南昌地铁砾砂层渣土改良技术试验研究

随着土压平衡盾构的广泛推广和应用,其地层适应性也越来越强,但盾构机在一些特殊地层中掘进时,渣土无法满足盾构施工对渣土流塑性的要求,易造成刀盘结饼、掌子面压力不稳定、刀盘磨损严重等问题。泡沫渣土改良技术是保证施工安全、顺利进行的关键技术之一。本文针对两种工程现场常用的泡沫进行泡沫基础性能试验,并以南昌地铁3号线盾构区间为工程背景,针对该区间砾砂地层进行改良渣土坍落度试验,对不同注入率和不同发泡剂的改良效果进行分析。研究发现,两种泡沫剂的建议使用浓度为3%;渣土流动性随泡沫注入率的增大而提高。在试验所用土样条件下,建议施工时使用的泡沫注入率为20%~30%。     

成昆铁路矮塔斜拉桥索梁锚固区模型试验研究北大核心

为研究铁路矮塔斜拉桥索梁锚固区的受力形式,以成昆铁路金沙江大桥为工程背景,针对该桥采用的新型梁顶混凝土锚固构造,通过缩尺模型试验研究其在不同荷载下的应力分布和开裂特征。结果表明:在斜拉桥成桥恒载索力作用以及最不利荷载组合索力作用下,C7锚固块更容易发生破坏,将其作为试验构件开展缩尺模型试验,发现锚固块在不同张拉荷载作用下张拉至设计索力的过程中,应变增幅基本上线性增加,卸载后同样呈线性减小,说明混凝土受力处在线弹性阶段,且应力在规范要求范围内。在试验荷载加载至140%设计索力时,锚固块前端倒角位置开始出现细小裂纹且随荷载的增加不断开展。当荷载卸载至0时,之前出现的裂缝随荷载的减小逐渐闭合,宽度肉眼不可见,表明该构造能够满足正常使用要求且具备足够的安全储备。     

Structural safety assessment procedure for membrane-type LNG CCS considering hydroelasticity effect

As environmental regulations have become more onerous, the demand for LNG and LNG carriers has increased. The LNG cargo containment system (LNG CCS) is one of the most important facilities in LNG carriers, and many membrane types of LNG CCS have been developed so far. Traditionally, sloshing model tests are performed and a series of statistical approaches are used to obtain design sloshing pressures. Then, these design loads are utilized to analyze the structural safety of LNG CCS. In the sloshing model test, the flat and almost rigid plate is used as the LNG CCS instead of a real model, and thus, the hydroelasticity effect cannot be considered. In the present research, the effect of hydroelasticity on sloshing pressure was investigated in a fluid-structure interaction simulation. A wet drop simulation was conducted, and its results subsequently were compared with wet drop experimental test results to ensure their validity. Then, two types of structure model, namely a flat-rigid plate model and a flat-flexible CCS model, were generated to investigate the effect of hydroelasticity. Also, a fluid hitting analysis model was devised to realize the sloshing phenomenon, and the two generated structure models were applied as the structure domain in the analysis. In the fluid hitting simulations, it was found that the hydroelasticity effect on sloshing pressure is significant. Thus, correction factors, which are quantitative values of the effect of hydroelasticity, were derived (and are proposed herein). Finally, a structural safety assessment procedure for consideration of the hydroelasticity effect was derived (and is suggested herein).     

Analysis of volatility in driving regimes extracted from basic safety messages transmitted between connected vehicles

Driving volatility captures the extent of speed variations when a vehicle is being driven. Extreme longitudinal variations signify hard acceleration or braking. Warnings and alerts given to drivers can reduce such volatility potentially improving safety, energy use, and emissions. This study develops a fundamental understanding of instantaneous driving decisions, needed for hazard anticipation and notification systems, and distinguishes normal from anomalous driving. In this study, driving task is divided into distinct yet unobserved regimes. The research issue is to characterize and quantify these regimes in typical driving cycles and the associated volatility of each regime, explore when the regimes change and the key correlates associated with each regime. Using Basic Safety Message (BSM) data from the Safety Pilot Model Deployment in Ann Arbor, Michigan, two- and three-regime Dynamic Markov switching models are estimated for several trips undertaken on various roadway types. While thousands of instrumented vehicles with vehicle to vehicle (V2V) and vehicle to infrastructure (V2I) communication systems are being tested, nearly 1.4 million records of BSMs, from 184 trips undertaken by 71 instrumented vehicles are analyzed in this study. Then even more detailed analysis of 43 randomly chosen trips (N = 714,340 BSM records) that were undertaken on various roadway types is conducted. The results indicate that acceleration and deceleration are two distinct regimes, and as compared to acceleration, drivers decelerate at higher rates, and braking is significantly more volatile than acceleration. Different correlations of the two regimes with instantaneous driving contexts are explored. With a more generic three-regime model specification, the results reveal high-rate acceleration, high-rate deceleration, and cruise/constant as the three distinct regimes that characterize a typical driving cycle. Moreover, given in a high-rate regime, drivers’ on-average tend to decelerate at a higher rate than their rate of acceleration. Importantly, compared to cruise/constant regime, drivers’ instantaneous driving decisions are more volatile both in “high-rate” acceleration as well as “high-rate” deceleration regime. The study contributes to analyzing volatility in short-term driving decisions, and how changes in driving regimes can be mapped to a combination of local traffic states surrounding the vehicle.     

