Traffic and emissions impact of congestion charging in the central Beijing urban area: A simulation analysis

Congestion charging is being considered as a potential measure to address the issue of substantially increased traffic congestion and vehicle emissions in Beijing. This study assessed the impact of congestion charging on traffic and emissions in Beijing using macroscopic traffic simulation and vehicle emissions calculation. Multiple testing scenarios were developed with assumptions in different charging zone sizes, public transit service levels and charging methods. Our analysis results showed that congestion charging in Beijing may increase public transit use by approximately 13%, potentially reduce CO and HC emissions by 60–70%, and reduce NOx emissions by 35–45% within the charging zone. However, congestion charging may also result in increased travel activities and emissions outside of the charging zone and a slight increase in emissions for the entire urban area. The size of charging zone, charging method, and charging rate are key factors that directly influence the impact of congestion charging; improved public transit service needs to be considered as a complementary approach with congestion charging. This study is used by Beijing Transportation Environment and Energy Center (BTEC) as reference to support the development of Beijing’s congestion charging policy and regulation.     

Full six degrees of freedom coupled dynamic simulation of ship collision and grounding accidents

By taking advantage of the user-defined load subroutine (loadud) and the user common subroutine (usercomm) in LS-DYNA, the authors proposed a new coupled approach for simultaneously calculating structural damage and the planar 3DOF ship motions in ship collisions. The coupled procedure aimed at predicting the detailed structural damage together with reasonable global ship motions. This paper extends the method to consider the full 6DOF ship motions; thus, ship collision as well as grounding accidents can be properly handled. This method is particularly useful for design purposes because the detailed ship hull profile is not needed.A traditional ship maneuvering model is used for the in-plane surge, sway and yaw degrees of freedom with a series of nondimensional coefficients determined from experiments. It is assumed that the out-of-plane degrees of freedom are not coupled with the in-plane ship motions, and there is no coupling among roll, pitch and heave motions. The implementation is verified through free decay tests, and the obtained natural periods show good agreement with theoretical results.Several collision and grounding cases are simulated in which a supply vessel crashes into rigid plates with different orientations. The effects of the roll motion, the heave and pitch motions and the full 6DOF motions are studied. The results are compared with those from a 6DOF decoupled method. Ship motions through the proposed method compare reasonably well with SIMO results. It is found that several consecutive impacts may occur in the simulation of one collision case due to the periodic motions. This is not taken into account in the decoupled method, which makes this method unconservative.     

卡西姆港燃煤应急电站卸煤码头港池水域平面布置优化

针对复杂水域条件下大型散货码头的水域平面布置,基于卡西姆燃煤应急电站码头工程项目,根据对周边已建工程、红树林以及水动力等主要影响因素的深入分析提出初步平面方案,并通过船舶操纵模拟试验对平面布置及相关尺度进行优化,合理确定本工程平面布置方案。结果表明,本工程的建设对周边影响较小,水域尺度能够满足船舶通航及靠离泊要求,水域平面布置合理。     

LNG码头应急通道与应急锚地研究

本文针对LNG应急逃离情况以及国内LNG应急锚地使用现状,总结分析国内、外LNG应急锚地布置情况;结合江苏滨海LNG码头通航条件,提出LNG应急通道及应急锚地三种布置方案,通过操船模拟试验论证比选并得出结论,供类似工程参考。     

粉质黏土层大直径泥水盾构掘进地层扰动分析

针对盾构机在粉质黏土层中推进引起的地层扰动进行分析尤为重要。以新建京张高铁JZSG-1标段清华园隧道2号～1号盾构区间为例,采用现场实测与数值模拟相结合的方法,研究大直径泥水平衡盾构隧道穿越粉质黏土层引起的地层扰动,得到土体横向水平位移及地表沉降的变化规律。需对横向1.5D范围内地表及建(构)筑物进行地层加固、加强监控量测;在盾构掘进过程中,应根据沉降数据实时调整盾构掘进参数及加固方案,以期更好地控制地表沉降。针对掌子面释放系数和注浆层软化模量进行参数分析数值计算,提出地表沉降的有效控制方法,在条件允许情况下适当提早管片的拼装及适当加快注浆层的硬化速度,可有效控制地表沉降。     

