探讨沥青路面局部渗水的原因及处理方法

通过武汉市汉蔡高速公路沥青路面出现的局部渗水现象,分析沥青路面产生局部渗水的原因及处理的必要性,提出对沥青路面局部渗水的处理原则及处理方法。     

移动式格栅除污机的应用与设计

针对大型泵站进水口设置多台并列布置的固定格栅,其工程投资大、设备利用率不高的弊端,建议使用移动式格栅除污机,并对其结构形式、主要构件设计计算及关键技术进行了阐述。移动式格栅除污机的成功应用为我国的水处理事业增添了一项新的专用设备。     

浅谈桥梁防水与防腐

该文介绍了桥梁防水层材料及其铺装技术,针对桥梁在不同地区经历了季节变换后所呈现的各种老化腐蚀现象,提出了处理方法。     

路面沥青复合料基于孔隙水压力损坏的实验分析探究

集料-沥青界面强度实验,集料-沥青界面黏合机能影响要素分析,孔隙水压对沥青复合料的损坏原理。本研究经过界面拉拔实验,分析沥青老化、温度和水分等要素对集料-沥青界面黏合机能的影响,探讨车辆载荷作用下孔水压对集料-沥青黏合机能的影响及损坏原理,以为同类沥青复合料路面工程应用提供研究和技术参考。     

百色水利枢纽通航设施工程省水船闸选型方案

广西百色水利枢纽通航设施工程率先采用“省水船闸+升船机+辅助船闸”组合式通航建筑物总体布置方案,其省水船闸带两级独立梯形断面省水池,省水率可达55%。介绍百色水利枢纽通航设施工程通航建筑物形式选择,阐述采用“省水船闸+升船机+辅助船闸”组合方案后,船闸下泄水流进入中间渠道后引起的升船机上游水位波动情况,以及全平衡式升船机在对接过程中对于水位变化的要求。为解决水位波动对升船机安全运行的影响问题,提出非省水船闸+泄水外排方案与省水船闸方案,并对两方案进行技术经济对比分析,最终确定采用省水船闸方案。     

高速船尾部喷水推进局部振动分析

针对高速船尾部采用喷水推进装置的局部振动问题,建立了船体尾部包含喷水推进泵的有限元模型。考虑附连水质量的影响,将船体尾部离散成甲板,底板,喷水推进泵,尾板等局部结构,采用规范经验公式估算以及有限元分析的方法分别对各局部结构的板、板格、板架进行固有频率计算,将其结果与轴频和叶频激励频率进行储备频率校核,判断尾部采用喷水推进装置在振动问题上是否满足规范标准,并为下一步的船体设计提供参考。     

油田注水管道的腐蚀研究与缓蚀剂评价

油田注水管线所输送介质复杂,腐蚀现象严重,存在安全隐患,一旦因腐蚀泄漏就会造成巨大的经济损失。因此,开展油田注水管道的腐蚀研究及采取措施减缓腐蚀具有重要意义。为此,对某油田注水管道现场采集注入水样及腐蚀产物,通过X-射线衍射及X-射线能谱仪进行分析,分析结果表明腐蚀产物主要是碳酸钙,同时含有一定量的氯化物、碳酸亚铁、硫化物等成分。通过电镜扫描腐蚀产物的微观形貌,发现存在氯离子腐蚀。并通过ICP-OES分析输送介质组分,针对其腐蚀特点及输送介质组分,采用失重法及电化学方法评价了引入季铵盐的咪唑啉缓蚀剂HJD2最佳质量分数及缓蚀机理,实验结果表明该缓蚀剂对该注水管道具有较好的缓蚀作用,在现场注水温度下,最佳质量分数(0.06%)时的缓蚀效率为95.1%,通过注入该缓蚀剂可以有效地减缓该注水管线的腐蚀,延长管线的使用寿命。     

涵洞基坑降水方案比选与参数分析

结合哈大铁路客运专线DK651+972涵洞施工的实例,论述了根据实际水文地质条件确定降水方案,对以往经验参数进行修改,以达到降水目的及确保工程顺利进行。     

Mechanism of Tunnel Water Inflow Caused by Bending Failure of a Waterproof Dike Based on a Circular Thin Plate Mechanical Model北大核心CSCD

Water bursts during tunnel construction endanger construction, and it is therefore necessary to reserve a waterproof dike with the required thickness to avoid water bursts and to take reinforcement of the dike and treatment of the structure liable to trigger a water burst. Using the water burst at K5+398 of the Mingyueshan tunnel of the Shanghai-Chengdu expressway as an example, and considering the type of tunnel section and the upright mudstone of the dike, the waterproof dike at the work face is simplified as a round thin plate. A formula for the calculation of a minimum safety thickness for the critical waterproof dike is deduced by analyzing the force applied on the water-proof dike, and the minimum safety thickness for the water burst section at K5+398 of the Mingyueshan tunnel is cal-culated. The numerical simulation analysis demonstrates the critical thickness of waterproof dike at K5+398 of the Mingyueshan tunnel is 1.4-1.55 m, and the calculated water inflow and water burst basically agree with the actual condition. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Model Test on Grouting Law in Dynamic Water-Rich Sand Layers by the Electric Resistance Method北大核心CSCD

In order to study the diffusion law of grouting slurry in the water-rich sand layer under flowing water conditions, a grouting test model consisting of a main test system, a grouting system, and a measurement system was developed. And for detecting the diffusion scope of the grouts, a new resistivity method was proposed. It is found that the relationship between grouting pressure and grouting rate during the test is strong. Under hydrodynamic conditions, the grouting slurry diffuses elliptically. Due to gravity and the effect of the upper water flow, the center of gravity of the ellipsoid is below the grouting outlet, and the grouting effectively improves the physical and mechanical properties of water-rich sand bodies. At the same time, the resistivity method has a good application effect on the detection of grouting diffusion range. The range of slurry diffusion obtained by the resistivity method is basically consistent with the boundary of the stone body after excavation, indicating that the resistivity method is reliable for detection of grouting range in dynamic water-rich sand layer. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.