Wind pressure distribution and wind-induced dynamic response for spatial groined latticed vaults

The wind pressure distribution and wind-induced vibration responses of long-span spatial groined latticed vaults (SGLVs) were numerically simulated, which always are ones of the most important problems in the structural wind resistance design. Incompressible visco-fluid model was introduced, and the standard k-εtwo equation model and semi-implicit method for pressure linked equation (SIMPLE) were used to describe the flow turbulence. Furthermore, the structural dynamic equation was set up, which is solved by Newmark-β method. And several sort of wind-induced vibration coefficients such as the wind-induced vibration coefficient corresponding to the nodal displacement responses and wind loads were suggested. In the numerical simulation where the SGLV consisting of the cylindrical sectors with different curved surface was chosen as the example,the influence on the relative wind pressure distribution and structural wind-induced vibration responses of the closed or open SGLV caused by such parameters as the number of cylindrical sectors, structural curvature and the ratio of rise to span was investigated. Finally, some useful conclusions on the local wind pressure distribution on the structural surface and the wind-induced vibration coefficients of SGLV were developed.     

高速机车制动温升对轴盘配合的影响

利用ANSYS建立了高速机车轴盘制动装置热量传递模型,计算了接触面热阻、间隙导热系数和表面传热系数,研究了其温度场分布特性,分析了制动生热对轴盘制动装置过盈配合的影响。计算结果表明:合理的制动盘和盘毂间隙能增大热阻,减小温度对过盈配合的影响,在结构允许范围内,建议合理的设计单边间隙为0.5~1.5mm;制动结束时刻,选择合理的盘毂厚度可使过盈面平均接触压力减小5.9%~6.6%,以降低温度对过盈配合的影响,建议盘毂合理厚度为8mm。     

聚丙烯纤维水泥稳定碎石收缩性能

为了减小水泥稳定碎石的收缩,研究了聚丙烯纤维对水泥稳定碎石收缩性能的影响,分别用千分表支架法和应变片电测法对聚丙烯纤维水泥稳定碎石和普通水泥稳定碎石的干缩性能和温缩性能进行了测试,分析了材料的平均干缩系数和平均温缩系数随纤维掺量变化的规律。试验结果表明:聚丙烯纤维的掺入可显著地减小水泥稳定碎石的平均干缩系数和平均温缩系数,高龄期聚丙烯纤维水泥稳定碎石的平均干缩系数比低龄期的小,而高龄期的平均温缩系数却比低龄期的大;在纤维体积掺量小于1‰的范围内,随着纤维体积掺量的增加,水泥稳定碎石平均干缩系数和平均温缩系数均逐渐减小。可见,在一定的纤维掺量范围内,聚丙烯纤维水泥稳定碎石具有良好的抗收缩性能,应用于路面基层可提高路面的抗裂性能。     

沉管隧道基槽爆破开挖作用下邻近地铁隧道力学响应

为确保邻近地铁隧道在沉管隧道基槽爆破开挖过程的安全性,通过现场实测评价地铁隧道运营现状,借助数值分析法探索地铁隧道对沉管基槽爆破开挖的力学响应特征,并制定既有隧道结构的安全判据和沉管基槽爆破振动安全距离。研究表明： 既有地铁区间隧道现状累计最大沉降为1.89 mm,近半年最大沉降速率为0.01 mm/d,均小于规范规定的控制值,隧道结构现状处于稳定状态;沉管隧道基槽爆破振动引起的地铁隧道结构最大振速为0.359 cm/s,远小于振速安全阈值（2.0 cm/s）,说明地铁结构受爆破振动影响较小,且爆破振动的安全距离为25 m; 基槽开挖应力扰动后引起的地铁隧道累计最大沉降为3.16 mm,小于位移预警值,隧道结构处于稳定状态。     

直喷增压汽油机采用高压缩比技术的研究

通过在1.3L直喷增压汽油机上,采用两种不同的高压缩比进行试验,研究泵气损失变化规律和对热效率的影响。在转速2500rpm-8bar工况下,采用可变气门正时技术调节发动机有效压缩比和膨胀比。结果表明:高的有效压缩比,必须加大节气门开度来减少节流损失,以降低泵气损失;利用高压缩比并采取进气门晚关、排气门晚开的策略的同时,需要兼顾到燃烧稳定性问题:几何压缩比提高以后,发动机不仅热效率得到提升,同时排放物NOx也在降低,但THC排放有所上升。     

