用示波器对柴油机喷油系统进行故障检测与诊断

阐述利用示波器对柴油发动机喷油系统压力波形进行检测,并利用检测的压力波形对其故障进行诊断的基本原理和方法。     

广州本田雅阁轿车空调系统的检修

给出广州本田雅阁轿车空调系统在车上的布置情况及控制电路图,具体介绍其电动机的检修、继电器的检测、功率晶体管与电子控制器的检修及空调系统的故障自诊断,并围绕这4部分内容分别展开探讨。     

Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

一种确定高圆簧横向刚度的有效方法

文中将高圆簧简化为等截面弹性直杆，导出高圆簧横向刚度计算式，并用试验结果进行修正，提出高圆横向刚度分析方法。理论分析和试验结果表明：高圆簧横向刚度的大小取愉于高圆簧的自由高度和工作高度，即由其结构几何参数和工作载荷决定。按文中方法确定的高圆簧横向刚度理论值与试验结果间的最大误差不超过１０％，满足工程理论分析要求。     

汽车车身结构碰撞性能的试验研究

为了在碰撞事故中有效地保护乘员的生命安全，汽车首先必须具备安全车身，以确保事故中乘员的生存空间及缓和冲击，其后应配置合理的乘员约束条件，以避免或减缓乘员与车内结构二次碰撞造成的灾害。详细介绍了车身构件碰撞性能的试验方法和研究结果。     

车用催化转化器流动阻力影响因素的研究

流动阻力是车用催化转化器的重要性能之一。作者对载体结构参数，入口扩张管和出口收这三个因素进行了试验研究，并对载体通道的流动进行了理论分析，提出了一种计算载体流动阻力的方法。研究结果表明，载体结构参数和扩张管锥角对流动阻力影响显著，而收缩管锥角的影响不明显，在载体结构参数中，减小载体壁厚是降低催化器阻力的有效措施。     

车辆行驶工况滚动阻力系数的测定

分析了车辆滚动阻力系数的影响因素，论述了车辆行驶速度对滚阻力系数的影响。依据车辆行驶的功率平衡原理，提出了滚动阻力系数的测试方法及测试时应注意的问题。并对实车测试值与经验公式估算值进行了比较。     

非自由液化场地地基动力性能大型振动台模型试验研究

基于1∶10模型大型振动台试验,研究非自由液化场地的地基动力性能。液化场地条件下,与自由场地基相比,非自由场地地基的自振频率明显加大、动力耗能作用提高较小。土层液化前且在小震输入下,地基动力变形的线性特征较突出,主要表现为对地震波的动力放大作用,加速度反应自下而上逐渐增大;土层完全液化后,地基加速度反应自下而上也逐渐增大,这是由于液化地基的层间剪切运动加快且加快的速率自下而上逐渐增大所致。地基孔压变化主要受两方面因素影响:一是随埋深减小,孔压减小,但孔压比增大;二是离桩距离越近,孔压和孔压比越大。土层液化前,输入波主要峰值过后,自下而上孔压消散逐渐减慢。较大震输入下,自下而上孔压有减小的趋势,但最大孔压比均很快达到液化孔压比;输入波主要峰值过后,孔压消散很缓慢,尤其是孔压消散随埋深减小越来越慢。试验中还出现瞬时负孔压的有趣现象,这也许是由于可液化土层发生瞬时膨胀作用所致。     

液压马达实验方法研究

介绍了液压试验分类方式,根据其独具的特点对在用液压马达性能试验加载方法进行分析,并分类对工程机械用各种液压马达在泵工况下进行试验的可行性进行了探讨.     

填石路堤原位抗剪试验研究

在路堤原位抗剪试验基础上，获取路堤原位抗剪强度指标内摩擦角φ和黏聚力C，以推滑平衡分析法为理论基础，提出4点基本假设，经过现场试验数据计算分析，论证了假设成立和推滑平衡分析法应用于填石路堤的正确性。