成昆铁路矮塔斜拉桥索梁锚固区模型试验研究北大核心

为研究铁路矮塔斜拉桥索梁锚固区的受力形式,以成昆铁路金沙江大桥为工程背景,针对该桥采用的新型梁顶混凝土锚固构造,通过缩尺模型试验研究其在不同荷载下的应力分布和开裂特征。结果表明:在斜拉桥成桥恒载索力作用以及最不利荷载组合索力作用下,C7锚固块更容易发生破坏,将其作为试验构件开展缩尺模型试验,发现锚固块在不同张拉荷载作用下张拉至设计索力的过程中,应变增幅基本上线性增加,卸载后同样呈线性减小,说明混凝土受力处在线弹性阶段,且应力在规范要求范围内。在试验荷载加载至140%设计索力时,锚固块前端倒角位置开始出现细小裂纹且随荷载的增加不断开展。当荷载卸载至0时,之前出现的裂缝随荷载的减小逐渐闭合,宽度肉眼不可见,表明该构造能够满足正常使用要求且具备足够的安全储备。     

冲压机械振动对高铁桥梁及行车动力影响分析

高速铁路桥梁的平顺性和稳定性对运营列车的平稳性和安全性有很大影响。为研究冲压机械产生的外部振动激励对高铁桥梁的影响,首先通过对此机械引起的地面振动进行实测,并结合有限元分析软件,确定最大冲击荷载作用下产生的地面振动及传播至桥墩处的振动;然后通过建立列车-轨道-桥梁耦合动力学模型,将桥墩处的地面振动作为激励输入,分析列车以不同速度通过时车辆、桥梁动力学响应。结果表明:地面冲击振动有限元模型计算结果与实测结果基本相符,验证了模型的可靠性;地面振动对桥梁响应会产生一定的影响,距振源50 m处地面振动对桥梁所产生的影响较距振源80 m处(桥墩处)的大,但对运行车辆的影响很小;随着车速由250 km/h至350 km/h,车辆及桥梁各结构的动态响应均有所增大,但都未超出安全限值。因此,冲压机械冲击作用导致的地面振动对列车-轨道-桥梁系统动态服役性能影响非常有限。     

Can we reliably assess climate mitigation options for air traffic scenarios despite large uncertainties in atmospheric processes?

Air traffic has an increasing influence on climate; therefore identifying mitigation options to reduce the climate impact of aviation becomes more and more important. Aviation influences climate through several climate agents, which show different dependencies on the magnitude and location of emission and the spatial and temporal impacts. Even counteracting effects can occur. Therefore, it is important to analyse all effects with high accuracy to identify mitigation potentials. However, the uncertainties in calculating the climate impact of aviation are partly large (up to a factor of about 2). In this study, we present a methodology, based on a Monte Carlo simulation of an updated non-linear climate-chemistry response model AirClim, to integrate above mentioned uncertainties in the climate assessment of mitigation options. Since mitigation options often represent small changes in emissions, we concentrate on a more generalised approach and use exemplarily different normalised global air traffic inventories to test the methodology. These inventories are identical in total emissions but differ in the spatial emission distribution. We show that using the Monte Carlo simulation and analysing relative differences between scenarios lead to a reliable assessment of mitigation potentials. In a use case we show that the presented methodology can be used to analyse even small differences between scenarios with mean flight altitude variations.     

Traffic and emissions impact of congestion charging in the central Beijing urban area: A simulation analysis

Congestion charging is being considered as a potential measure to address the issue of substantially increased traffic congestion and vehicle emissions in Beijing. This study assessed the impact of congestion charging on traffic and emissions in Beijing using macroscopic traffic simulation and vehicle emissions calculation. Multiple testing scenarios were developed with assumptions in different charging zone sizes, public transit service levels and charging methods. Our analysis results showed that congestion charging in Beijing may increase public transit use by approximately 13%, potentially reduce CO and HC emissions by 60–70%, and reduce NOx emissions by 35–45% within the charging zone. However, congestion charging may also result in increased travel activities and emissions outside of the charging zone and a slight increase in emissions for the entire urban area. The size of charging zone, charging method, and charging rate are key factors that directly influence the impact of congestion charging; improved public transit service needs to be considered as a complementary approach with congestion charging. This study is used by Beijing Transportation Environment and Energy Center (BTEC) as reference to support the development of Beijing’s congestion charging policy and regulation.     

