公路砖石拱桥加固原理及实效分析

以砖石拱桥的加固实例为工程背景,对砖石拱桥原拱圈下增设拱圈、原拱上增设钢筋混凝土拱圈、钢杆件拉结、钢板箍与螺栓锚固等几种加固方法的施工工艺流程、适用范围、注意事项等进行描述和探讨.     

双速搅拌工艺

根据传统二次搅拌理论,提出了混凝土双速搅拌工艺,介绍了双速搅拌工艺的原理及优点,并指出了该工艺的实现方案.该工艺的应用可降低生产成本,提高混凝土的强度和生产率.     

超大跨度斜拉桥施工过程力学行为

斜拉桥结构效应在施工过程中具有典型的时空变化特性，但目前对效应的时程特性及时空包络关注较少。建立精细的几何非线性分析模型，分析主跨1088m的苏通大桥施工过程力学行为，包括施工阶段效应增量、效应时程、效应包络及恒载效应。研究结果有助于结构设计和施工控制。     

大直径钢管桩承载力恢复过程试验研究

针对目前预制桩承载力恢复特性研究与工程应用中的不足,依托西非某海工工程,提出高应变法。采用对同一钢管桩进行初打与不同休止时间复打相结合的试验方法,研究了大直径钢管桩沉桩后的承载力恢复过程。结合地质情况、沉桩与试验结果,得到了钢管桩承载力、侧阻力及端阻力随时间变化的一般规律及影响因素,并通过静载试验对研究结果进行了验证。该研究在提高项目施工效率、降低成本的同时,还得到了有意义的规律与结论,可为后续类似项目提供参考。     

特种弹药铁路运输可调式定位装置研究

概述了特种弹药铁路运输可调试定位装置的主要功能、技术要求、主要战技术指标，介绍了特种弹药铁路运输采用的从箱体顶部固定方式，并进行了相应的可调式定位装置研究，将装置分为整体固定和单点独立固定两种，用于固定弹箱在敞车内的位置，确保弹体运输安全。     

太阳能游船光伏逆变器控制系统EMC设计

从船舶环境和光伏逆变器的基本原理和功能出发,分别对太阳能游船EMC干扰源和干扰路径进行分析,通过信号滤波与保护、工艺设计和试验测试,实现高可靠性的太阳能游船光伏逆变器控制系统研究和设计,为太阳能游船的光伏逆变器控制系统研究提供基本EMC设计思路与实现技巧。     

港口高压电缆卷筒滑环箱防凝露措施

凝露造成高压电缆卷筒滑环箱绝缘下降、箱体内元器件损坏,必须加以解决。分析凝露形成条件和造成高压电缆卷筒滑环箱故障的原因。提出温度控制法和湿度控制法两种措施。效果良好,可供参考。     

Autonomous cars: The tension between occupant experience and intersection capacity

Systems that enable high levels of vehicle-automation are now beginning to enter the commercial marketplace. Road vehicles capable of operating independently of real-time human control under an increasing set of circumstances will likely become more widely available in the near future. Such vehicles are expected to bring a variety of benefits. Two such anticipated advantages (relative to human-driver vehicle control) are said to be increased road network capacity and the freeing up of the driver-occupant’s time to engage in their choice of leisurely or economically-productive (non-driving) tasks.In this study we investigate the implications for intersection capacity and level-of-service of providing occupants of automated (without real-time human control), autonomously-operating (without vehicle-to-X communication) cars with ride quality that is equivalent (in terms of maximum rates of longitudinal and lateral acceleration) to two types of rail systems: [urban] light rail transit and [inter-urban] high-speed rail. The literature suggests that car passengers start experiencing discomfort at lower rates of acceleration than car drivers; it is therefore plausible that occupants of an autonomously-operating vehicle may wish to instruct their vehicle to maneuver in a way that provides them greater ride comfort than if the vehicle-control algorithm simply mimicked human-driving-operation.On the basis of traffic microsimulation analysis, we found that restricting the dynamics of autonomous cars to the acceleration/deceleration characteristics of both rail systems leads to reductions in a signalized intersection’s vehicle-processing capacity and increases in delay. The impacts were found to be larger when constraining the autonomous cars’ dynamics to the more-restrictive acceleration/deceleration profile of high-speed rail. The scenarios we analyzed must be viewed as boundary conditions, because autonomous cars’ dynamics were by definition never allowed to exceed the acceleration/deceleration constraints of the rail systems. Appropriate evidence regarding motorists’ preferences does not exist at present; establishing these preferences is an important item for the future research agenda.This paper concludes with a brief discussion of research needs to advance this line of inquiry.     

Predicting the adoption of connected autonomous vehicles: A new approach based on the theory of diffusion of innovations

On the grounds that individuals heavily rely on the information that they receive from their peers when evaluating adoption of a radical innovation, this paper proposes a new approach to forecast long-term adoption of connected autonomous vehicles (CAVs). The concept of resistance is employed to explain why individuals typically tend to defer the adoption of an innovation. We assume that there exists a social network among individuals through which they communicate based on certain frequencies. In addition, individuals can be subject to media advertisement based on certain frequencies. An individual’s perceptions are dynamic and change over time as the individual is exposed to advertisement and communicates with satisfied and dissatisfied adopters. We also explicitly allow willingness-to-pay (WTP) to change as a result of peer-to-peer communication. An individual decides to adopt when (i) there is a need for a new vehicles; (ii) his/her WTP is greater than CAV price; and (iii) his/her overall impression about CAVs reaches a cutoff value. Applicability of the proposed approach is shown using a survey of employees of the University of Memphis. Our results show that the automobile fleet will be near homogenous in about 2050 only if CAV prices decrease at an annual rate of 15% or 20%. We find that a 6-month pre-introduction marketing campaign may have no significant impact on adoption trend. Marketing is shown to ignite CAV diffusion but its effect is capped. CAV market share will be close to 100% only if all adopters are satisfied with their purchases; therefore, the probability that an individual becomes a satisfied adopter plays an important role in the trend of adoption. The effect of the latter probability is more pronounced as time goes by and is also more prominent when CAV price reduces at greater rates. Some caveats may be inserted when considering the study results as the findings are subject to sample bias and data limitations.