船舶轴系校中计算中优化算法的应用

本文以常见船舶轴系布置为基础,建立轴系校中计算数学模型,采用智能微群优化算法数值求解该数学模型。并对某3000吨级海监船进行轴系校中计算,结果表明智能微群优化算法求解出的轴系校中参数满足中国船级社相关规定的要求,该方法可以在轴系校中计算中推广使用。     

基于正交设计的船用柴油机燃烧系统参数匹配及优化

为研究柴油机燃烧系统参数匹配对柴油机动力和排放性能的影响,首先分别利用AVL_BOOST和AVL_FIRE仿真软件建立4190ZLC-2型船用柴油机整机模型和缸内燃烧高压循环模型,然后基于已建模型应用正交试验设计方法安排柴油机进气系统、喷油系统和燃烧室结构尺寸参数匹配仿真计算。研究结果表明,通过极差分析可以得出燃烧系统参数对4190ZLC-2型柴油机性能的影响主次顺序。以柴油机指示功率为评价指标时,参数组合0.26 mm-28°CA-160°-0.9-145 mm-2.6 mm-22 mm(喷孔直径-喷油提前角-油束夹角-涡流比-喉口直径-凸台高度-凹坑半径)对应的指示功率为63.40 k W,比原机仿真值高15%;以NOX排放为评价指标时,参数组合0.30 mm-24°CA-140°-0.4-135 mm-6.6 mm-14 mm(喷孔直径-喷油提前角-油束夹角-涡流比-喉口直径-凸台高度-凹坑半径)对应的NOX排放质量分数为0.015 7%,比原机仿真值低30.2%。     

Structural Optimization and Strength Analysis of the Lifting Arm of a Wet Shotcrete Spraying Unit北大核心CSCD

Wet shotcrete spraying units are widely used in underground engineering, for railways, highways, water conservancy and hydropower stations, municipal works, mining and military and other industries. Structural analysis and mechanical behavior optimization are conducted regarding the lifting arm of a TKJ series shotcrete spraying unit, and optimization of the hinge point position and working scope of the lifting arm is realized. The optimal layout scheme for the hinge force is given based on the Monte Carlo method, the hinge force of the lifting arm is improved for the mean and maximum values, and the maximum and average hinge force of the lifting cylinder decrease by 23.14% and 7.70%, respectively, compared with that of the original scheme. The static strength is checked using Ansys-Workbench for the optimized scheme, and the results show that the optimized scheme has a larger safety re-serve and that the structural design is more reasonable than the original scheme. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Large-scale evacuation network optimization: a bi-level control method with uncertain arterial demand

To improve the efficiency of large-scale evacuations, a network aggregation method and a bi-level optimization control method are proposed in this paper. The network aggregation method indicates the uncertain evacuation demand on the arterial sub-network and balances accuracy and efficiency by refining local road sub-networks. The bi-level optimization control method is developed to reconfigure the aggregated network from both supply and demand sides with contraflow and conflict elimination. The main purpose of this control method is to make the arterial sub-network to be served without congestion and interruption. Then, a corresponding bi-objective network flow model is presented in a static manner for an oversaturated network, and a Genetic Algorithm-based solution method is used to solve the evacuation problem. The numerical results from optimizing a city-scale evacuation network for a super typhoon justify the validity and usefulness of the network aggregation and optimization control methods.     

Preliminary investigation of PM1, PM2.5, PM10 and its metal elemental composition in tunnels at a subway station in Shanghai,China

In this study, real-time monitoring campaigns were conducted in two tunnels (Line A and Line B) at a subway station in Shanghai, including temperature, relative humidity, PM₁, PM_2.5 and PM₁₀, in order to understand the climate and PM characteristics in the transportation microenvironment. In addition, collected floor dust particles in the tunnel were analyzed by ICP for their metal elemental composition. Strong correlations occurred between all PM levels and meteorological parameters in the tunnel of Line A (with platform screen doors), in comparison with the weak correlations between such parameters in the tunnel of Line B (without platform screen doors). PM_2.5 and PM₁₀ between peak hours and off-peak hours for both lines presented significant differences (p < 0.05), respectively. Nevertheless, PM₁ showed a different pattern, with p > 0.05 for Line A and p < 0.05 for Line B, respectively. In addition, statistical results concluded that PM had an evident weekly variation for both lines. Friday was the highest day of all particulate matters in monitoring periods for both lines. Ratios of PM₁/PM₁₀ and PM_2.5/PM₁₀ were high when trains were out of service and low when trains were in service. Relative abundance of metal elements detected from floor dust particles proved that floor dust particles in tunnels might be a major source of airborne PM in the subway microenvironments, with Fe as the most abundant metal element, followed by Ca, Al, Mg, Mn, Zn, Cu, Cr, Ni, Pb and Hg.     

杭州公共自行车交通系统发展优化建议与思考

文章通过大量的信息调研,综合分析了杭州市公共自行车交通系统(PBS)的运营现状及存在的问题,提出了拓宽非机动车道、服务点规模等级化、站点设施结构智能化、换乘系统综合化的公共自行车交通系统发展优化建议。     

An Optimization Model for Guiding Pedestrian–Vehicle Mixed Flows During an Emergency Evacuation

In most metropolitan areas, an emergency evacuation may require a potentially large number of pedestrians to walk some distance to access their passenger cars or resort to transit systems. In this process, the massive number of pedestrians may place a tremendous burden on vehicles in the roadway network, especially at critical intersections. Thus, the effective road enforcement of the vehicle and pedestrian flows and the proper coordination between these two flows at critical intersections during a multimodal evacuation process is a critical issue in evacuation planning. This article presents an integrated linear model for the design of optimized flow plans for massive mixed pedestrian–vehicle flows within an evacuation zone. The optimized flow can also be used to generate signal timing plans at critical intersections. In addition, the linear nature of the model can circumvent the computational burden to apply in large-scale networks. An illustrating example of the evacuation around the M&T Bank Stadium in downtown Baltimore, MD, is presented and used to demonstrate the model's capability to address the complex interactions between vehicle and pedestrian flows within an evacuation zone. Results of simulation experiments verify the applicability of our model to a real-world scenario and further indicate that accounting for such conflicting movements will yield more reliable estimation of an evacuation's required clearance time.     

铁路数字通信传输网络优化浅谈

以宝成线数字通信传输网络的部分优化工程为例,说明数字通信传输网络的优化方案,以满足业务开通、安全等方面的需求。     

北京通信段管内部分传输网络优化

北京铁路局管内京哈、津山、津秦沈等铁路,承担着大量客货运输任务。但该线路通信设备陈旧,处理能力不足。为此,分析北京铁路局重要干线的通信传输网络问题,利用新增传输设备,完成优化整改,提高网络安全性。     

哈飞路宝正面碰撞安全性车身优化设计

针对哈飞路宝轿车车身设计的具体要求,建立了用于碰撞分析的整车车身结构简化有限元模型,并利用该模型对车身前部结构的几种设计方案进行了选择分析。利用计算机模拟技术对整车车身结构的有限元模型进行了模拟碰撞分析。模拟结果与实车碰撞试验结果的对比表明,所采用计算方法和模拟过程正确,提出的优化设计方案可以提高该轿车产品的被动安全性。