基于GOOSE机制的城市轨道交通中压环网继电保护方案优化

针对目前城市轨道交通中压环网继电保护存在的问题,提出了基于GOOSE(面向通用对象的变电站事件)机制的中压环网的继电保护优化方案,有效地解决了传统过流保护级差配合困难的问题.该方案是以GOOSE光纤以太网为基础,以闭锁逻辑为核心的数字通信电流保护方案.将GOOSE信号进行分类,并对中压供电环网系统各种可能出现的故障进行动作行为分析.最后,通过RTDS(动态数字仿真系统)仿真试验,证明该方案在各种故障情况下,都能保证继电保护的选择性、速动性、灵敏性和可靠性.     

Signal control optimization for automated vehicles at isolated signalized intersections

Traffic signals at intersections are an integral component of the existing transportation system and can significantly contribute to vehicular delay along urban streets. The current emphasis on the development of automated (i.e., driverless and with the ability to communicate with the infrastructure) vehicles brings at the forefront several questions related to the functionality and optimization of signal control in order to take advantage of automated vehicle capabilities. The objective of this research is to develop a signal control algorithm that allows for vehicle paths and signal control to be jointly optimized based on advanced communication technology between approaching vehicles and signal controller. The algorithm assumes that vehicle trajectories can be fully optimized, i.e., vehicles will follow the optimized paths specified by the signal controller. An optimization algorithm was developed assuming a simple intersection with two single-lane through approaches. A rolling horizon scheme was developed to implement the algorithm and to continually process newly arriving vehicles. The algorithm was coded in MATLAB and results were compared against traditional actuated signal control for a variety of demand scenarios. It was concluded that the proposed signal control optimization algorithm could reduce the ATTD by 16.2–36.9% and increase throughput by 2.7–20.2%, depending on the demand scenario.     

Plate scanning tools to obtain travel times in traffic networks

The management of vehicle travel times has been shown to be fundamental to traffic network analysis. To collect travel time measurement, some methods focus solely on isolated links or highway segments, and where two measurement points, at the beginning and at the end of a section, are deemed sufficient to evaluate users' travel time. However, in many cases, transport studies involve networks in which the problem is more complex. This article takes advantage of the plate scanning technique to propose an algorithm that minimizes the required number of registering devices and their location in order to identify vehicles candidates to compute the travel times of a given set of routes (or subroutes). The merits of the proposed method are explained using simple examples and are illustrated by its application to the real network of Ciudad Real.     

多元评价体系组合模型在铁路隧道变形预测中的应用

为克服传统预测模型结构单一、预测精度及稳定性不足等缺陷,提出多元体系组合预测模型的建模思路。首先,基于支持向量机、BP神经网络及ARMA模型3种单一预测模型,构建铁路隧道变形预测体系;再以均方根误差、误差平方和及平均绝对误差等为评价准则或指标,构建各预测结果的误差评价体系,求解各单项预测模型的权值贡献指数,得到最优组合权值;然后利用后验差检验、残差检验和关联度检验构建预测精度校验体系,对组合预测结果进行检验,评价预测模型的有效性;最后,结合工程实例,对多元体系组合预测模型在特大断面隧道中的变形预测效果进行检验。结果表明:多元评价体系组合模型预测相对误差值均小于2%,具有较高的预测精度,且较单一预测模型具有更高的预测精度,也一致通过相关检验,验证了多元体系组合预测模型的有效性。     

基于响应面和遗传算法的柴油机瞬态过程喷油参数优化

基于台架试验数据,利用响应面法建立了某工程机械用柴油机瞬态过程喷油参数与性能的近似高精度模型,基于此模型采用遗传算法对瞬态过程喷油参数分别进行离线优化研究。结果表明:采用单目标优化确定的燃油消耗率(BSFC)、NO_x比排放量和颗粒质量(PM)比排放量的优化极限分别可达180.23g/(kW·h),8.92g/(kW·h)和0.011 8g/(kW·h),相对原机可降低多达4.5%,34.0%和37.3%。双目标优化的Pareto解集表明,相比于同时优化BSFC和NO_x比排放量,BSFC和PM比排放量更容易同时得到优化。采用权重因子适应度函数的三目标优化结果对应的BSFC,NO_x比排放量及PM比排放量分别为184.70g/(kW·h),12.62g/(kW·h)和0.012 2g/(kW·h),较原机分别降低2.1%,6.6%和35.3%。改进优化模型后,性能优化Pareto解集对应的BSFC和PM比排放量水平都非常接近其优化极限,但NO_x比排放量相对其优化极限仍然较高。     

基于小波和粒子群算法的HEV行驶状况辨识方法研究

针对混合动力汽车(HEV)行驶状况(道路坡度和整车载荷)变化难以有效识别,导致驱动系统控制策略不能有效满足驾驶员意图问题,以混联式HEV为研究对象,提出了基于小波滤波和粒子群算法的HEV行驶状况辨识方法。首先建立了汽车行驶状况辨识模型,采用最小二乘法确立了优化目标函数,其次研究了基于小波滤波和粒子群算法的HEV行驶状况辨识原理,最后进行了行驶状况粒子群智能算法辨识试验。在采集实车数据的基础上,对实车数据进行小波滤波,并运用行驶状况辨识方法对道路坡度和整车载荷进行了辨识,并对辨识结果进行小波滤波,结果表明,试验工况下整车载荷辨识的相对误差绝对平均值为2.71%,道路坡度辨识的相对误差绝对平均值为3.85%,验证了所提出方法的有效性。     

国Ⅴ柴油机SCR系统结构对尿素结晶影响研究

针对某国Ⅴ商用柴油车SCR系统中出现的结晶问题,综合应用CFD模拟和台架试验进行分析研究,提出一系列结构优化和改进方案,改善了SCR前流场状态以及流体的流动均匀性和尿素均匀性,基本消除了排气系统在实际工况下的结晶风险,提高了全系统的抗结晶能力,保证了SCR系统的正常运行。通过对模拟结果和台架试验数据的比对分析,研究了流场分布以及混合器结构对结晶形成产生的影响。     

高职物流管理专业人才培养模式的改革实践

在深入研究高职教学规律和物流管理专业人才培养模式改革实践的基础上,提出在高职物流管理专业改革与建设的总体目标,从“工学交替”人才培养模式的构建策略、“面向工作过程系统化”的课程体系与教学内容改革、基于关键能力培养的“六步骤”法教学组织与实施模式、专兼结合的“双师结构”教学团队建设以及实习实训基地建设等方面,阐述了物流专业改革与建设的方案与措施。     

射频识别技术在物流工程中的应用研究

简要介绍了射频识别技术的工作原理和优点,综述了射频识别技术在国内各个领域的主要应用,最后指出了当前射频识别技术所存在的主要问题。     

动力总成悬置支架多目标拓扑优化和强度分析

基于Optistruct,以支架的最小柔度、最大固有频率作为优化目标函数;以应力、体积作为约束函数,对一发动机后拉杆安装支架进行拓扑优化,优化结果表明:在满足悬置支架强度和模态要求下,质量减少了12%。