拟合坐标下河道二维非恒定流计算

本文通过边界贴体坐标,在物理域生成正交曲线网格。该曲线网格具有准确贴合边界及域内网格布置灵活的特点,克服了矩形网格贴合边界较差及计算域长宽比悬殊的困难。通过坐标转换,将复杂域问题转变成规则长方形域问题的求解,并对新坐标系下的方程采用ADI方法进行数值模拟计算。     

外高桥新港区顺岸码头工程水环境质量影响预测数学模型

本文在外高桥顺岸码头工程水环境现状评价的基础上,采用沿水深积分平均的二维水流水质数学模型,结合一定的定解条件,建立了预测该项工程对周围水环境影响的水质数学模型。采用ADI数值计算方法离散控制方程,考虑到顺岸码头下游3km的上海合流污水竹园排放口工程,预测计算工程建成后产生的污染源对评价区水域的水质影响。计算时,主要讨论了化学耗氧量(COD_(Mn))的浓度增量。本模型也可以推广应用于其他河口、海岸流场和浓度场的计算预测研究。     

一种新的诊断线性模拟电路参数故障的方法

提出一种检测线性模拟电路参数单故障的新方法。该方法首先采用一种简单的转化程序将待测线性模拟电路转化为离散信号流图,再依照故障模型生成多个诊断求值器,最后根据数字仿真过程中求值器的输出值判定原电路的参数故障。这种方法效率较高,可以节省不少计算时间,后面通过一个例子证明其有效性。     

加筋板的双重非线性分析

本文综合工程实际的需要,对船体加筋板结构进行了双重非线性有限元分析。采用Prandtl-Reuss流动理论,具体导出了加筋板在双重非线性状态下理想弹-塑性和强化材料的单元刚度矩阵;用增量切线刚度法-迭代法相结合的混合解法来提高求解精度;对单剛、等效节点力的计算,均采用Gauss积分法和进行分层精度判别来节约机时和内存。     

铸造接尘工人最大呼气流速容量曲线的分析

对１４７名男性不吸烟铸造接尘工人及２９７名男性不吸烟对照工人进行了肺功能检测及呼吸系统症状的询问调查，并进行了最大呼气流速容量曲线的分析。结果表明，接尘组肺功能（Ｖ８７．５、Ｖ７５、Ｖ５０）显著低于对照组，呼吸系统症状阳性率显著高于对照组。最大呼气流速容量曲线接尘组显著低于对照组。提示铸造粉尘确能引起接尘工人呼吸系统的损害，应引起重视。     

丁坝错口距离的最优值、极限值研究

丁坝的布置方法直接影响到工程的效果,其关键是利用丁坝的坝后回流区。本文通过理论分析和水槽实验,提出了两岸丁坝在适当错口布置时整治范围增大的看法。获得了错口距离的最优值、极限值。错口坝的回流长度与宽度,回流与主流的分界边线的计算公式,计算结果与实验值吻合较好。     

锚泊时船舶放链长度的确定及其实用图表

本文给出了船舶锚泊时所受到的风作用力、水作用力和放出锚链长度的计算公式,以及实用数表和曲线图,可供查取。数表和曲线是根据文中确定的如下关系式编绘:L_b≈1/2Ln;L≈1.5L。(其中L_b——卧底锚链长度;L_n——悬垂锚链长度;L——放出锚链总长度)。十一例实船计算表明,根据上式计算结果,与目前国内外通用的方法确定的放链长度相符。利用这些数表和曲线图,既可合理地确定不同海况下船舶所应放出的锚链长度,也可减少起锚时的功率消耗和缩短起锚时间。     

Studies on the optimization of stern hull form based on a potential flow solver

A hypothesis of the minimum energy of secondary flow, suggested by Bessho, is introduced here. According to this hypothesis, it can be expected that hull forms having frame lines with a minimum energy of secondary flow show less form drag. In the first part of this article, secondary flow energy is evaluated for the cases with and without a free-surface effect, and Bessho’s hypothesis is confirmed for practical hull forms. Then optimization methods for the stern hull form are suggested, in which a nonlinear optimization technique is introduced. Numerical examples are given for a practical tanker hull form and a practical container hull form. From these studies, the suggested optimization method can be confirmed as a simplified and practical design method to the select frame lines of stern hull forms.     

The interaction of tidal advection, diffusion and mussel filtration in a tidal channel

Time series measurements of flow and pigment concentrations (Chl) in the Menai Strait have revealed that the strong residual flow in a tidal channel ( 500 m³ s^− 1) transports phytoplankton from the open sea into the channel where much of it is consumed by suspension feeders, mainly in commercial beds of Mytilus edulis. The progressive depletion of phytoplankton along the channel results in a strong horizontal gradient of plankton and hence Chl. Tidal displacement of this gradient causes large (± 50% of mean) oscillations of Chl in the vicinity of the mussel beds. Vertical mixing by the strong tidal flows is sufficiently vigorous for most of the tidal cycle to ensure that downward diffusion can resupply the near-bed layer although there are indications of some transient depletion around slack water.This paradigm of the interaction of advection, diffusion and filtration determining the distribution of plankton and its supply to mussels has been encapsulated in a series of simple models forced only by boundary values. In the first, a 1-D model of tidal flow in the channel reproduces the principal features of the observed currents including the unusually large spatial change in phase of the currents and the variation of the residual transport with tidal range. The flow field from this physical model is used to drive a second model based on the advection diffusion equation for Chl with a source at the Irish Sea boundary and a sink over the mussel bed. This model illustrates the formation of a strong Chl gradient along the channel and simulates the amplitude and phase of the M₂ oscillations of Chl and the development of the M₄ variation apparent in the observations. This second model has been extended to 2-D over the mussel beds to allow investigation of the effects of water column mixing. The model indicates that only for a short period ( 30 min), close to slack water, is mixing sufficiently reduced to permit the development of a depletion boundary layer and then only within  1 m from the bottom, a result which is consistent with the observations.     

船用柴油机排气冷却降噪装置性能仿真与实验研究

在特定情况下,船用大功率柴油机排气温度和噪声会受到严格限制,为解决这一问题,考虑在柴油机后安装冷却降噪装置.现应用湍流气粒两相流动的计算流体力学理论,对冷却降噪装置的冷却效果及阻力特性进行仿真计算,计算结果和试验吻合较好.