杭州湾跨海大桥70 m预应力混凝土箱梁用海工耐久混凝土的试验研究

通过平板抗裂试验,研究了海工耐久混凝土的早期抗裂性,采用RCM法研究了海工耐久混凝土抗氯离子渗透的能力。结果表明,使用P.Ⅱ42.5(R)硅酸盐水泥、Ⅱ区中砂、5~25 mm碎石、Ⅰ级或Ⅱ级低钙粉煤灰、粒化高炉矿渣粉及新一代高性能高效减水剂,可以配制出C 50~C 60海工耐久混凝土。     

京秦线提速路涵过渡段动力仿真与试验对比

结合京秦线提速改造工程进行了列车 路基动力仿真计算。在不同速度条件下,通过对路涵过渡段加固前后状态下机车车辆运行安全舒适性指标、轨道及路基主要动力性能指标的分析计算,对京秦既有线路涵过渡段提速到200km/h的适应性及加固方案的可行性提出了相应评价意见与建议,并与随后的实车试验进行了对比。试验测试结果验证了仿真分析的可靠性。     

Experimental ivnestigation on flow fields of viscous fluid around two-dimensional wings and comparison with computational results

To examine the flow field of a viscous fluid around the trailing edge of a wing with respect to the Kutta condition or the Joukowski hypothesis, an experimental investigation into the velocity fields around two-dimensional (2D) wings NACA0012 and NACA4412 was carried out using an X-type hot-wire anemometer in a wind tunnel and the method of colored milk injection in a circulating water channel. The results of these investigations revealed that the flow of a viscous fluid at the trailing edge of a 2D wing is tangential to the face on the pressure side, and that the flow is very slow or reversed on the suction side due to separation when the angle of attack is greater than 7.5°. By flow visualization, a Kármán vortex street was found in the wake of both wings (NACA0012 and NACA4412) when the angle of attack was 5°. These results show that the ordinary Kutta condition with respect to the direction of outflow at the trailing edge is not necessarily satisfied in a viscous fluid, but the Kutta condition with respect to the pressure at the trailing edge is satisfied as usual. Numerical results, which have been obtained as the solution of Reynolds-averaged Navier-Stokes equations, show good agreement with above-mentioned experimental results. Therefore, CFD (Computational Fluid Dynamics) simulation has proved to be very effective for studying steady viscous flow around the trailing edge of a 2D wing.     

多值非线性系统的自适应控制

提出了带有多值非线性环节的线性离散系统的自适应控制算法，仿真实验的结果表明：该算法简单易行具有明显的优点，跟踪误差比采用一般的自适应控制算法时要小得多，且能保证闭环系统大范围近收敛。     

柴油闪急沸腾喷雾的试验研究

通过对柴油机高压油管进行外加热源加热热，在Ｅ１５０柴油机上实现柴油的闪急沸腾喷雾，并对柴油机的性能及排放进行了试验研究。结果表明，采用闪急沸腾喷雾，柴油机油耗可降低８ｇ／ｋＷ．Ｈ，烟度下降０．４ＢＳＵ，ＮＯＸ排放略有升高，ＣＯ，ＨＣ排放均降低。     

Dynamic Simulation of a Smart Crank and Slider Mechanism

In this paper, a smart crank and slider mechanism is analyzed mostly from a dynamic view. By means of dynamic explicit finite element method, 3D nonlinear structure is simulated. It is proved that the mechanism can effectively accomplish smart movement prescribed. And in order to ensure reciprocal movement with higher frequency, measures should be taken to avoid over heating of parts. Compared with internal energy, kinetic energy of total rigid body is dominating, and Y direction equivalent rigid velocity is much higher than X direction velocity. Equivalent rigid velocity of all parts is consistent with respective movement condition. For both energy and velocity, slider effect is dominating. Three direction equivalent inertia force oscillates. Force amplitude in Y -direction is comparitively the greatest.     

滑行艇和翼滑艇在正横规则波中的线性横摇仿真研究

建立滑行艇和翼滑艇在正横规则波中的二阶线性横摇运动微分方程,并利用前苏联中央流体动力中心ЦАГИ法得到艇体阻力,利用仿真工具Matlab/Simulink建立滑行艇和翼滑艇的横摇运动、阻力及推进系统的综合仿真模型,仿真计算结果表明建立的横摇运动微分方程较为合理,并验证具有前置V型割划式水翼的翼滑艇其横摇自稳特性要比同等吨位的滑行艇优良许多。     

同步发电机参数辨识的相关方法探讨

随着电网安全及稳定运行问题的重要性日益突出,基于获得准确的系统模型和参数辨识方法,优化同步发电机相关参数将是十分有意义的。本文针对当今几种比较典型的参数辨识方法做了系统的介绍,通过比较得出何种方法对于同步电机的参数辨识是最适合的。     

盐渍土地基处理的浸水试验研究

盐渍土作为一种不良土体,由于它的盐溶特性严重影响置于其上的建筑物。采用何种有效的处理方法来降低溶陷沉降量将至关重要。文中以西北某盐渍土机场的地基处理为例,采用浸水预溶的处理方法,在现场分别进行了深层浸水试验、直接浸水试验、浸水后晾晒试验,并对施工工艺、浸水控制、渗水速度确定做了研究。通过试验后检测,浸水预溶试验取得了良好的效果,为指导大面积地基处理施工提供了可靠参数。     

虚阴极振荡器的研究进展

虚阴极振荡器是强流相对论电子束源中比较重要的一种微波源，能够产生很高的功率，近年来得到了广泛的重视。简要介绍了虚阴极振荡器的工作原理，综述了虚阴极振荡器的最新发展状况和发展趋势，以及用于虚阴极模拟的PIC方法和未来技术发展，分析了其性能和军事应用，最后评述了他们的发展前景。