考虑移步需求的无桩型共享单车动态调度研究

共享单车系统自发的不均衡性导致单车数量分布与用户需求分布之间产生偏移，降低了系统服务能力，需要调度实现再平衡. 现有动态调度算法缺乏考虑起点车辆供给不足，用户在出行过程中“再次”取车的移步需求，难以准确识别用户真实的出行需求分布，降低了调度效果. 本文提出以用户出行选择行为为下层，以调度车辆路径规划为上层的双层规划模型框架，设计结合仿真系统的启发式求解算法. 算例场景基于上海市虹口、杨浦区共享单车历史出行数据搭建，并进行网格化处理. 算例结果表明，模型能有效识别移步需求，提高共享单车的供需匹配能力. 针对各类调度资源配置情况，共享单车的供需匹配率提升18.07%~ 19.89%，提高了共享单车系统的管理效率.     

频繁爆破下隧道内振动传播的数值研究

为揭示频繁爆破下隧道内振动传播衰减规律,文章以蒙华铁路段家坪隧道为工程背景,利用LS-DY NA建立了三维隧道模型,模拟分析了多次爆破下隧道内近区和中远区的振动传播规律。结果表明,质点垂向峰值振速随距离和爆破次数的增大而减小,少数振速有增大的现象;近区振动衰减较快,中远区振动衰减比近区缓慢;中远区a值比近区至少小12.5%,但整体上二者的a值随爆破作用次数的增加呈缓慢上升趋势;系数K随爆破作用次数的增加而降低,近区K值降低速率普遍大于中远区,且近区K值比中远区至少大29.1%;频繁爆破下,中远区比近区较符合萨道夫斯基经验公式。     

Simulating the air quality impacts of traffic calming schemes in a dense urban neighborhood

In this study, the effects of isolated traffic calming measures and area-wide calming schemes on air quality in a dense neighborhood were estimated using a combination of microscopic traffic simulation, emission, and dispersion modeling. Results indicated that traffic calming measures did not have as large an effect on nitrogen dioxide (NO₂) concentrations as the effect observed on nitrogen oxide (NO_x) emissions. Changes in emissions resulted in highly disproportional changes in pollutant levels due to daily meteorological conditions, road geometry and orientation with respect to the wind. Average NO₂ levels increased between 0.1% and 10% with respect to the base-case while changes in NO_x emissions varied between 5% and 160%. Moreover, higher wind speeds decreased NO₂ concentrations on both sides of the roadway. Among the traffic calming measures, speed bumps produced the highest increases in NO₂ levels.     

救助船模拟器原型机关键技术研究

针对大风浪条件下救助船操纵训练的要求，有必要开发针对救助船的操纵模拟器。相比于传统的通用船舶模拟器，救助船模拟器原型机系统中引入六自由度平台运动系统，基于UDP协议传输船舶姿态数据实现实时体感模拟功能，可以模拟船舶在大风浪条件下剧烈摇动的操船环境，提高模拟训练的真实感。此外，系统中引入救助作业模拟模块的思想，可以更好地评估、训练船员在恶劣海况下配合其他救助人员完成救助任务的能力，提高执行海上救助任务的成功率与效率。     

A methodology for evaluating the performance of model-based traffic prediction systems

Model-based traffic prediction systems (mbTPS) are a central component of the decision support and ICM (integrated corridor management) systems currently used in several large urban traffic management centers. These models are intended to generate real-time predictions of the system’s response to candidate operational interventions. They must therefore be kept calibrated and trustworthy. The methodologies currently available for tracking the validity of a mbTPS have been adapted from approaches originally designed for off-line operational planning models. These approaches are insensitive to the complexity of the network and to the amount and quality of the data available. They also require significant human intervention and are therefore not suitable for real-time monitoring. This paper outlines a set of criteria for designing tests that are appropriate for the mbTPS task. It also proposes a test that meets the criteria. The test compares the predictions of the mbTPS in question to those of a model-less alternative. A t-test is used to determine whether the predictions of the mbTPS are superior to those of the model-less predictor. The approach is applied to two different systems using data from the I-210 freeway in Southern California.