求解瞬时温度场的边界层函数法

本文介绍了求解奇异摄动问题的一种有效方法——边界层函数法,并用此方法研究了在薄矩形板中的热传导问题。     

一种结合2DLPP与2DPCA的人脸识别方法

为解决二维局部保持投影(2DLPP)需要较多数据表示人脸特征的缺陷,提出了一种新的二维局部保持投影主成分分析方法(2DLPP-PCA).通过对人脸图像在行、列方向同时进行2DLPP和2DPCA投影,2DLPP-PCA 不仅能减少保存人脸特征所需要的数据量,而且能有效地提取人脸的局部特征和全局特征.在ORL、Yale和CAS-PEAL-R1人脸数据库上的实验结果表明,2DLPP-PCA是一种高性能的特征提取方法,当训练样本数为6时,2DLPP-PCA在ORL数据库上的最佳平均识别率达到99％以上.     

Direct formulation and algorithms for the probit-based stochastic user equilibrium traffic assignment problem

This paper proposes simple and direct formulation and algorithms for the probit-based stochastic user equilibrium traffic assignment problem. It is only necessary to account for random variables independent of link flows by performing a simple transformation of the perceived link travel time with a normal distribution. At every iteration of a Monte-Carlo simulation procedure, the values of the random variables are sampled based on their probability distributions, and then a regular deterministic user equilibrium assignment is carried out to produce link flows. The link flows produced at each iteration of the Monte-Carlo simulation are averaged to yield the final flow pattern. Two test networks demonstrate that the proposed algorithms and the traditional algorithm (the Method of Successive Averages) produce similar results and that the proposed algorithms can be extended to the computation of the case in which the random error term depends on measured travel time.     

船体薄壁梁弯扭耦合振动的流固耦合分析

采用耦合有限元,边界元法计算水中船体的弯扭耦合振动.文中用一维薄壁梁有限元模拟船体梁,在横剖面处用二维边界元方法计算结构表面卢压,推导出表征流体对振动特性影响的附加质量阵,编制了用流同耦合方法求解船体振动模态的程序.通过与采用ANSYS软件进行耦合场分析以及刘易斯方法得到的振动模念相比较,验证了文中方法的可行性和应用性.     

边界控制方法在DVR样机研制中的应用

动态电压恢复器（DVR）可在供电电压发生电压下陷时维持负载电压稳定,以保护敏感负载。由于在正常电力系统中,电压下陷故障出现的频率相对不高,使得DVR的利用率较低。将一种基于二阶开关平面理论的边界控制器应用于DVR系统,使其既可用于电压下陷补偿又能用于稳态下电压电能质量控制,大大提高了设备利用率。通过预测DVR逆变器的某次开关动作后,其系统状态矢量的运动轨迹可得到上述二阶开关平面。将该平面作为状态轨迹沿理想开关平面运动的上界,可约束轨迹使其趋向理想工作点。为考察其动态特性,应用上述控制器的DVR样机针对源端谐波畸变和伴有畸变的下陷电压波形进行了补偿试验。结果证实上述边界控制方案可获得优于其它一些控制策略的谐波补偿效果。     

Non-local simulation of the stable boundary layer with a third order moments closure model

A new higher order closure model for the stable boundary layer is presented and compared with Large Eddy Simulation data. The model includes numerical solutions for the mean values, second and third order moments equations. A satisfactory agreement is found between the calculated vertical profiles of the turbulent quantities with those provided by the LES. Furthermore the new model results are compared with profiles obtained with a lower order closure model in order to verify the effective importance of including third order dynamical equations in the model.     

高速公路景观与绿化设计的要点

我国的高速公路存在着一些景观问题,通过从“点”、“线”、“面”三个方面深入研究景观与绿化设计的方法．可以提高我国高速公路的建设和服务水平。     

LNG卸料臂与船对接法兰面泄漏分析

LNG卸料臂是LNG卸载过程中最重要的设备之一,而卸载过程中卸料臂与船对接法兰面最易发生泄漏,因此避免其泄漏很重要。文中以某LNG接收站为例,简要介绍卸料臂预冷流程;对曾经发生过的泄漏展开分析,结果发现预冷速度过快是造成对接法兰面泄漏的主要原因;提出了相应的改进措施。改进之后,此LNG接收站卸船期间再未出现卸料臂与船对接法兰面泄漏的问题。     

Multi‐objective highway alignment optimization using a genetic algorithm

The available highway alignment optimization algorithms use the total cost as the objective function. This is a single objective optimization process. In this process, travel‐time, vehicle operation accident earthwork land acquisition and pavement construction costs are the basic components of the total cost. This single objective highway alignment optimization process has limited capability in handling the cost components separately. Moreover, this process cannot yield a set of alternative solutions from a single run. This paper presents a multi‐objective approach to overcome these shortcomings. Some of the cost components of highway alignments are conflicting in nature. Minimizing some of them will yield a straighter alignment; whereas, minimizing others would make the alignment circuitous. Therefore, the goal of the multiobjective optimization approach is to handle the trade‐off amongst the highway alignment design objectives and present a set of near optimal solutions. The highway alignment objectives, i.e., cost functions, are not continuous in nature. Hence, a special genetic algorithm based multi‐objective optimization algorithm is suggested The proposed methodology is demonstrated via a case study at the end.     

一种基于独立成分分析和径向基神经网络的人脸识别新方法

提出了一种新的基于独立成分分析和径向基神经网络的人脸识别方法。独立成分分析可以从高阶上消除特征数据的相关性,改进了主成分分析方法只能从2阶上消除数据相关性的弱点;最终特征数据的分类由RBF神经网络来实现。在人脸数据库上的实验结果表明该新方法的识别性能较其他方法有了很大提高。