准饱和土中单桩竖向荷载作用下的动力响应

根据Biot饱和多孔连续介质波动方程,基于Bardet对准饱和土的假设,提出了准饱和土二相介质波动方程;运用Helmholtz矢量分解和传递、透射矩阵法(TRM)推导出准饱和土中层状半空间受竖向荷载作用下的动力响应表达式;利用Muki虚拟桩法,在层状半空间建立了桩和准饱和土相互作用的第二类Fredholm积分方程,通过离散的数值积分方法求解积分方程,讨论了准饱和土中单桩竖向动力响应问题.算例分析表明,准饱和土中桩顶竖向阻抗随饱和度的减少而增大,与饱和土地基相比,明显偏大;桩侧孔压随饱和度的减小而增大,并沿着桩长迅速衰减;桩顶位移幅值在频率较小时变化明显,饱和度越小,位移峰值越大,当频率较大时,饱和度的变化对振幅的影响不大.     

高负荷下应用米勒循环提升高压比汽油机热效率机理研究

对高负荷工况下应用进气阀早关(EIVC)或者迟关(LIVC)技术实现的米勒循环进行仿真计算,基于热力学第一定律比较分析两者改善高压缩比增压直喷汽油机热效率的机理。结果表明:几何压缩比的增加提高了发动机的理论热效率,但由于高负荷时的爆震限制使油耗恶化了1.9%;米勒循环的应用可以有效降低爆震倾向,与原发动机相比,采用EIVC与LIVC策略燃油经济性的分别提升2.4%和3.0%;对比分析EIVC与LIVC对汽油机热效率的影响发现,LIVC策略能使燃烧相位更加优化、缸内燃烧更为充分,使得其燃油改善效果好于EIVC策略。     

增压汽油机不同排气歧管长度下的压力波动特性

利用台架试验数据校准了增压直喷汽油机一维性能仿真模型,应用校准后的模型研究了低速(1 500r/min)全负荷工况不同排气歧管长度下排气阀口与涡轮机入口处的压力波动特性,并对压力波动形态与低速增压压力的建立、瞬态响应、缸内充气效率等的关联性进行了深入分析。研究结果表明:在现有排气歧管结构形式下,在低转速宜采用较短歧管,从而有望获得更高的增压压力和扭矩;相继工作的气缸不宜在涡轮机前共用一根排气总管,否则容易引起废气倒流,而且歧管越短倒流越严重;排气歧管中的压力波在传向涡轮机入口过程中被"均值化",不能充分应用排气压力波动效应来提高低速扭矩和改善增压延迟。     

依靠技术攻关运用科学管理控制大体积混凝土施工裂纹

论述大体积混凝土裂纹产生的机理及控制措施。     

Experimental study on the nonlinear pressure acting on a high-speed vessel in regular waves

It is well known that the hydrodynamic responses of a high-speed vessel traveling in regular head waves of even moderate wave height can show significant nonlinear behavior, and so linear statistical techniques become insufficient for predicting the statistics of responses in irregular waves. On the other hand, it has been shown that an approximate third-order Volterra model is applicable to handling the statistics of some nonlinear seakeeping problems, such as motions and vertical hull girder loads. In the present study, the focus is on the nonlinear behavior of the pressure responses of the hull surface, especially on the pressures acting on alternately wet and dry areas near the waterline and on the bow zone with high deadrise angles that may be subject to slight impact and water pile-up effects. To clarify the validity of applying Volterra modeling to this problem, a series of experiments in regular and irregular head waves were carried out, and approximate third-order and fifth-order Volterra models with the proposed algorithm for finding frequency response functions (FRFs) were applied as a means of validation. In the present article, the first part of the validation was performed using experimental data in regular waves. It was confirmed that the third-order Volterra model has adequate accuracy to simulate deterministically the variation of pressure responses in regular waves of different wave steepness up to a wave amplitude to wavelength ratio of 0.01 even for the highly nonlinear pressures acting on the above-mentioned areas of the hull surface.