和裂纹深度。     

格拉斯磁环匀强磁场分析

以毕奥-萨伐尔定律为基础,建立亥姆霍兹线圈以及格拉斯磁环中心磁场分布模型,并计算了它们内部的轴向磁感应强度分布,绘出了空间分布图,分析了轴向磁感应强度与x、y坐标的关系,分析结果得到了亥姆霍兹线圈和格拉斯磁环内部匀强磁场分布区域,通过比较得到格拉斯磁环内部的匀强磁场区域比亥姆霍兹线圈内部的匀强磁场分布区域更大的结论。     

A copula-based approach for estimating the travel time reliability of urban arterial

Estimating the travel time reliability (TTR) of urban arterial is critical for real-time and reliable route guidance and provides theoretical bases and technical support for sophisticated traffic management and control. The state-of-art procedures for arterial TTR estimation usually assume that path travel time follows a certain distribution, with less consideration about segment correlations. However, the conventional approach is usually unrealistic because an important feature of urban arterial is the dependent structure of travel times on continuous segments. In this study, a copula-based approach that incorporates the stochastic characteristics of segments travel time is proposed to model arterial travel time distribution (TTD), which serves as a basis for TTR quantification. First, segments correlation is empirically analyzed and different types of copula models are examined. Then, fitting marginal distributions for segment TTD is conducted by parametric and non-parametric regression analysis, respectively. Based on the estimated parameters of the models, the best-fitting copula is determined in terms of the goodness-of-fit tests. Last, the model is examined at two study sites with AVI data and NGSIM trajectory data, respectively. The results of path TTD estimation demonstrate the advantage of the proposed copula-based approach, compared with the convolution model without capturing segments correlation and the empirical distribution fitting methods. Furthermore, when considering the segments correlation effect, it was found that the estimated path TTR is more accurate than that by the convolution model.     

船舶低硫柴油系统设计的分析与优化

就新辟航线首制船“汉亚直达”集装箱船的低硫柴油系统,叙述了船舶低硫柴油系统的设计经验,从当前国内外对船用燃油硫含量的要求、应对方案到船舶低硫柴油冷却方式选择、低硫柴油冷却系统设计、高/低硫柴油转换、使用低硫柴油风险分析及处理等方面进行详细叙述,为业内同行提供参考。     

Extreme hawser tension assessment for FPSO vessel during offloading operation in Bohai bay

The Floating Production Storage and Offloading Unit (FPSO) is an offshore vessel that produces and stores crude oil prior to tanker transport.Robust prediction of extreme hawser tensions during Floating Production Storage and Offloading (FPSO) operation is an important safety concern. Excessive hawser tension may occur during offloading operations, posing an operational risk. In this paper, AQWA has been used to analyze vessel response due to hydrodynamic wave loads, acting on a specific FPSO vessel under actual sea conditions. Experimental validation of numerical results has been discussed as well.This paper advocates methodology for estimating extreme response statistics, based on simulations (or measurements). The modified ACER (averaged conditional exceedance rate) method is presented in brief detail. Proposed methodology provides an accurate extreme value prediction, utilizing all available data efficiently. In this study the estimated return level values, obtained by ACER method, are compared to the corresponding return level values obtained by Gumbel method. Based on the overall performance of the proposed method, it is concluded that the improved ACER method can provide more robust and accurate prediction of the extreme hawser tension.Data declustering issue has been addressed. Paper highlights ability of ACER method to account for a set of varying sea state probabilities, as required in engineering long term statistical analysis.Described approach may be well used at the vessel design stage, while defining optimal vessel parameters that would minimize potential FPSO hawser tension.     

考虑空车调配协调的货物列车开行方案优化研究

为实现空车调配与货物列车开行方案协调优化，结合基本运行图架构与车流径路，构建货运时空服务拓展网络。考虑配空与装卸取送、集编发等环节的时间接续要求，节点与区段不对流空车要求，以重车流全程运送与空车配送等广义总费用最少为目标，建立整数规划弧路模型。针对既有算法设计局限性，结合重车或空车配空的时间接续要求，提出将不同的 k 短路重车流方案与空车配空方案相关联的改进可行解构造方法，设计混合差分进化求解算法。实例研究表明，考虑空车调配进行重车、空车流组织协调优化，能够减少空车走行费用，及时满足装车需求，有效保证作业车流配合中转车流集结编组及时挂线，提高方案可实施性。