Experimental study on seismic vibration control of an offshore wind turbine with TMD considering soil liquefaction effect

Wind energy is clean and sustainable. Taiwan is establishing offshore wind farms using wind turbines in the Taiwan Strait. However, these are located in an earthquake-prone area with sandy seabed conditions. To ensure their safety and reliability, the turbines’ support structure must be protected against wind, waves, and seismic loads. Tuned mass dampers (TMDs) are commonly employed to reduce structural vibrations. A TMD is more simply incorporated into turbine structures than are other energy dissipation devices. In this study, a 1:25-scale test model with a TMD was constructed and subjected to shaking table tests to experimentally simulate the dynamic behavior of a typical 5-MW wind turbine with a jacket-type support structure and pile foundation. The scaled-down wind turbine model has a nacelle without rotating blades; therefore, the aerodynamic and rotational effects due to the rotating blades were ignored in this study. A large laminar shear box filled with saturated sandy ground was used to simulate the typical seabed conditions of Taiwanese offshore wind farms. The TMD system was designed to be tuned the first-mode frequency of the test model. Two ground accelerations, selected by considering wind farm site condition and near-fault characteristics, were used for excitation in the test. The responses of the test model with and without the TMD system were compared, and the influence of soil liquefaction on the effectiveness of TMD vibration control was addressed.     

柴油机增压器包覆层隔声性能试验分析及优化设计

提出一种船用增压器的包覆层结构,其内层为绝热材料和吸声材料,外层为金属薄片。采用统计能量法(SEA)建立该结构的中高频段隔声数值模型,开展包覆层的隔声试验,隔声量实测值与仿真结果吻合较好,能验证数值建模的有效性。对包覆层的吸声材料的厚度、密度和流阻等参数进行优化设计,利用正交试验法设计数值试验组,采用极差和方差分析法分析影响材料隔声性能的关键因素,得出最重要的影响因素是材料厚度,在选型设计中还应考虑密度和流阻因素。当安装厚度受限时,可通过改变密度和流阻值来提高材料的隔声量。     

盾构隧道管片接头缩尺试验模拟方法

由于盾构隧道管片接头刚度影响因素繁多复杂，使得缩尺模型管片接头制作困难、模拟效果较差。为此，提出一种采用特制弹簧与预埋螺栓共同工作的管片接头模拟方法来模拟原型管片接头，并分别对该方法设计的模型管片接头以及原型管片螺栓连接接头的轴向、剪切及弯曲刚度进行计算分析。通过对比分析可以得出设计管片模型接头与原型管片螺栓连接接头的等效条件，在满足上述等效条件的情况下，经相似关系换算可认为缩尺模型管片接头刚度与原型管片接头刚度满足试验设定的相似关系。最后，采用堆载试验对模型管片进行可行性验证。经理论分析及模型试验表明： 提出的盾构隧道管片接头缩尺试验模拟方法可使模型接头刚度等效于原型管片接头，能较为全面地满足模拟原型管片的要求。     

中国乘用车工况构建

依托“中国工况”项目，对我国乘用车行驶工况进行深入研究. 在全国41 个城市采集乘用车共计1 600 万km的行驶数据，收集各城市交通量大数据用于权重因子开发；利用权重因子对采集数据进行加权，获取代表我国驾驶特征的、统一的速度-加速度分布，以其为基准，使用卡方检验选择最优短片段组合作为我国乘用车行驶工况(CLTC). 对比CLTC工况特征与其他典型工况及实测数据GIS加权结果，CLTC工况更符合我国实际.     

单叶片螺旋钢桩竖向承载特性数值分析

为分析单叶片螺旋钢桩在砂土地层竖向抗压承载特征,结合单叶片螺旋钢桩现场静载试验进行有限元软件模拟。将数值计算结果与现场实测数据进行对比分析,验证其数值计算结果的可靠性,其次采用该有限元软件分别模拟不同相对密实度砂土中几何参数不同的单叶片螺旋钢桩静载试验而得到不同荷载-位移曲线,同时将螺旋叶片直径的5%位移值对应荷载作为桩极限承载力。考虑砂土相对密实度,钢桩埋深,螺旋叶片直径,中心钢轴4个参数变化对单叶片螺旋钢桩极限承载力影响。结果表明:单叶片螺旋钢桩桩周土层的相对密实度和桩埋深是影响承载力的主要参数,螺旋钢桩叶片直径影响次之,钢轴直径的影响最小;同时,单叶片螺旋钢桩极限承载力增量百分比在松砂中最大,中密砂次之,密砂最小。     

A practice-ready relocation model for free-floating carsharing systems with electric vehicles – Mesoscopic approach and field trial results

This paper introduces a relocation model for free-floating Carsharing (FFCS) systems with conventional and electric vehicles (EVs). In case of imbalances caused by one-way trips, the approach recommends profit maximizing vehicle relocations. Unlike existing approaches, two types of relocations are distinguished: inter zone relocations moving vehicles between defined macroscopic zones of the operating area and intra zone relocations moving vehicles within such zones. Relocations are combined with the unplugging and recharging of EVs and the refueling of conventional vehicles. In addition, remaining pure service trips are suggested. A historical data analysis and zone categorization module enables the calculation of target vehicle distributions. Unlike existing approaches, macroscopic optimization steps are supplemented by microscopic rule-based steps. This enables relocation recommendations on the individual vehicle level with the exact GPS coordinates of the relocation end positions. The approach is practice-ready with low computational times even for large-scale scenarios.To assess the impact of relocations on the system’s operation, the model is applied to a FFCS system in Munich, Germany within three real world field tests. Test three shows the highest degree of automation and represents the final version of the model. Its evaluation shows very promising results. Most importantly, the profit is increased by 5.8% and the sales per vehicle by up to 10%. The mean idle time per trip end is decreased by 4%.     

新型化学固沙剂的试验研究

研制了以聚乙烯醇(PVA)为原料的化学固沙剂,并对其进行了试验研究,结果表明它具有良好的固沙性能。最后分析了该固沙剂的固化机理。     

μ-和δ-阿片受体参与介导丘脑中央下核内吗啡诱发的抗伤害感受效应(英文)

目的研究μ-和δ-阿片受体在介导丘脑中央下核(Sm)内阿片诱发的抗伤害感受效应中的作用。方法用自动检测系统记录大鼠爪底皮下注射福尔马林诱发的伤害性行为,观察Sm内微量注射吗啡和选择性μ-和δ-阿片受体拮抗剂对伤害性行为的效应。结果吗啡(31 mmol/L,0.5μL)明显抑制福尔马林诱发的伤害性行为,这种效应可被μ-阿片受体拮抗剂-βfunaltrexamine(-βFNA,0.4 mmol/L,0.5μL)和naloxonazine(0.8 mmol/L,0.5μL)阻断,部分地被δ-受体拮抗剂naltrindole(0.4 mmol/L,0.5μL)阻断。结论Sm内注射吗啡诱发的抗伤害感受效应主要由μ-阿片受体介导,部分地由δ-受体介导。     

船舶电站模拟器的信号采集

介绍了船舶仿真电站中模拟量和开关量统一输入的一种实现原理,并简要说明输入通道与计算机间的信息交换过程.     

行标《水平涂层逆反射亮度系数测试方法》的研究

<水平涂层逆反射亮度系数测试方法>是一个真正意义上的路面水平涂层的逆反射性能的测试方法,它的颁布为国内系统完整地开展路面水平涂层的逆反射性能研究打下了基础.