Modeling the impacts of mandatory and discretionary lane-changing maneuvers

In this paper, a novel mesoscopic multilane model is proposed to enable simultaneous simulation of mandatory and discretionary lane-changing behaviors to realistically capture multilane traffic dynamics. The model considers lane specific fundamental diagrams to simulate dynamic heterogeneous lane flow distributions on expressways. Moreover, different priority levels are identified according to different lane-changing motivations and the corresponding levels of urgency. Then, an algorithm is proposed to estimate the dynamic mandatory and discretionary lane-changing demands. Finally, the lane flow propagation is defined by the reaction law of the demand–supply functions, which can be regarded as an extension of the Incremental-Transfer and/or Priority Incremental-Transfer principles. The proposed mesoscopic multilane cell transmission model is calibrated and validated on a complex weaving section of the State Route 241 freeway in Orange County, California, showing both the positive and negative impact of lane changing maneuvers, e.g., balancing effect and capacity drop, respectively. Moreover, the empirical study verifies that the model requires no additional data other than the cell transmission model does. Thus, the proposed model can be deployed as a simple simulation tool for accessing dynamic mesoscopic multilane traffic state from data available to most management centers, and also the potential application in predicting the impact of traffic incident or lane control strategy.     

A capacity maximization scheme for intersection management with automated vehicles

With the advent of connected and automated vehicle technology, in this paper, we propose an innovative intersection operation scheme named as MCross: Maximum Capacity inteRsection Operation Scheme with Signals. This new scheme maximizes intersection capacity by utilizing all lanes of a road simultaneously. Lane assignment and green durations are dynamically optimized by solving a multi-objective mixed-integer non-linear programming problem. The demand conditions under which full capacity can be achieved in MCross are derived analytically. Numerical examples show that MCross can almost double the intersection capacity (increase by as high as 99.51% in comparison to that in conventional signal operation scheme).     

鱼雷定深航行稳定性的分叉分析

鱼雷定深运动方程含有诸多的非线性项，用传统的分析方法对其稳定性进行研究有较大难度。运用非线性科学中的分叉理论，选定鱼雷定深运动方程中的某一流体动力系数扰动值为分叉参数，系统地分析在经典比例微分深度控制系统作用下，鱼雷在退化平衡点处的航行稳定性。利用中心流形定理，推导出系统状态变量解析表达式，对系统 Hopf分叉进行分析，并进行仿真验证。结果表明，流体动力系数变化使定深航行产生 Hopf分叉，并给出了确保鱼雷稳定航行的流体动力参数取值范围。     

基于FLAC软件模拟强夯加固吹填砂地基

基于港区陆域吹填项目,采用FLAC软件建立三维模型,模拟了不同夯能、夯击次数对强夯效果的影响,对强夯前后杨氏模量的变化进行了分析研究。结果表明,表层吹填砂厚度和下卧软土层分布对夯能的大小起着决定作用。对于下卧松散砂层,可适当加大夯击能量和夯击次数(7~8击),增加其处理深度和效果;而对于下卧软黏土层,可以适当减小夯击能量并增加夯击次数,以提高加固效果。夯击之后,表层吹填砂的杨氏模量有较大的提高,从原来的10 MPa提高到20~40 MPa。     

高速路网不停车收费车道优化布设方法

合理设置高速公路收费站ETC (Electronic Toll Collection)车道数量，对高速公路通行效率至关重要。针对目前路网中ETC与MTC (Manual Toll Collection)车辆混行的情况，考虑ETC的普及率，结合多用户路网均衡模型和排队论方法，建立基于双层规划模型的高速路网ETC车道优化布设方法。上层模型以车辆总通行时间最小为目标，优化设置进出收费站的ETC车道数量；下层模型为多用户路网均衡模型，反映ETC和MTC车辆的路径和收费车道选择行为。下层模型通过设计收费站的等价拓扑结构，表征收费站的车道使用规则及车辆的收费车道选择行为，并采用排队论方法估计ETC和MTC车道的收费排队时间。根据模型的特点设计了基于主动集的启发式算法，利用参数二进制与拉格朗日函数法确定迭代下降方向，解决了下降方向与步长难以计算的问题；通过内嵌优化函数的方式，保证在主动集转化过程中上层约束均不会失效，且避免了迭代过程中的模型解退化问题。基于上海市绕城高速进行实证分析，结果表明：随着ETC普及率的提升，收费排队时长按照负指数趋势下降；与按比例布设ETC车道的方法相比，所提方法最高可降低57.4%的收费排队时间，且该方法可以避免ETC车道布设过多对于MTC车道通行能力挤压造成的负面效果。研究成果可以有效指导高速路网ETC车道的布设，提高路网通行效率。     

