非港湾式公交停车对道路交通流的影响分析

公交车进出站点不仅影响本身,也给其他车辆运行带来很大干扰。文章首先比较全面地分析非港湾式公交停车影响下道路交通流特征,然后借助于EXCEL软件,构建关于公交停车频率、公交停车时间、最大公交停车长度及其存在时间、道路流量的车速和车头时距多元线性模型,并进行了严格的数学检验。该研究为合理分析路段交通流状况、正确计算区间行驶车速与车头时距提供了依据。     

柴油机曲轴有限元计算与台架试验数据对比分析

目前，国内柴油机行业普遍使用的曲轴弯曲疲劳强度试验台架，均采用音叉共振板结构。该试验台架对于大多数常规结构曲轴的连杆轴颈圆角疲劳强度的测定是比较准确的，但对于有些特殊结构曲轴的试验，却未能取得理想结果。以某曲轴台架试验、台架仿真模型及有限元计算模型数据为基础，分析对比了不同模型数据的差异及产生原因。     

Experimental and empirical investigations of traffic flow instability

Traffic instability is an important but undesirable feature of traffic flow. This paper reports our experimental and empirical studies on traffic flow instability. We have carried out a large scale experiment to study the car-following behavior in a 51-car-platoon. The experiment has reproduced the phenomena and confirmed the findings in our previous 25-car-platoon experiment, i.e., standard deviation of vehicle speeds increases in a concave way along the platoon. Based on our experimental results, we argue that traffic speed rather than vehicle spacing (or density) might be a better indicator of traffic instability, because vehicles can have different spacing under the same speed. For these drivers, there exists a critical speed between 30 km/h and 40 km/h, above which the standard deviation of car velocity is almost saturated (flat) along the 51-car-platoon, indicating that the traffic flow is likely to be stable. In contrast, below this critical speed, traffic flow is unstable and can lead to the formation of traffic jams. Traffic data from the Nanjing Airport Highway support the experimental observation of existence of a critical speed. Based on these findings, we propose an alternative mechanism of traffic instability: the competition between stochastic factors and the so-called speed adaptation effect, which can better explain the concave growth of speed standard deviation in traffic flow.     

大直径钢管桩承载力恢复过程试验研究

针对目前预制桩承载力恢复特性研究与工程应用中的不足,依托西非某海工工程,提出高应变法。采用对同一钢管桩进行初打与不同休止时间复打相结合的试验方法,研究了大直径钢管桩沉桩后的承载力恢复过程。结合地质情况、沉桩与试验结果,得到了钢管桩承载力、侧阻力及端阻力随时间变化的一般规律及影响因素,并通过静载试验对研究结果进行了验证。该研究在提高项目施工效率、降低成本的同时,还得到了有意义的规律与结论,可为后续类似项目提供参考。     

潜艇均衡系统自流注水调节阀稳态噪声试验研究

本文模拟建立了潜艇均衡系统自流注水试验系统,对不同假海压力、不同系统流量、不同出口背压及串联2台调节阀时自流注水稳定过程振动噪声进行研究。结果表明:潜艇均衡注水振动噪声随着假海深度的增大而增大;空气噪声随流量调节阀开度的增大而增大,在流量调节阀开度为60°-70°之间,振动加速度及水动力噪声产生峰值;在出口背压为0-0.5 MPa之间时,振动噪声值均大于无背压状态,峰值为0.2 MPa;串联2台流量调节阀可大幅降低自流注水振动噪声。     

鱼雷发动机三组元比例控制器数值模拟

利用计算流体力学软件Pumplinx模拟鱼雷发动机中三组元比例控制器的内部流场,分析计算中不同压差情况下对比例控制器性能的影响,以及叶片与定子间间隙大小对于比例控制器性能的影响,同时对不同叶片数目下性能进行对比。计算结果表明:由于比例控制器为被动旋转马达结构,其转速和流量均随时间呈周期性脉动变化,随着工作压差增大,转速脉动幅度基本保持不变,而流量和扭矩脉动幅值增加;随着间隙增大,泄漏量增大,但流量、扭矩、转速脉动幅值大幅降低,出口流量较为平稳;叶片数目增多后比例控制器转速降低、排量降低。由计算结果推断出目前比例控制器的最优叶片数目为4。本文可为进一步研究比例控制器精度问题提供参考。     

超深振捣条件下混凝土墙体模板侧压力的简化计算方法

超深振捣对混凝土成品质量有害无益,研究超深振捣引起模板侧压力增大的规律,可为规避其害提供依据。为此设计4个混凝土墙体试件,实测在浇筑过程中模板侧压力的变化情况。基于振捣液化和液体压力平衡理论,建立了超深振捣情况下混凝土模板侧压力计算模型,推导了计算公式,并与实验数据进行对比验证。研究结果表明,振捣深度是影响混凝土墙体模板侧压力的重要因素,本文提出的计算模型能很好地预测墙体结构超深振捣位置的模板侧压力。     

Continuum theory for pedestrian traffic flow: Local route choice modelling and its implications

This contribution puts forward a novel multi-class continuum model that captures some of the key dynamic features of pedestrian flows. It considers route choice behaviour on both the strategic (pre-trip) and tactical (en-route) level. To achieve this, we put forward a class-specific equilibrium direction relation of the pedestrians, which is governed by two parts: one part describing the global route choice, which is pre-determined based on the expectations of the pedestrians, and one part describing the local route choice, which is a density-gradient dependent term that reflects local adaptations based on prevailing flow conditions.Including the local route choice term in the multi-class model causes first of all dispersion of the flow: pedestrians will move away from high density areas in order to reduce their overall walking costs. Second of all, for the crossing flow and bi-directional flow cases, local route choice causes well known self-organised patterns to emerge (i.e. diagonal stripes and bi-directional lanes). We study under which demand conditions self-organisation occurs and fails, as well as what the impact is of the choices of the different model parameters. In particular, the differences in the weights reflecting the impact of the own and the other classes appear to have a very strong impact on the self-organisation process.     

运梁河特大桥转体梁不平衡重称重试验分析

哈大客专运粮河特大桥跨既有线连续梁采用平转法施工,为确保转体顺利进行,转体前进行了T构不平衡重试验分析,文中介绍了一种转体构件不平衡重的测试方法和应用过程。结果表明,方法有效可行,可供同类工程借鉴。     

STX1(2)型驮背多功能运输车超偏载检测标准

分析了STX₁₍₂)型驮背多功能运输车对既有超偏载检测方法和标准的适应性,提出了该车的超偏载检测方案,明确了公路货车或半挂车超偏载的检测方法及评判标准。