海洋核动力平台全频段舱室噪声预报与降噪方案研究

随着新规范对船舶及海上工作平台提出了更高要求，舱室噪声的控制及优化设计越来越受到人们的关注。本文首先对全频段舱室噪声预报软件——VA One软件统计能量分析理论及软件概况进行了阐述，其次应用该软件对海洋核动力平台进行几何建模与仿真计算。通过对舱室仿真计算结果与标准指标要求的对比分析，在设计阶段提出了海洋核动力平台舱室空气噪声综合治理降噪方案，该措施可以缩短建造周期、降低制造成本，提高海洋核动力平台的舒适性与安全性，具有十分重要的经济效益和社会效益。     

A signal decomposition method based on repeated extraction of maximum energy component for offshore structures

Contrary to most signal decomposition methods that usually decompose an original signal into a series of components simultaneously, a novel approach based on repeated extraction of Maximum Energy Component (MEC) is proposed. The approach starts from determination of the MEC referring to the estimated Power Spectral Density (PSD) function, and then represents the MEC by employing an exponential function to fit the original signal. By defining a stopping criterion based on two adjacent estimated PSDs, each MEC can be accurately extracted with an improved performance throughout the entire signal decomposition. To verify the proposed method, a single degree-of-freedom system subject to harmonic loads has been examined. Numerical results show that the analytical response can not only be decomposed into four MECs corresponding to the excitation and the system, respectively, but also provide an accurate estimation of natural frequency and damping ratio of the system. Meanwhile, by observing results from the Ensemble Empirical Mode Decomposition (EEMD), Variational Mode Decomposition (VMD) and Prony based on state-space model (Prony-SS), an improved decomposition accuracy has been achieved from the proposed approach. Furthermore, experimental data from the Norwegian Deepwater Programme and two sets of field-test data from one fixed offshore platform and an offshore wind turbine have been used to demonstrate the correctness of the developed signal decomposition method. It is noted that divergence in results by Prony-SS can be observed when a very large model order is used, while the proposed method provides the better decomposition and reconstruction of signals.     

散货船舱口盖剩余强度

通过对散货船舱口盖极限强度的理论分析，采用了正交各向异性板及刚塑性模型进行了理论上的推导，并对7万t散货船的1号舱的舱口盖(两块对称滚动式)，进行了ILL66及IACS URS21(1998年版与上述ILL66的88议定书中载荷的量级相当)的外载荷的比较及线性和非线性的有限元分析。本文所采用的有限元的线性及弹塑性计算对实际的舱口盖进行评估的结果证明，IACS URS21(ILL66的88议定书)的标准比ILL66的标准有所提高。采用非线性有限元法是在初始设计阶段使用的可行方法。这些结果可供规范研制工作参考。     

Time-series analysis of remote-sensed chlorophyll and environmental factors in the Santa Monica–San Pedro Basin off Southern California

The time-series of remote-sensed surface chlorophyll concentration measured by SeaWiFS radiometer from September 1997 to December 2001 and the relevant hydrological and meteorological factors (remote-sensed sea surface temperature, atmospheric precipitation, air temperature and wind stress) in Santa Monica Bay and adjacent waters off southern California were analyzed using wavelet and cross-correlation statistical methods. All parameters exhibited evident seasonal patterns of variation. Wavelet analysis revealed salient long-term variations most evident in air temperature during El Niño 1997–1998 and in wind stress during La Niña 1998–1999. Short-period (<100 days) variations of remote-sensed chlorophyll biomass were mostly typical to spring seasons. Chlorophyll biomass was significantly correlated with air temperature and wind stress: an increase of chlorophyll biomass followed with 5–6-day time lag an increase of wind stress accompanied by a simultaneous decrease of air temperature. The mechanism of these variations was an intensification of phytoplankton growth resulting from the mixing of water column by wind stress and entrainment of nutrients into the euphotic layer.     

微机控制的船用发电机继电保护实验装置

由于微机控制的继电保护与常规保护比较起来有许多优点,因此微机控制的船用发电机继电保护实验装置有其取代原有实验装置的必要性。本文就微机控制的船用发电机继电保护实验装置的硬件结构、软件算法和软件抗干扰技术进行了探讨。     

几种常见形式的等效阶梯截面

针对许多平面杆系桥梁分析软件仅提供梯形分块法的截面尺寸输入方式和截面几何特性已知或者有解析表达式的带有曲边的截面不便直接使用梯形分块法的问题，利用桥梁结构平面计算中截面等效的概念．提出了等效算法，构造了节线数不多于6的等效阶梯截面，推导了等效阶梯截面几何要素的一般计算公式．给出了圆形、圆环等几种常用截面形式的不多于6条节线等效阶梯截面尺寸计算的具体而又简捷的公式。     

采用双钓鱼法吊装侯家沟大桥箱梁

根据侯家沟大桥特殊的地形状况，选用最合理、最经济的吊装方案，进行大桥的箱梁吊装。     

深水导管架滑移下水轨迹的计算与分析

导管架由驳船上滑移下水，首先在倾斜的驳船上由外力（液压缸或绞车）推动克服滑靴与滑道间的静摩擦力，其后在倾斜的滑道上靠自身重力的作用滑移，最后通过下水驳船的摇臂滑入水中。在此过程中，应考虑到导管架的运动轨迹是否安全稳定（如导管架和泥面的安全间隙）、导管架是否以安全的方式脱离摇臂、导管架最终的漂浮位置是否稳定以及驳船的倾角等方面。采用时域分析法对导管架重心的轨迹进行计算和分析。     

后张法预应力混凝土箱梁制造质量过程控制

为满足《时速 2 0 0km新建铁路线桥隧站设计暂行规定》要求 ,秦沈客运专线在我国铁路建设中首次采用双线整孔箱形梁和单线并置式箱形梁。在总结实践经验的基础上 ,简要阐述箱梁制造的全过程以及影响箱梁制造质量的因素 ,提出控制箱梁制造质量的方法及采取的措施。