内压载荷下X80管道裂纹应力分布规律研究

为了研究内压作用下管道裂纹应力场分布规律,以含有表面裂纹的X80管道为研究对象,对不同形状、不同方向、不同内压、不同尺寸的含裂纹管道进行仿真分析和实验验证。结果表明:裂纹尖端处应力远大于裂纹中心应力。裂纹形状对应力影响作用较小,随着裂纹方向与管道轴向夹角增大,裂纹尖端应力先增大后减小,随着管道内压、裂纹深度、裂纹长度的增大,裂纹尖端处应力随之线性增大。其中,裂纹长度对裂纹尖端应力的影响小于管道内压和裂纹深度。     

Adoption of alternative fuel vehicles: Influence from neighbors,family and coworkers

During the last years, many governments have set targets for increasing the share of biofuels in the transportation sector. Understanding consumer behavior is essential in designing policies that efficiently increase the uptake of cleaner technologies. In this paper we analyze adopters and non-adopters of alternative fuel vehicles (AFVs). We use diffusion of innovation theory and the established notion that the social system and interpersonal influence play important roles in adoption. Based on a nationwide database of car owners we analyze interpersonal influence on adoption from three social domains: neighbors, family and coworkers. The results point primarily at a neighbor effect in that AFV adoption is more likely if neighbors also have adopted. The results also point at significant effects of interpersonal influence from coworkers and family members but these effects weaken or disappear when income, education level, marriage, age, gender and green party votes are controlled for. The results extend the diffusion of innovation and AFV literature with empirical support for interpersonal influence based on objective data where response bias is not a factor. Implications for further research, environmental and transport policy, and practitioners are discussed.     

缓波型非粘接柔性立管的干涉敏感性

针对非粘接柔性立管在波浪和海流作用下易发生立管干涉的问题,以我国南海某油田输油立管和相邻锚链为例,分别对拖曳力系数、管道单位长度质量、外径、内部介质密度、立管抗拉弯扭刚度和悬挂角度等参数进行敏感性分析,得出不同参数的敏感性情况,并在此基础上提出一些建议供实际工程设计参考.     

隧道爆炸冲击波的危害及控制措施

目前山岭隧道施工基本以钻爆法为主,爆破过程中产生的冲击波会对隧道内的人员及机械设备安全产生较大影响,造成重大安全事故和财产损失。本文主要介绍了冲击波在隧道内传播会形成超压,且随着传播距离增加超压峰值逐渐衰减到大气压范围内;基于超压准则评估了冲击波对人体、隧道内设施及周边建筑物的危害程度;通过在隧道内安装简易的冲击波缓冲装置及加强监测、设置安全警戒线等控制措施,减弱了爆破冲击波的危害,从而达到安全快速施工的目的。     

基于信令数据的出行强度影响因素分析模型

为探究城市交通出行强度影响因素及不同因素的影响程度，本文从土地利用与交通基础设施建设两方面出发，分析包括土地利用混合指数，职住混合率熵指数，公共交通站点 500 m覆盖率，路网可达性等17个指标与出行强度的相关关系；基于相关系数和拟合优度分析，提取7个与出行强度强相关指标，基于所识别指标构建北京市中心城区出行强度多元回归模型.模型结果表明，职住混合率熵指数对出行强度的影响最为显著，公共交通站点覆盖率对出行强度的影响比道路网密度和可达性更为明显.此外，给出单一土地利用/交通基础设施指标对出行强度拟合结果的离群特征分析方法，用于评估不同区域基础设施供给与交通出行需求之间的平衡关系.     

高速铁路轨道的波阻抗及影响因素研究

高速铁路轨道在雷击或故障冲击电流作用下会产生暂态冲击过电压,该过电压的大小由轨道的波阻抗决定。通过建立高速铁路线路的仿真模型,分析直角冲击波在轨道上的传播与折反射过程,提出轨道的波阻抗的计算方法,研究钢轨类型、土壤电阻率、钢轨对地过渡电阻对波阻抗的影响。结果表明:P60型轨道波阻抗数值为235. 55Ω;轨道的波阻抗主要受钢轨类型和土壤电阻率的影响,高速铁路轨道的波阻抗在在210～250Ω变化;在高速铁路轨道仿真模型中,线路末端电阻等于波阻抗时,可以有效地消除折反射对仿真结果的影响,末端电阻的取值不需要考虑钢轨地过渡电阻的影响。研究给出高速铁路轨道波阻抗的范围及仿真模型中末端电阻的取值方法,可以为轨道过电压计算、分析与仿真提供理论与方法参考。     

