立交隧道相互作用三维数值模拟与实测对比研究

以温福铁路琯头岭隧道下穿同三高速公路隧道为例,研究新建下穿隧道与既有隧道工程之间相互影响的问题。采用ANSYS有限元软件,模拟上覆公路隧道和下穿铁路隧道的位移和应力变化情况,并与现场监控量测结果对比,得到以下结果:下穿隧道拱顶沉降量较小,水平收敛值较大,下穿隧道立交段拱腰和边墙是需要重点支护的对象;上覆隧道在立交段下沉值变大,变化幅度为仰拱边墙拱腰拱顶,隧道中部和下部水平收敛值变化较大;受下穿隧道开挖影响,立交隧道上覆地层受力产生不均匀变化,造成扭矩存在,地面水平位移整体呈现"8"字形,立交隧道的建设对地层产生了较大的转动扰动。     

薄基岩顶板隧道爆破施工围岩稳定性分析

为更有效地进行薄基岩顶板条件下隧道施工安全控制,以某高速公路隧道为工程背景,运用数值模拟的方法,分别研究不同顶板厚度下隧道爆破施工引起的围岩振速分布特征及其对围岩的损伤情况,并进行围岩稳定性分析。结果表明:1)当顶板厚度在5 m及以上时,围岩是稳定的;2)当顶板厚度为3 m时,最危险横断面上基岩顶板内开始产生严重的拉伸裂缝及一些径向裂缝,将形成超挖;3)当顶板厚度≤2 m时,径向裂缝贯穿顶板岩体,围岩稳定性较差,在掌子面后1 m内可能发生塌落、掉块等事故。     

城市地下道路分(合)流匝道通风阻力特性

为分析多点进出结构的城市地下道路空气流动特性,以长沙市营盘路湘江隧道为原型,通过现场实测、缩尺模型试验以及CFD软件数值模拟方法,对分(合)匝道通风阻力特性进行了研究,考察了雷诺数、风量比、分岔角度对分(合)流匝道阻力特性的影响规律。研究结果表明:1)主隧道与匝道风量比、主隧道与匝道夹角是影响分(合)流匝道局部阻力系数的关键因素;2)城市地下道路分(合)流匝道局部阻力变化特性,不宜简单套用通风管道的三通构件的参数;3)结合最小二乘法和Matlab软件对计算结果进行多因素回归分析,给出了基于长沙营盘路湘江隧道的分(合)流匝道主隧道和匝道的局部阻力系数关联式。研究结果可为复杂结构城市地下道路通风系统阻力特性分析及通风工程优化设计提供方法参考。     

水中悬浮隧道交通荷载模拟方法研究

为研究水中悬浮隧道交通荷载的合理模拟方法以及交通荷载对隧道结构的影响,借鉴铁路、公路交通荷载的模拟方法,综合考虑车辆轮载、路面不平度、行车速度以及外部激励荷载等影响因素的共同作用,提出水中悬浮隧道交通荷载的模拟表达式。通过数值模拟计算,分析悬浮隧道交通荷载的变化特征,并研究不同交通荷载模拟方法对悬浮隧道结构振动位移响应的影响。结果表明:文章提出的交通荷载模拟方法计算结果符合移动振动荷载的波动性和周期性特征。在对结构振动位移响应影响方面,固定均布荷载相当于静载,移动集中荷载和移动振动荷载时的位移变化幅值相对固定均布荷载时的大且影响相似,但移动振动荷载时的振幅稍大,体现了交通荷载中动荷载部分对结构振动位移响应的影响,更适合用来模拟悬浮隧道中的交通荷载。     

Modelling,simulation and applications of longitudinal train dynamics

ABSTRACT

Significant developments in longitudinal train simulation and an overview of the approaches to train models and modelling vehicle force inputs are firstly presented. The most important modelling task, that of the wagon connection, consisting of energy absorption devices such as draft gears and buffers, draw gear stiffness, coupler slack and structural stiffness is then presented. Detailed attention is given to the modelling approaches for friction wedge damped and polymer draft gears. A significant issue in longitudinal train dynamics is the modelling and calculation of the input forces – the co-dimensional problem. The need to push traction performances higher has led to research and improvement in the accuracy of traction modelling which is discussed. A co-simulation method that combines longitudinal train simulation, locomotive traction control and locomotive vehicle dynamics is presented. The modelling of other forces, braking propulsion resistance, curve drag and grade forces are also discussed. As extensions to conventional longitudinal train dynamics, lateral forces and coupler impacts are examined in regards to interaction with wagon lateral and vertical dynamics. Various applications of longitudinal train dynamics are then presented. As an alternative to the tradition single wagon mass approach to longitudinal train dynamics, an example incorporating fully detailed wagon dynamics is presented for a crash analysis problem. Further applications of starting traction, air braking, distributed power, energy analysis and tippler operation are also presented.     

Vehicle lift-off modelling and a new rollover detection criterion

The modelling and development of a general criterion for the prediction of rollover threshold is the main purpose of this work. Vehicle dynamics models after the wheels lift-off and when the vehicle moves on the two wheels are derived and the governing equations are used to develop the rollover threshold. These models include the properties of the suspension and steering systems. In order to study the stability of motion, the steady-state solutions of the equations of motion are carried out. Based on the stability analyses, a new relation is obtained for the rollover threshold in terms of measurable response parameters. The presented criterion predicts the best time for the prevention of the vehicle rollover by applying a correcting moment. It is shown that the introduced threshold of vehicle rollover is a proper state of vehicle motion that is best for stabilising the vehicle with a low energy requirement.     

超高压共轨系统轨压控制策略研究

为稳定控制超高压共轨系统中的共轨腔压力并缩短轨压控制算法的开发周期,利用AMESim/Simulink联合仿真技术建立了超高压共轨系统轨压控制仿真模型,采取前馈+PID控制算法设计了轨压控制策略,并针对轨压控制中的瞬态和稳态工况进行了仿真计算,最后在试验台架上开展了轨压跟随性测试。结果表明:所制定的前馈+PID控制算法能使轨压稳定在目标轨压附近,上下波动小于3 MPa,且轨压突变时瞬态响应时间小于0.5s,控制结果能够满足超高压共轨系统对精度和速度的需求。     

基于一维-三维耦合仿真的进气系统优化方法

提出了基于一维-三维耦合仿真的进气系统优化方法,此方法兼具CFD对进气系统三维流动特性准确描述与一维仿真对内燃机进气系统全局控制的优点。建立了进气歧管三维模型,采用GT-Power软件进行缸内工作过程模型仿真,根据试验数据标定仿真模型。通过一维-三维耦合仿真计算得到进气歧管各转速下的流动参数,以此作为CFD仿真的边界条件,优化进气歧管的结构参数。通过整机试验对进气歧管流动性能进行了验证。试验结果表明,该方法能够较好地指导进气歧管设计。     

侧压力系数与非同步开挖对分离式隧道影响研究

使用有限元方法进行了一系列的计算分析,探讨不同侧压力系数对分离式隧道左、右洞不同步开挖时两洞间的影响程度,并通过现场动态监控量测来验证数值模拟的正确性。结果表明：侧压力系数越大相邻隧道的影响程度越大。     

基于系统集成理论的城市道路景观设计

在我国城市道路景观实践过程中,由于建造时序的不同,城市道路的“景观破碎、缺乏集成”和“豪华奢侈、脱离实际”,不利于城市系统的和谐发展。鉴于此,本文在深入分析城市道路景观建设目标的基础上,独辟蹊径从系统范畴的角度探讨了一种“集成”的道路景观设计理念,为城市道路景观的建设提供了一个新的思路。