重载货车摩擦缓冲器阻抗特性的数值模拟

为预测摩擦缓冲器的实际工作状态,从几何特征和作用原理的角度,建立详细的MT-2型缓冲器理论模型。首先,通过对缓冲器内部各摩擦元件的运动学和静力学分析,推导出缓冲器在准静态下的阻抗特性;其次,引入附加摩擦系数量化各摩擦元件之间动静态摩擦过渡时的黏滞补偿,并模拟出缓冲器在动态下的阻抗特性;最后,利用C80型货车冲击试验数据对该缓冲器的理论模型进行验证。验证结果表明:总体上,数值模拟和现场试验下的缓冲器示功曲线基本吻合,说明模型的正确性;局部上数值模拟中缓冲器从加载Ⅰ阶段过渡至加载Ⅱ阶段的突变现象在冲击试验中表现的并不明显,还有待进一步完善。     

船用电器柜抗冲击设计研究

为增强船内部电器柜的抗冲击性能,采用有限元法对船内不同安装型式的电器柜结构进行了模态和抗冲击性能仿真分析,通过对比分析得出了使用撑杆加固型式安装的电器柜能显著提高船内电器柜的抗冲击性能的结论,并确定了电器柜抗冲击优化设计方案。     

新加坡工艺教育学院教学理念对我国职教改革的启示

文中介绍了新加坡工艺教育学院概况、教学理念与办学特色,比照我国职业教育的现状,提出现阶段如何进行改革的建议。     

大型活动交通影响评价方法

大型活动吸引和产生的突增交通量会造成周边地区的交通拥挤。通过比较大型活动与大型商业建设项目的交通影响评价特点和分析大型活动交通管理的影响因素,分别针对“提供一次性服务的大型活动”和“提供长效服务的大型活动”,设计了交通需求的预测方法。以交叉口服务水平分析方法为基础,提出一种了大型活动的交通影响评价方法。以长春市南岭体育场举办的“中国足球甲A联赛”为对象,运用Vissim微观交通仿真软件对所提出的方法进行了初步验证。结果表明,在大型活动条件下,所提出的方法能够确定需要进行交通管制的空间范围。     

铁路车辆编组连挂中车钩缓冲装置冲击特性分析

为了提高车辆编组连挂时的平稳性,保证所运货物的完整无损,通过对铁路车辆编组连挂时车钩缓冲装置的冲击特性进行分析,建立编组连挂时的缓冲装置的力学模型,对模型分析解微分方程得出位移时间曲线、加速度时间曲线以及加速度峰值,从而得出编组连挂的最大加速度与车钩系统的阻尼有关。     

����ʱ�չ켣���ٵĽ�ͨ�����Բ���������

基于视频的交通流检测在智能交通系统中具有重要意义。本文针对广泛采用的低位摄像机,提出了一种交通流特性参数的检测分析方法。首先基于三级虚拟检测线和自适应更新率局部背景建模来快速提取车辆特征点并消除活动阴影对提取精度的影响;然后基于Adaboost（Adaptive Boosting,自适应增强）分类器实现特征点按车分组,并在跟踪过程中根据运动特征相关度消除分组误差,获取高精度的车辆轨迹;进而自动生成多车道轨迹时空图并提取各车道交通流的多种特性参数。实验结果验证了算法的高效性;同时,自动生成的多车道轨迹时空图也为更多的交通信息获取和更深入的交通流特性分析提供了有力支持。