Estimation of extreme significant wave heights and the associated uncertainties: A case study using NORA10 hindcast data for the Barents Sea

The reliability of an offshore structure is dependent on its response to the extreme wave climate; therefore, an adequate knowledge of the wave climate at a location is a prerequisite during design as well as in marine operations. This study aims to contribute to the knowledge of the extreme wave climate in the Norwegian Sector of the Barents Sea, using wave hindcast datasets from the Norwegian Reanalysis 10 km (NORA10) database for four locations.We have considered three commonly used methods for the estimation of extreme wave heights, that is, the initial distribution method, the peak over threshold method, and the annual maxima method. The parametric bootstrap concept is considered in the estimation of the epistemic uncertainty related to sample size. The estimated 100-year significant wave heights obtained from the three methods differ, and the degree of variability in the estimates varies, depending on the dataset. The epistemic uncertainty due to sample size is wider when considering the annual maxima method.The estimates obtained from the three methods show the importance of considering different methods and their associated uncertainties when estimating extreme wave values for design. While it is difficult to single out the best method among the three, the estimated values give knowledge of the possible range of the extreme significant wave heights at the locations. Generally, the datasets considered in this study suggest that the wave climate is less harsh further north compared to the southern region of the Barents Sea. The datasets do not suggest any temporal trends in the historical significant wave heights at any of the locations.     

Layout optimization of an inertial energy harvester for miniature underwater mooring platforms

Comprehensive analyses of the layout influence on power performance of a low-frequency miniature horizontal-pendulum-type inertial energy harvester for underwater mooring platforms are presented in this article. The mathematical models are obtained utilizing the Newton-Euler method. The power performance is evaluated by simulations over different parameters, such as damping, excitation frequency, and layout position. Simulation results indicate that the harvester can extract energy from low-frequency excitations over the range of 0.1 Hz–0.4 Hz, and maximum output power can reach to 0.7 W under excitation frequency f = 0.4 Hz. Different layout positions influence the energy harvesting performance of the harvester dramatically. Changing the layout position to positive value can enhance and broaden the power performance. The amplitude responses with different layout positions do not show resonant characteristics, even near the natural frequency of the harvester, due to large amplitude vibrations and strong nonlinear characteristic. As excitation frequency f = 0.4 Hz, there is a zero output power point appears at layout position d = −1.3 m. Moreover, the harnessed power has a quadratic relationship with the layout position value.     

基于地基回弹因素的盾构隧道管片上浮预测

针对软弱地层盾构隧道管片脱出盾尾后出现的上浮问题,分析盾构施工过程中管片上浮的诱因,得出软弱地层中管片的上浮主要是地层应力重分布产生的地基回弹力引起的。在此基础上建立隧道开挖动态模型,分析隧道上浮量变化规律以及地层特性对管片上浮量的影响规律,得出地层弹性模量和管片上浮量呈一定的指数关系,且弹性模量对管片上浮量的影响远大于地层黏聚力和内摩擦角。通过力平衡理论计算盾构开挖引起的地层回弹力、管片上浮量以及隧道上浮影响的地层高度范围,并通过对珠江狮子洋工程管片上浮量的计算与实测对比,证明该公式的合理性,为盾构隧道工程中考虑地基抗力引起的管片上浮量预测提供一种新的方法。     

基于一维-三维耦合仿真的进气系统优化方法

提出了基于一维-三维耦合仿真的进气系统优化方法,此方法兼具CFD对进气系统三维流动特性准确描述与一维仿真对内燃机进气系统全局控制的优点。建立了进气歧管三维模型,采用GT-Power软件进行缸内工作过程模型仿真,根据试验数据标定仿真模型。通过一维-三维耦合仿真计算得到进气歧管各转速下的流动参数,以此作为CFD仿真的边界条件,优化进气歧管的结构参数。通过整机试验对进气歧管流动性能进行了验证。试验结果表明,该方法能够较好地指导进气歧管设计。