基于改进型消灭曲线法的横摇阻尼估算

自由衰减试验仍是目前最为有效且常用的估算横摇阻尼系数的方法.横摇阻尼系数的估算精度对于船舶横摇运动的预报起着至关重要的作用.通常采用所谓的消灭曲线法来分析自由横摇衰减数据.该方法的一个不足之处在于其推导是基于忽略了非线性恢复力项的自由横摇运动方程.另一方面,考虑更多非线性成分的能量法能够纳入该因素影响但在实施过程中较为复杂.文中提出了一种改进型的消灭曲线法,能够纳入船体非线性恢复力项的影响.所提出的方法形式简单且相比能量法更易于实施.数值试验证明了改进型消灭曲线法的正确性,并展现了其相对传统消灭曲线法所具有的优势.     

卡西姆港燃煤应急电站卸煤码头港池水域平面布置优化

针对复杂水域条件下大型散货码头的水域平面布置,基于卡西姆燃煤应急电站码头工程项目,根据对周边已建工程、红树林以及水动力等主要影响因素的深入分析提出初步平面方案,并通过船舶操纵模拟试验对平面布置及相关尺度进行优化,合理确定本工程平面布置方案。结果表明,本工程的建设对周边影响较小,水域尺度能够满足船舶通航及靠离泊要求,水域平面布置合理。     

考虑移步需求的无桩型共享单车动态调度研究

共享单车系统自发的不均衡性导致单车数量分布与用户需求分布之间产生偏移，降低了系统服务能力，需要调度实现再平衡. 现有动态调度算法缺乏考虑起点车辆供给不足，用户在出行过程中“再次”取车的移步需求，难以准确识别用户真实的出行需求分布，降低了调度效果. 本文提出以用户出行选择行为为下层，以调度车辆路径规划为上层的双层规划模型框架，设计结合仿真系统的启发式求解算法. 算例场景基于上海市虹口、杨浦区共享单车历史出行数据搭建，并进行网格化处理. 算例结果表明，模型能有效识别移步需求，提高共享单车的供需匹配能力. 针对各类调度资源配置情况，共享单车的供需匹配率提升18.07%~ 19.89%，提高了共享单车系统的管理效率.     

重载货车摩擦缓冲器阻抗特性的数值模拟

为预测摩擦缓冲器的实际工作状态,从几何特征和作用原理的角度,建立详细的MT-2型缓冲器理论模型。首先,通过对缓冲器内部各摩擦元件的运动学和静力学分析,推导出缓冲器在准静态下的阻抗特性;其次,引入附加摩擦系数量化各摩擦元件之间动静态摩擦过渡时的黏滞补偿,并模拟出缓冲器在动态下的阻抗特性;最后,利用C80型货车冲击试验数据对该缓冲器的理论模型进行验证。验证结果表明:总体上,数值模拟和现场试验下的缓冲器示功曲线基本吻合,说明模型的正确性;局部上数值模拟中缓冲器从加载Ⅰ阶段过渡至加载Ⅱ阶段的突变现象在冲击试验中表现的并不明显,还有待进一步完善。     

鱼雷定深航行稳定性的分叉分析

鱼雷定深运动方程含有诸多的非线性项，用传统的分析方法对其稳定性进行研究有较大难度。运用非线性科学中的分叉理论，选定鱼雷定深运动方程中的某一流体动力系数扰动值为分叉参数，系统地分析在经典比例微分深度控制系统作用下，鱼雷在退化平衡点处的航行稳定性。利用中心流形定理，推导出系统状态变量解析表达式，对系统 Hopf分叉进行分析，并进行仿真验证。结果表明，流体动力系数变化使定深航行产生 Hopf分叉，并给出了确保鱼雷稳定航行的流体动力参数取值范围。     

基于FLAC软件模拟强夯加固吹填砂地基

基于港区陆域吹填项目,采用FLAC软件建立三维模型,模拟了不同夯能、夯击次数对强夯效果的影响,对强夯前后杨氏模量的变化进行了分析研究。结果表明,表层吹填砂厚度和下卧软土层分布对夯能的大小起着决定作用。对于下卧松散砂层,可适当加大夯击能量和夯击次数(7~8击),增加其处理深度和效果;而对于下卧软黏土层,可以适当减小夯击能量并增加夯击次数,以提高加固效果。夯击之后,表层吹填砂的杨氏模量有较大的提高,从原来的10 MPa提高到20~40 MPa。