沥青地库探索

应用导热油加热技术在中国已经发展了10多年,随着该技术的发展,地库也开始作为沥青贮仓.针对采用地库作为导热油加热沥青的这一技术,对地库的用热设备、导热油供热系统及沥青加热所需热量计算做了介绍.     

公路特大型泥石流研究及防治新理念

作为我国一种严重的公路水毁类型，公路特大型泥石流灾害至今尚未解决，本文建构了该类泥石流研究及防治新理念，对于公路建筑物的安全与稳定、确保公路交通有序进行具有重要意义。研究认为，公路泥石流研究及防治的主要对象是具有大冲大淤性能、毁损作用强烈的特大型泥石流；必须遵循以泥石流发育机理研究为基础、防治技术研究为手段、防治工程研究为目的的研究原则；详细分析了公路泥石流水毁模式，概化分析了冲淤变动型沟谷泥石流的发育特性；开发了防治效果极佳的速流结构，运用运动状态函数法建构了速流结构设计理念，运用动力学建构了泥石流最大抛程计算理论。     

Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

重载水泥混凝土路面损坏机理及对策研究

随着交通量的增加、轴载的增大和车速的提高,按照传统水泥混凝土路面规范修筑的道路出现了严重的早期破坏。本文通过分析重载交通作用下现有混凝土路面出现的早期破坏特征及其机理,从材料与结构上提出防止水泥混凝土路面在重载作用下发生早期破坏的对策。     

沥青混凝土搅拌机燃用重渣油的尝试

为降低沥青混凝土搅拌机的生产成本,采用ZZR重渣油燃烧机替代柴油燃烧机取得了很好的经济效益,给出了燃渣油时渣油含水及油路阻塞的判断方法,并介绍了出现故障的排除方法.     

A regression and beam theory based approach for fatigue assessment of containership structures including bending and torsion contributions

Container shipping has been expanding dramatically during the last decade. Due to their special structural characteristics, such as the wide breadth and large hatch openings, horizontal bending and torsion play an important role to the fatigue safety of containerships. In this study the fatigue contributions from vertical bending, horizontal bending and torsion are investigated using full-scale measurements of strain records on two containerships. Further, these contributions are compared to results from direct calculations where a nonlinear 3D panel method is used to compute wave loads in time domain. It is concluded that both bending and torsion have significant impacts on the fatigue assessment of containerships. The stresses caused by these loads could be correctly computed by full-ship finite element analysis. However, this requires large computational effort, since for fatigue assessment purposes the FE analysis needs to be carried out for all encountered sea states and operational conditions with sufficient time steps for each condition. In this paper, a new procedure is proposed to run the structure finite element analysis under only one sea condition for only a few time steps. Then, these results are used to obtain a relationship between wave loads and structural stresses through a linear regression analysis. This relation can be further used to compute stresses for arbitrary sea states and operational conditions using the computed wave loads (bending and torsion moments) as input. Based on this proposed method for structure stress analysis, an efficient procedure is formulated and found to be in very good agreement with the full-ship finite element analysis. In addition it is several orders of magnitude more time efficient for fatigue assessment of containership structures.     

Hierarchal assessment of noise pollution in urban areas – A case study

Noise pollution in urban areas has many harmful effects on the citizens. There are varieties of noise generation sources of which the traffic noise could be a major source. The point which is perhaps less noticed is that sound level is not the only parameter to indicate the extent and intensity of noise pollution. Situation of urban land uses, distribution of population centers and types of passages can deeply affect the concern on this environmental issue but not with a similar ratio. This article presents an overlaying technique to define noise prone areas using all different factors involved. A case study was carried out in the District 14 of Tehran Metropolitan City where there are busy streets and highways. For this purpose, the share of each criterion in noise pollution intensity was determined using Analytical Hierarchy Process (AHP). Afterwards, the map layers were overlaid based upon the relative importance of the criteria to get the final map on which the noise prone areas are specified. The developed method could be used as a tool for indirect estimation of noise pollution by which instead of direct measurement of the equivalent sound level, it would be possible to predict noise susceptible areas considering the most important influential factors.     

某散货船试航中主机滑油低压故障的排除

文章分析了某散货轮在试航中主机多次出现因滑油低压而报警停车的故障现象,并将该故障出现的原因及排除过程进行了总结和思考,以期为船厂、船东以及试航的相关人员提供参考。     

基于ANN的船舶撞击高桩码头群桩损伤位置预测

本文采用有限元软件ABAQUS建立了船舶撞击高桩码头群桩的空间有限元模型。通过计算评估了撞击力、桩体刚度、撞击位置和撞击角度下对群桩结构损伤位置的影响。基于人工神经网络(ANN)方法,对不同参数组合下的群桩结构损伤位置进行了预测,并对ANN方法的可行性进行了评估。     

5000 PCC“SHANGHAI HIGHWY”船主机启动分析与处理

分析5 000 PCC"SHANGHAI HIGHWAY"船主机伺服油压低引起主机启动故障的原因、介绍调查与处理过程,在实施了恰当的处理方法后,解决了问题。以期为类似问题的处理与解决提供借鉴和参考。