浅埋顶管沉井周边土体的三维破坏形状及沉降研究

为研究顶管沉井及周边土体在顶进力作用下的形变范围与大小，以加固旋喷桩作为沉井周围加固体建立ABAQUS软件计算模型，并将模拟结果与工程实例、PLAXIS 3D软件所得结果进行对比分析。同时，采用广州地区花岗岩残积土进行室内沉井模型试验，并通过试验结果对数值模拟结论进行验证，得出结论如下： 1）在开挖基坑前达到设计强度的旋喷桩能有效减小基坑周边土体塌陷变形、坑底隆起。2）在施加工作顶推力下，前侧主动区首先出现贯通裂缝，竖向位移斜率增大出现明显拐点；继续增大顶推力，土体位移会急剧增大导致地表沉降严重。3）对于后背土体，在顶推力作用下，地表破裂线的切线角度从0°逐渐增大至45°+φ/2，导致破裂范围也不断扩大；达到45°+φ/2处后，继续施加顶推力会导致短轴方向破坏范围扩大的速度较长轴方向的速度更快；三维空间中被动区破坏土体在地表处产生形状为椭圆的破坏面，椭圆长轴方向为顶推轴线方向，被动破坏体呈现为牛角状椭圆楔体。     

公路工程的水土保持生态补偿

就公路工程中所遇到的环境问题,结合设计施工中的解决办法,阐述公路工程的水土保持生态补偿,从而减小因道路施工给沿线自然地形、地貌造成的各种破坏,保护和改善当地环境,提高公路的使用效果,更好地发挥公路的各项功能。     

基于硬化泥膜的填舱换刀技术研究

为了解决砂土地层盾构刀盘换刀作业面易涌水、涌砂进而导致作业面失稳坍塌问题,采用水泥砂浆和膨润土浆液组成的混合浆液在土舱压力作用下,通过刀盘开口向砂土地层渗透,经固化后在原有稳定泥膜的基础上形成新型混合泥膜,在利用风镐清除土舱内硬化混合浆液的同时,保留刀盘前段形成的混合泥膜,即可进行盾构刀盘换刀作业。通过在广州某地铁盾构施工项目中的应用,表明本施工技术能为砂土地层盾构换刀提供高效且安全的解决方案。     

土压平衡盾构施工中泡沫改良砾砂土的试验研究

为了解决土压平衡盾构在砾砂土地层掘进过程中,土体塑流性差、刀盘及螺旋输送机磨损严重和开挖面平衡不易保持等问题,通过自制泡沫发生器发泡,对砾砂土地层的泡沫改良技术进行室内试验研究,分析气液比、含水率和泡沫掺量对塑流性的影响和改良前后土样的渗透系数的变化规律,得出泡沫发生器气液比在30∶1~55∶1、含水率为5%~12.5%、泡沫掺量为20%~40%时,土体具有较好的塑流性,泡沫的"轴承效应"和泡沫剂中表面活性剂的亲水基团与水、砾砂土颗粒形成的氢键是塑流性提高的根本原因;使用泡沫剂改良砾砂土后,渗透系数大幅降低,掺泡沫后在280 min内渗透系数随时间变化较小,能达到10~(-5)cm/s,泡沫剂溶液中高分子化合物的联结和液桥力是土样具有堵水作用的原因。     

A signal-based fault detection and classification method for heavy haul wagons

This paper proposes a signal-based fault detection and isolation (FDI) system for heavy haul wagons considering the special requirements of low cost and robustness. The sensor network of the proposed system consists of just two accelerometers mounted on the front left and rear right of the carbody. Seven fault indicators (FIs) are proposed based on the cross-correlation analyses of the sensor-collected acceleration signals. Bolster spring fault conditions are focused on in this paper, including two different levels (small faults and moderate faults) and two locations (faults in the left and right bolster springs of the first bogie). A fully detailed dynamic model of a typical 40t axle load heavy haul wagon is developed to evaluate the deterioration of dynamic behaviour under proposed fault conditions and demonstrate the detectability of the proposed FDI method. Even though the fault conditions considered in this paper did not deteriorate the wagon dynamic behaviour dramatically, the proposed FIs show great sensitivity to the bolster spring faults. The most effective and efficient FIs are chosen for fault detection and classification. Analysis results indicate that it is possible to detect changes in bolster stiffness of ±25% and identify the fault location.     

Influence of AC system design on the realisation of tractive efforts by high adhesion locomotives

The main task for heavy haul railway operators is to reduce the cost of exported minerals and enhance the long-term viability of rail transport operations through increasing productivity by running longer and heavier trains. The common opinion is that this is achievable by means of implementation of high adhesion locomotives with advanced AC traction technologies. Modern AC high adhesion locomotives are very complex mechatronic systems and can be designed with two alternative traction topologies of either bogie or individual axle controls. This paper describes a modelling approach for these two types of AC traction systems with the application of an advanced co-simulation methodology, where an electrical system and a traction algorithm are modelled in Matlab/Simulink, and a mechanical system is modelled in a multibody software package. Although the paper concentrates on the analysis of the functioning for these two types of traction control systems, the choice of reference slip values also has an influence on the performance of both systems. All these design variations and issues have been simulated for various adhesion conditions at the wheel–rail interface and their influence on the high traction performance of a locomotive equipped with two three-axle bogies has been discussed.     

水泥土掺石膏的室内试验研究

针对掺加石膏以及不加添加剂的水泥土,利用现场的淤泥质土作为养护环境,进行3种不同水泥的室内7、28和90d的无侧限抗压强度试验。室内试验研究结果表明：龄期是影响水泥土试块强度的主要因素之一;添加剂石膏在水泥掺量一定情况下,主要起到早强和减水的作用。     

沿海公路反开挖施工中的若干问题

对软土路基的反开挖问题进行了探讨,提出了开挖时间的确定,并论述了基底承载力大小以及反开挖施工合理性问题.     

强夯置换法处理滨海公路软土路基

结合辽宁省滨海公路庄河市大张至中隈段的土质情况,阐述了强夯处理软土地基的设计方法、施工过程及处理后的地基效果.     

浅谈软土泥沼地基的处理方法

介绍了软土及泥沼地基处理方法,有换土垫层法、强夯法、侧向约束法、土工织物加固法、排水固结法、综合处理方法的机理和适用范围。