地铁交通诱发邻近建筑物振动的实测与分析

根据现场实测数据,对某地铁2号线沿线典型区段地铁引起的临近建筑物振动实况和振动特性及其传播规律等进行了分析研究。结果表明:地铁诱发的沿线建筑物的振动以竖向为主,且楼层竖向振动基本表现为整体振动;在框架结构中,振动信号主要是沿柱子向上部楼层传播;楼层振动主要表现为低频的楼板振动,楼层间信号的放大主要集中在20 Hz以下的低频信号。此外,本文还给出建筑物振动实测资料的评价分析,为评估地铁运营诱发的环境振动与城市规划设计提供参考。     

发动机带传动中皮带寿命提高方法研究

设计一种新型的通用皮带预紧力测量装置，通过分析发动机皮带传动中的横向振动，提出带轮结构布置原则。实验证明，根据该原则进行皮带轮结构布置并设定准确的皮带预紧力，可减小传动打滑现象，有效提高皮带的使用寿命及皮带传动效率.     

Railway wheel-flat and rail surface defect modelling and analysis by time–frequency techniques

Damage to the surface of railway wheels and rails commonly occurs in most railways. If not detected, it can result in the rapid deterioration and possible failure of rolling stock and infrastructure components causing higher maintenance costs. This paper presents an investigation into the modelling and simulation of wheel-flat and rail surface defects. A simplified mathematical model was developed and a series of experiments were carried out on a roller rig. The time–frequency analysis is a useful tool for identifying the content of a signal in the frequency domain without losing information about its time domain characteristics. Because of this, it is widely used for dynamic system analysis and condition monitoring and has been used in this paper for the detection of wheel flats and rail surface defects. Three commonly used time–frequency analysis techniques: Short-Time Fourier Transform, Wigner–Ville transform and wavelet transform were investigated in this work.     

The dynamic response of rail support

This research reviews principles behind the dynamic response of rail supports, and introduces a method of analysis to find the maximum response in a realistic setting. Assuming a time-dependent, moving mass with massive wheels is essential, because the ratio of the moving mass to the rail mass is significant. However, the dynamic response of the track is not affected by dynamic properties of the train other than its unsprung mass, because the natural frequencies of the train suspension and track are significantly different. A numerical method is developed to model the dynamic response based on these principles, and applied to the Korean urban transit. The dynamic response includes multiple peaks with a large amplitude range, creating noise while the wheel passes the support. The dynamic impact factor (DIF) for the rail support depends mainly on the stiffness and damping of the rail support. The DIF for the rail moment is below the code value, whether this value is based on numerical analysis or on-site measurements. However, our numerical analysis results in a DIF for support settlement that is greater than the code value, if the damping is less than 3%.     

内燃机车柴油机振动烈度评定方法探讨

从机车在"0位"时柴油机晃动现象入手,对"柴油机振动烈度评定方法"进行了分析探讨。重点对测量点、测量参数计算、评定准则进行了阐述,重新提出了"柴油机振动烈度评定方法",同时给出了振动位移的控制值。     

中小跨径公路混凝土简支梁桥冲击系数研究及建议取值

为弥补中国现行桥梁规范中计算动力冲击系数时考虑因素单一的不足,对冲击系数的影响因素进行研究,并提出更合理的冲击系数建议值。首先,根据中国桥梁通用图集建立13座不同截面形式和不同跨径的常见中小跨径公路混凝土简支梁桥的有限元模型,结合能表征中国设计车辆荷载动力特性的三维车辆数值模型,建立车桥耦合振动分析系统。然后,基于车桥耦合振动分析系统,研究桥梁基频、桥面不平整度、车速和车质量等因素对动力冲击系数的影响,并与中国现行桥梁设计规范中的动力冲击系数取值进行对比分析。最后,提出冲击系数的建议值,并与世界各国桥梁规范中的冲击系数取值进行对比,讨论建议值的合理性。结果表明:桥面不平整度是影响冲击系数的重要因素,在桥面好的情况下,冲击系数均在0.1以下,低于规范中规定的冲击系数,而桥面很差时,冲击系数可达0.5,远大于中国现行规范中的冲击系数设计值,因此,定期对桥面进行维护能有效减小车辆对桥梁的冲击效应;质量轻的车辆引起更大的冲击系数,但由于车辆总质量轻,其导致的总荷载效应仍然较小,而重车虽然引起的冲击系数较小,但由于其导致的总荷载效应较大,更易对桥面造成损伤,因此,限制超载尤为重要。     

动态当量夹角在商用车产品开发中的应用研究

在商用车传动轴系统布置设计时，为避免因万向节传动输出轴与输入轴的转角差引起车辆异常振动，应使空载静止和满载静止工况下的传动轴当量夹角、最大夹角及角加速度幅值满足设计要求。研究表明，在某些工况下，仅校核空载静止和满载静止工况下的传动轴系统布置的相关参数，不能完全避免因传动轴系统布置设计引起的整车异常振动问题。因此分析了满载爬坡工况下动态当量夹角对整车异常振动的影响，表明了在进行商用车传动轴系统布置设计时，还需使满载爬坡工况下的动态当量夹角以满足设计要求。     

Investigating the influence of soil properties on railway traffic vibration using a numerical model

This paper presents the influence of dynamic and geometrical soil parameters on the propagation of ground vibrations induced by external loads. The proposed approach is based on a three-dimensional model, focusing on realistic excitation sources like impulse loads and moving railway vehicles. For the latter, a complete vehicle/track model is developed. The simulation is performed in time domain, offering an interesting approach, compared with classic cyclic analyses. The ground is modelled initially as an elastic homogeneous half-space and additionally as a layered half-space. First, the effect of homogeneous soil properties on ground vibration is analysed. Soil stratification is then taken into account, using various configurations. Analysis reveals that as receiver distance increases ground wave reflection in a layered ground plays an important role in the reduction of ground surface motion. This effect is magnified when the phase velocity wavelength becomes large compared with the depth of the surface layer.     

边界条件对吊索索力估算的影响

从Bernoulli—Euler理论出发，推导了吊索在一般边界条件下的自由振动频率方程和索力的解析表达式。分析了边界条件对吊索自振频率的影响，并与有限元结果进行了比较。结果表明，边界条件对吊索索力估算的影响不可忽略。     

基于模态分析的发动机齿轮室盖优化设计

某柴油发动机齿轮室盖在试验中振动较大,为解决这一问题,文章采用声学振动测试与CAE模态分析相结合的方法,对齿轮室盖进行优化设计,并进行试验验证。结果证明通过在齿轮室盖薄弱位置处添加加强筋,可以有效提高其固有频率,避开发动机在3600r/min转速下的主要贡献频率,改善齿轮室盖的振动情况。CAE模态分析方法能够有效识别结构件的薄弱区域,通过加强局部刚度,改善振动性能。