喷撒颗粒的增粘机理研究

本文建立了向轮轨接触间喷撒颗粒时的摩擦模型，并将此摩擦模型应用于修正的轮轨粘着理论中，对喷撒颗粒的增粘机理进行了理论研究。从理论计算结果可以看出，向轮轨接触间喷撒颗粒的增粘效果是非常明显的，且增粘效果和轮轨的表面状态、颗粒的质量和进入轮轨接触面间的颗粒数量有关。     

车身外形CAGD中磨光三角域曲面的计算和应用

三角域曲面设计一直是车身表面造型的难点。本文建立了磨光型三角域自由 曲面的计算模型，开发了软件，通过实际设计实例证明该方法光顺性好，计算稳定，效率高。     

软土地基水平受荷桩基础力学性能研究

通过国内不同规范和文献的对比研究以及工程实例分析,建议以桩基地面水平位移达到6 mm的水平荷载作为桩基横轴向容许承载力,或者采用建筑桩基规范桩基水平承载力公式估算。考虑到软土地基桩土作用非线性的特点,引入了NL法对水平受荷桩内力和变形进行分析,建立了软土地基桩基在水平荷载作用下的精确分析方法;在相同的水平荷载作用下,采用m法计算的水平受荷桩变形值和内力值要比采用NL法计算的数值分别增大150%、15%左右,采用m法进行水平受荷桩设计时偏于保守。     

电力机车二系橡胶堆旁承横向刚度计算方法的研究

阐述了机车橡胶堆旁承横向刚度计算的基本原理，提出了一种新的计算方法，并经过了实验验证，另外还分析了影响计算准确性的主要因素。     

A local model for the simulation of two–dimensional spilling breaking waves

A numerical model for the simulation of two dimensional spilling breaking waves is described. It is derived from a previous model which, in turn, takes its underlying ideas from the Cointe and Tulin theory of steady breakers. With respect to the former model, the present one is local, i.e., the inception, extension, and geometry of the breakers are determined through the local shape of the water surface. The model has been implemented in a RANSE code, which was developed for the simulation of ship flows, through a modification in the boundary conditions. This yields a simple and effective way to reproduce the breakers influence on the underlying flow. The resulting code has been used to simulate the flow past a submerged hydrofoil. The numerical results are compared with those of the previous model and with the experimental data obtained by Duncan.     

船体三维网格的自动生成算法及其图形用户界面的设计

本文介绍的三维湿表面网格的自动生成算法,不但可完成型值表各站型线的等弧长插值拟合,而且能够在沿船长方向的任意位置上进行站的加密和插值,从而自动生成三维湿表面网格。该算法的实现依赖于一套完整的图、形用户界面。此界面用Ｕｎｉｘ平台的Ｍｏｔｉｆ、Ｃ和ＧＬ编制,友好灵活,方便易用。     

Fault tolerant nonlinear control with applications to an automated transit bus

This paper presents an integrated structure for a passive and active fault tolerant control (FTC) design approach in the framework of a robust nonlinear control technique called Dynamic Surface Control (DSC). As motivated by the automated vehicle application, we consider two categories of possible faults: pre-specified (a priori) and non-specified faults. It is first shown that DSC can be considered as a passive FTC approach in the sense that it gives simultaneous robust stability to a set of nonlinear systems even in the presence of model uncertainties and the pre-specified faults. Then, the non-specified fault is classified depending on the fault’s impact on the closed-loop system and isolatability from a fault detection and diagnosis (FDD) system. If a fault is both intolerable and isolatable, an active FTC approach is taken which includes FDD and controller reconfiguration. More specifically, trajectory reconfiguration is considered to accommodate the actuator fault, i.e., to compensate for the performance loss due to the fault within the framework of a switched hierarchical structure. Finally, the integrated structure for the longitudinal control of an automated transit bus is designed through the proposed method. Simulation results of the fault tolerant controller are shown for both single and multiple multiplicative faults. This controller was implemented on the California PATH transit buses in a demonstration of automated public transportation technology in San Diego, California in August of 2003.     

高速公路面层出现裂缝的原因与预防措施

通过对河北省高速公路路面屡次出现裂缝的现象进行调查分析,并结合秦皇岛市京沈高速公路大修工程的实践,综合分析了路面产生裂缝的主要原因,并提出有效防治裂缝产生的措施和建议.     

存轨基地地基加固及安全分析

京沪高速铁路某铺轨基地,地基承载力不足,且部分地方存在软弱土夹层,而钢轨的平顺性要求又较高。为了满足刚度和强度要求,采用CFG桩对该地基进行了地基处理。给出了CFG桩的地基处理方案,计算了复合地基承载力和各台座处的沉降值,对强度和刚度进行了验算,各方面均满足要求。可为同类工程提供参考。     

回填土区深层搅拌桩和高压旋喷桩复合地基的静承载性能

结合实际工程现场静载试验,采用有限元计算方法研究了桩长和桩土模量比对深层搅拌桩和高压旋喷桩复合地基在回填土中的桩体承载特性、荷载传递及复合地基变形特性的影响。结果表明,在回填土区,深层搅拌桩以桩体上部破坏为主,增加桩长不能有效地提高复合地基承载力,增加桩体强度尤其是上部桩体的强度则能够较大地提高复合地基承载力,高压旋喷桩可有效增强回填土地基的承载力。提出的桩体弹性模量取值范围可供设计参考。