丁坝错口距离的最优值、极限值研究

丁坝的布置方法直接影响到工程的效果,其关键是利用丁坝的坝后回流区。本文通过理论分析和水槽实验,提出了两岸丁坝在适当错口布置时整治范围增大的看法。获得了错口距离的最优值、极限值。错口坝的回流长度与宽度,回流与主流的分界边线的计算公式,计算结果与实验值吻合较好。     

锚泊时船舶放链长度的确定及其实用图表

本文给出了船舶锚泊时所受到的风作用力、水作用力和放出锚链长度的计算公式,以及实用数表和曲线图,可供查取。数表和曲线是根据文中确定的如下关系式编绘:L_b≈1/2Ln;L≈1.5L。(其中L_b——卧底锚链长度;L_n——悬垂锚链长度;L——放出锚链总长度)。十一例实船计算表明,根据上式计算结果,与目前国内外通用的方法确定的放链长度相符。利用这些数表和曲线图,既可合理地确定不同海况下船舶所应放出的锚链长度,也可减少起锚时的功率消耗和缩短起锚时间。     

Studies on the optimization of stern hull form based on a potential flow solver

A hypothesis of the minimum energy of secondary flow, suggested by Bessho, is introduced here. According to this hypothesis, it can be expected that hull forms having frame lines with a minimum energy of secondary flow show less form drag. In the first part of this article, secondary flow energy is evaluated for the cases with and without a free-surface effect, and Bessho’s hypothesis is confirmed for practical hull forms. Then optimization methods for the stern hull form are suggested, in which a nonlinear optimization technique is introduced. Numerical examples are given for a practical tanker hull form and a practical container hull form. From these studies, the suggested optimization method can be confirmed as a simplified and practical design method to the select frame lines of stern hull forms.     

CAN总线网络传输的延时优化研究

为减小CAN总线网络延时对传输速率的影响,提出了一种报文偏移量补偿与标识符优化的混合优化方案.首先定义总线网络传输延时,研究了表征CAN总线网络数据传输延时的主要指标,然后设计了报文分段与编码方案优化方法和延时报文的偏移量补偿方法,最后采用二者相结合的方案改善延时情况,并利用Symtavision软件分别对优化前、后C...     

The interaction of tidal advection, diffusion and mussel filtration in a tidal channel

Time series measurements of flow and pigment concentrations (Chl) in the Menai Strait have revealed that the strong residual flow in a tidal channel ( 500 m³ s^− 1) transports phytoplankton from the open sea into the channel where much of it is consumed by suspension feeders, mainly in commercial beds of Mytilus edulis. The progressive depletion of phytoplankton along the channel results in a strong horizontal gradient of plankton and hence Chl. Tidal displacement of this gradient causes large (± 50% of mean) oscillations of Chl in the vicinity of the mussel beds. Vertical mixing by the strong tidal flows is sufficiently vigorous for most of the tidal cycle to ensure that downward diffusion can resupply the near-bed layer although there are indications of some transient depletion around slack water.This paradigm of the interaction of advection, diffusion and filtration determining the distribution of plankton and its supply to mussels has been encapsulated in a series of simple models forced only by boundary values. In the first, a 1-D model of tidal flow in the channel reproduces the principal features of the observed currents including the unusually large spatial change in phase of the currents and the variation of the residual transport with tidal range. The flow field from this physical model is used to drive a second model based on the advection diffusion equation for Chl with a source at the Irish Sea boundary and a sink over the mussel bed. This model illustrates the formation of a strong Chl gradient along the channel and simulates the amplitude and phase of the M₂ oscillations of Chl and the development of the M₄ variation apparent in the observations. This second model has been extended to 2-D over the mussel beds to allow investigation of the effects of water column mixing. The model indicates that only for a short period ( 30 min), close to slack water, is mixing sufficiently reduced to permit the development of a depletion boundary layer and then only within  1 m from the bottom, a result which is consistent with the observations.     

船用柴油机排气冷却降噪装置性能仿真与实验研究

在特定情况下,船用大功率柴油机排气温度和噪声会受到严格限制,为解决这一问题,考虑在柴油机后安装冷却降噪装置.现应用湍流气粒两相流动的计算流体力学理论,对冷却降噪装置的冷却效果及阻力特性进行仿真计算,计算结果和试验吻合较好.     

水深对抛石强夯影响的模型试验研究

通过模型试验,探讨水深对重锤夯击抛石后夯沉率及抛石应力的影响,以及有、无水情况下抛石夯击夯沉率和抛石应力随落距的变化关系。试验研究成果表明：水面与抛石面齐平的情况与有水的夯击效果相近,为缩比尺模型试验中消除边界效应及水深影响提供了理论依据。     

移动非均布荷载作用下的沥青路面动力响应分析

为更准确地模拟沥青路面实际的受力状态,基于弹性层状理论,借助大型有限元分析软件ANSYS,建立了沥青路面三维有限元粘弹性模型,并对其施加非均布垂直和切向摩擦行为的共同影响,分析车辆在匀速行驶时,沥青路面在不同载重车辆荷载作用下的动力响应。结果表明,纵向最大拉应力位于基层层底,纵向最大压应力位于沥青面层。超载显著增加了各层结构应力,加速了路面结构的破坏。路面设计时应提高上层材料的抗压强度。     

一种扫路车吸嘴内部结构的优化

通过对吸扫式扫路车吸嘴口气流状态以及速度测试的分析,在不增加制造和使用成本的前提下,对吸嘴内部结构进行了优化设计,增大了吸力,提高了吸扫式扫路车的扫净率。     

Rice公式外推桥梁荷载效应

在当今,如何对桥梁进行合理评估已成为桥梁工作者的一个重要课题。而在桥梁评估过程中,科研工作者往往需要定量描述评估周期内某座桥梁的交通车辆荷载大小,一般用荷载效应描述。就此根据动态称重系统实测的107国道路段交通荷载数据产生的模拟车流对评估周期内荷载效应极值的计算方法进行了初步研究,以各种跨径简支梁为例,利用Rice外推理论外推各个观测周期的荷载效应极值,并以此作为建立评估荷载模型的基础。