车辆运动方程定位原理的研究及其应用

利用车辆运动方程获取车辆行驶距离,车辆当前位置点处的道路方向作为方向角,根据航位推算原理实时推算车辆位置。通过实地跑车试验分别分析了该定位技术在车载导航系统和监控中心的应用。试验结果显示,在车辆导航系统中该技术能实现GPS盲区内的车辆连续定位功能;在监控中心中,该技术从理论上可以大大减少单个车辆和监控中心之间的信息流量,其实际应用还有待智能交通系统的进一步完善。     

Thermal design of automobile exhaust based thermoelectric generators: Objectives and challenges

The potential for thermoelectric power generation (via waste heat recovery onboard automobiles) to displace alternators and/or provide additional charging to a vehicle battery pack has increased with recent advances in thermoelectric material processing. In gasoline fueled vehicles (GFVs), about 40% of fuel energy is wasted in exhaust heat, while a smaller amount of energy (30%) is ejected through the engine coolant. Therefore, exhaust-based thermoelectric generators (ETEG) have been a focus for GFV applications since the late 1980s. The conversion efficiency of modern thermoelectric materials has increased more than three-fold in the last two decades; however, disputes as to the thermal design of ETEG systems has kept their overall efficiency at limited and insufficient values. There are many challenges in the thermal design of ETEG systems, such as increasing the efficiency of the heat exchangers (hot box and cold plate), maintaining a sufficient temperature difference across the thermoelectric modules during different operating conditions, and reducing thermal losses through the system as a whole. This paper focuses on a review of the main aspects of thermal design of ETEG systems through various investigations performed over the past twenty years. This paper is organized as follows: first, the construction of a typical ETEG is described. The heat balance and efficiency of ETEG are then discussed. Then, the third section of this paper emphasizes the main objectives and challenges for designing efficient ETEG systems. Finally, a review of ETEG research activities over the last twenty years is presented to focus on methods used by the research community to address such challenges.     

3-D numerical and experimental analysis for airflow within a passenger compartment

People use cars so frequently that they always consider the air-conditioning, and thermal comfort of the driver and passenger when buying a new car. Therefore accurate simulation of the thermal performance of automobile air conditioners to improve human comfort has become increasingly important. In order to improve the thermal comfort of passengers, 3-D flow motion and thermal behavior within vehicles must be analyzed. In this paper, a numerical simulation was used to investigate thermal behavior in a vehicle. Because air temperature at an air vent is related to the cooling capacity of the air conditioner, the cooling capacity was calculated using ɛ-NTU (effective number of transfer unit) theoretical equations. Using the air temperature relationship between inlet and outlet vents as boundary conditions, a 3-D unsteady κ-ɛ turbulent model was used to give a transient analysis simulation of the temperature field and flow conditions in a vehicle’s passenger cabin. Cooling cycle analysis and conjugate heat transfer analysis at the inside surface of the cabin’s ceiling, floor and sides were also considered. The predicted temperature distributions in the vehicles passenger cabin were in good agreement with those obtained experimentally.     

压电堆执行器温度特性研究

在压电堆执行器生热和散热机理分析基础上,建立高压共轨喷油器压电堆执行器温度特性的计算模型,经与试验结果对比,验证了模型的准确性.研究了驱动场强、驱动频率和驱动脉宽增加的苛刻工作条件下不同影响因素对压电堆执行器的生热特性的影响,并研究了压电堆执行器结构和喷油器冷却结构对散热特性的影响.     

多次喷射对柴油机燃烧与排放影响的试验研究

基于1台高压共轨涡轮增压柴油机,采用不同的预喷正时、预喷油量与后喷正时等,研究了多次喷射对燃烧放热、排放生成与燃油经济性的影响,以实现均质压燃和低温燃烧过程。研究结果表明:随预喷正时提前,缸内峰值压力降低,主燃阶段的滞燃期缩短,NOx和炭烟排放均降低;随预喷油量增加,预喷阶段燃烧的放热率和最大压力升高率增大,NOx和HC排放增大,而PM和CO排放降低;随后喷始点推迟,缸内压力与主放热率峰值差异变小,NOx排放降低,但炭烟排放先增大后逐渐降低。     

高速公路交通管理系统用户满意度测评方法研究

高速公路交通管理系统用户满意度的测评研究对交通运输项目社会经济影响评价具有重要意义。利用计量经济学方法建立了基于交通运输信息的高速公路交通管理系统用户满意度指数模型,并对测评方法进行了研究。该方法为交通运输部门实时了解本系统运营质量水平提供了有效的参考依据。     

基于对流效应的寒区路堤块石层临界高度研究

为了研究块石路堤降温效应与块石层高度之间的关系,基于多孔介质自然对流理论和热传导理论引入了表征寒区块石路堤自然对流降温效应的自然对流指数,利用热传导温度分布函数获得了路堤自然对流指数随块石层高度变化的近似公式。分析表明:自然对流指数最小值对应于路堤块石层的最小高度,而其最大值对应于路堤块石层的最大高度。另外介绍了一种利用自然对流指数近似公式估算路堤块石层临界高度的方法,并具体给出了算例,最后进行了数值验算。结果表明:通过自然对流指数确定的临界高度可为寒区工程的路堤设计提供参考。     

改进的水泥混凝土路面温度应力系数经验公式表达

现行规范水泥混凝土路面的温度应力系数需要人工查图读取，不可避免地存在主观性，也不利于计算机技术的应用。通过查图读取数据，应用双线性函数、一般化的二次方程、以及其他简单函数拟合，得到了含有13个常量的改进的温度应力系数Bx经验公式。分析表明，基于查图数据，对应99％的保证率，使用公式引起的温度疲劳应力的误差不超过水泥混凝土弯拉强度的1％。公式对温度应力系数的解析描述，不但克服了查图的缺点，也为进一步的研究工作准备了条件。     

一种新的沥青混合料疲劳性能评价方法

根据Lemaitre应变等效假设,定义沥青混合料疲劳损伤参量,并在分析沥青混合料疲劳损伤过程的基础上,定义新的疲劳破坏标准。然后通过三分点小梁弯曲疲劳试验建立基于损伤理论的沥青混合料疲劳性能评价方法。重合性检验表明,该损伤疲劳模型与荷载控制模式无关,从而可以更合理的评价混合料疲劳性能。     

车用管带式散热器的性能研究

针对车用管带式散热器,在试验和分析计算的基础上,建立预测管带式散热器的传热与流动阻力的数学模型,即传热因子j(柯尔朋数)和摩擦因子f(范宁摩擦系数)的计算关联式,并且编制了相应的计算程序,计算结果与试验数据在常规工况范围内基本吻合。同时,也在相同的条件下采用了Y. J. Chang建立的数学模型进行计算,并与试验结果做了比较。利用所编制的计算程序分析了散热器结构参数对散热器性能的影响,从而为改进散热器性能提供依据。