A proposed vision and vehicle-to-infrastructure communication-based vehicle positioning approach

It is essential to obtain accurate location of vehicles for new applications of Intelligent Transportation Systems. To remedy the defects of present Global Positioning System and vehicle-to-infrastructure (V-I) positioning technology, a new positioning approach based on vision and V-I communication is proposed. This approach aims at lane-level positioning with lower cost than conventional ones. In this approach, the position of the vehicle is represented by its lateral position (the lane number) and longitudinal position (the distance from entrance of the road) in a course coordinate system along the road; the specific lane the vehicle is occupying (the lane number) can be judged using the information of lane lines detected by vision systems; then the distance to the vehicle is obtained by a Road Side Unit (RSU) during the V-I communication; and the longitudinal position is calculated. The error of the approach on typical operating conditions is analyzed, indicating that the new approach can achieve the accuracy of less than 0.31 m for straight road and 0.58 m for typical arc road with ultra-wideband communication and ranging technologies and rational arrangement of RSUs. The feasibility of this approach is presented.     

Effectiveness of travel time reliability indicators in the light of the assessment of dynamic managed lane strategy

ABSTRACT

The aim of traffic management is to ensure a high quality of service for a maximum number of users by decreasing congestion and increasing safety. Uncertainty of travel times decreases the quality of service and leads end users to modify their plans regardless of the average travel time. Indicators describing travel time reliability are being developed and should be used in the future both for the optimization and for the assessment of active traffic management operations. This article discusses the efficiency of certain reliability indicators in an ex-post assessment of a traffic management strategy. Ex-post assessment is based on an observational before–after study. As some factors other than the studied management strategy may intervene between the two periods, and as most reliability indicators require knowledge of the full travel time distribution and not only its average, a methodology is developed for the identification of the impact of these exogenous factors on the whole distribution. Many reliability indicators are split into different parts allowing the identification of the part due to the management strategy impact. The methodology is tested numerically on a managed lane operation consisting of Hard Shoulder Running (HSR) at rush hour on a section of a French motorway. The variation of some reliability indicators appears misleading, whereas the splitting of the indicators increases our understanding of the strategy and highlights its impact. The paper gives the reliability assessment of the HSR field test and discusses different reliability indicators to identify their potential performances and shortcomings.     

水中悬浮隧道交通荷载模拟方法研究

为研究水中悬浮隧道交通荷载的合理模拟方法以及交通荷载对隧道结构的影响,借鉴铁路、公路交通荷载的模拟方法,综合考虑车辆轮载、路面不平度、行车速度以及外部激励荷载等影响因素的共同作用,提出水中悬浮隧道交通荷载的模拟表达式。通过数值模拟计算,分析悬浮隧道交通荷载的变化特征,并研究不同交通荷载模拟方法对悬浮隧道结构振动位移响应的影响。结果表明:文章提出的交通荷载模拟方法计算结果符合移动振动荷载的波动性和周期性特征。在对结构振动位移响应影响方面,固定均布荷载相当于静载,移动集中荷载和移动振动荷载时的位移变化幅值相对固定均布荷载时的大且影响相似,但移动振动荷载时的振幅稍大,体现了交通荷载中动荷载部分对结构振动位移响应的影响,更适合用来模拟悬浮隧道中的交通荷载。     

强夯置换法处理滨海公路软土路基

结合辽宁省滨海公路庄河市大张至中隈段的土质情况,阐述了强夯处理软土地基的设计方法、施工过程及处理后的地基效果.     

地震作用下钢筋混凝土桥墩抗倒塌性能研究

为研究混凝土桥墩的结构抗震性能,进行了单墩多自由度体系非线性静力推倒分析、非线性动力分析、增量动力分析。分别采用纤维模型中分布塑性铰和集中塑性铰两种建模方法,建立单墩有限元模型,利用Open Sees软件中的Hysteretic滞回模型考虑各种累积损伤的影响。