一种具有鲁棒性的磁链观测器在异步电机直接转矩控制中的应用

对磁链的准确估计在异步电机直接转矩控制中具有至关重要的作用．针对参数不确定电机模型．利用Lyapunov函数方法，给出了一种基于线性矩阵不等式（LMI）的具有鲁棒性的磁链观测器设计方法．得到了磁链观测器辨识的收敛性条件：相对于基于参数辩识磁链估计方法，其计算量很小．容易满足实时性控制的要求、仿真结果表明．磁链受定转子电月且不确定性变化影响较小．具有较强的鲁捧性．     

公路工程造价快速测算方法及其应用

在总结和分析各种工程造价估测方法的基础上，构建了基于模糊理论和造价管理系统之上的造价快速估测模型，并给出了其计算步骤和估测实例，可用于公路工程造价的快速测算。     

基于卡尔曼滤波的交叉口动态O-D反推模型与算法

交叉口各进出口道之间的实时转向交通量是信号控制系统重要的输入数据,也是难以获得的数据.针对已有模型收敛速度较慢、无法满足实际系统应用需要的问题,提出了基于卡尔曼滤波的状态空间模型,设计了顺序卡尔曼滤波进行求解,并采用裁切和标准化对反推结果进行了修正.实例研究表明,模型和算法具有较高的效率和准确性,能够为实时自适应信号控制系统的开发提供支持.     

Observer-based clutch disengagement control during gear shift process of automated manual transmission

A clutch disengagement strategy is proposed for the shift control of automated manual transmissions. The control strategy is based on a drive shaft torque observer. With the estimated drive shaft torque, the clutch can be disengaged as fast as possible without large driveline oscillations, which contributes to the reduction of total shift time and shift shock. The proposed control strategy is tested on a complete powertrain simulation model. It is verified that the system is robust to the variations of driving conditions, such as vehicle mass and road grade. It is also demonstrated that the revised system with switched gain can provide satisfactory performance even under large estimation error of the engine torque.     

A model-based traction control strategy non-reliant on wheel slip information

A traction control system (TCS) for two-wheel-drive vehicles can conveniently be realised by means of slip control. Such a TCS is modified in this paper in order to be applicable to four-wheel-drive vehicles and anti-lock braking systems, where slip information is not readily available. A reference vehicle model is used to estimate the vehicle velocity. The reference model is excited by a saw-tooth signal in order to adapt the slip for maximum tyre traction performance. The model-based TCS is made robust to vehicle modelling errors by extending it with (i) a superimposed loop of tyre static curve gradient control or (ii) a robust switching controller based on a bi-directional saw-tooth excitation signal. The proposed traction control strategies are verified by experiments and computer simulations.     

Flexible long range planning using low cost information

Contemporary transport planning requires a flexible modelling approach which can be used to monitor the implementation of a long term plan checking regularly its short term performance with easily available data; the original model is periodically updated using low cost information and this allows the evaluation of the changes to the plan which may be required. Such an approach requires models suited to regular updating and to the use of data from different sources. Models to update trip matrices from traffic counts have been available for some time; however, the estimation and/or updating of other model stages with low cost data has escaped analytical treatment. The paper discusses this idea and formulates the updating problem for an example involving a joint destination/mode choice model under various assumptions about the nature of the available data. Analytical solutions are proposed as well as some general conclusions.requests for offprints     

基于工作电压的动力电池剩余容量动态估算

以单体蓄电池为研究对象，为解决电动汽车动力电池在工作状态下的剩余容量（SOC）进行实时估算的难题，提出了一种新的动力电池剩余容量估算方法。通过外接一个处于工作状态下电池周期性的恒定电流负载，测得一系列的电池工作电压，这些工作电压采用阶段斜率的计算方法求电池该时刻的剩余时间，从而推算出电池的SOC。证明了动态工作点折算到静态工作点的可行性。该方法的相对误差最大不超过7％，通过软件可实施对温度、老化等因素的补偿。误差分析结果表明，该方法误差小，测量精度高。     

A Novel Approach to Vehicle Dynamics using the Theory of a Cosserat Point and its Application to Collision Analyses of Platooning Vehicles

A fully three-dimensional, computationally inexpensive vehicular model is presented. In contrast to traditional rigid body models, the vehicle's sprung mass is modeled as a (nonlinearly) deformable body. The formulation of the equations of motion is based on a continuum theory known as the theory of a Cosserat point. These equations largely preserve the relative simplicity of rigid body dynamics but incorporate deformable features. The ease of computer implementation permits the simultaneous simulation of vehicle and collision dynamics of multiple vehicles and highway objects. In this paper, the theory of a Cosserat point is summarized and its general application to vehicle and collision dynamics is illustrated. A three-dimensional collision algorithm is discussed with emphasis on small closing velocities (negligible residual crush, elastic rebound). The novel model is compared to standard procedures.     

水声网络探测节点的一种运动目标参数估计算法

文章提出了一种水声网络探测节点的运动目标参数估计方法,即基于模型匹配原理的估计算法。给出了算法的原理和仿真分析。     

贺尔海枢纽立交方案比选

对贺尔海枢纽立交的方案比选设计进行了详细的介绍,希望能够为同类立交设计时提供技术借鉴。