潜艇均衡系统自流注水调节阀稳态噪声试验研究

本文模拟建立了潜艇均衡系统自流注水试验系统,对不同假海压力、不同系统流量、不同出口背压及串联2台调节阀时自流注水稳定过程振动噪声进行研究。结果表明:潜艇均衡注水振动噪声随着假海深度的增大而增大;空气噪声随流量调节阀开度的增大而增大,在流量调节阀开度为60°-70°之间,振动加速度及水动力噪声产生峰值;在出口背压为0-0.5 MPa之间时,振动噪声值均大于无背压状态,峰值为0.2 MPa;串联2台流量调节阀可大幅降低自流注水振动噪声。     

浅谈FAS双中心建设及设备维护

重点分析了西安局集团公司由2K数调主系统组网更新改造为FAS双中心网络的建设方法,并根据日常维护经验,列举了调度台通道故障处理、FASB简易故障判断及计表倒换试验、FASA和FASB系统与MSC之间的业务故障处理等.     

公路建设项目征地拆迁补偿费用确定与控制方法研究

文中以广东省公路建设项目征地拆迁费用的确定为例,以现行实施的征地拆迁补偿相关规定为基础,探讨征地数量和标准的计量、计算方法,建立征地拆迁标准动态数据库,以期对征地拆迁费用的确定和控制提供思路和实际操作指导。     

考虑横向漂移的船舶路径跟踪自抗扰控制

针对船舶运动系统中内部动态不确定和外部干扰等问题,进行了欠驱动船舶路径跟踪的自抗扰方法研究。利用Backstepping设计参考航向角,并通过线性扩张状态观测器对流干扰和横向运动引起的横向漂移进行估计。其次,根据自抗扰算法对航向进行控制,采用线性扩张状态观测器对外界干扰及内部不确定项进行估计。最后仿真结果表明,在风流干扰下所设计的控制器仍能使船准确地跟踪上参考路径,验证了所提控制方案的有效性。     

基于计算机自动控制技术的多探头测深系统研制与改造

通过加装控制盒的方式,实现单探头测深仪与自动控制探头之间的流畅切换,将传统单探头测深仪改造成具有多探头功能的高效水下测量仪器系统,主要用于航道和码头基床等的水下扫测。利用该系统进行的码头基床扫测已经取得成功,可为同类测量设备的改造提供全新的思路。     

Vehicle platoon formation using interpolating control: A laboratory experimental analysis

This work addresses the formation phase of automatic platooning. The objective is to optimally control the throttle of vehicles, with a given arbitrary initial condition, such that desired ground speed and inter-vehicular spacings are reached. The steering of the vehicles is also controlled, because the vehicles should track a desired path while forming the platoon. In order to address the platoon formation problem, a cooperative strategy is formed by constructing a discrete state space model which represents the dynamics of a set of n vehicles. Once this model is set, a control method known as Interpolating Control, which aims at regulating to the origin an uncertain and/or time-varying linear discrete-time system with state and control constraints, is utilized. The performance of this control method is evaluated and compared with other approaches such as Model Predictive Control (MPC).Simulations are conducted which suggest that the Interpolating Control approach can be seen as an alternative to optimization-based control schemes such as Model Predictive Control, especially for problems for which finding the optimal solution requires calculations, where the Interpolating Control approach can provide a straightforward sub-optimal solution.In the experimental part of this work, the control algorithms for the platoon formation and path tracking problems are combined, and tested in a laboratory environment, using three mobile robots equipped with wireless routers. Validation of the proposed models and control algorithms is achieved by successful experiments.     

Model based urban traffic control,part II: Coordinated model predictive controllers

The present paper describes how to use coordination between neighbouring intersections in order to improve the performance of urban traffic controllers. Both the local MPC (LMPC) introduced in the companion paper (Hao et al., 2018) and the coordinated MPC (CMPC) introduced in this paper use the urban cell transmission model (UCTM) (Hao et al., 2018) in order to predict the average delay of vehicles in the upstream links of each intersection, for different scenarios of switching times of the traffic lights at that intersection. The feedback controller selects the next switching times of the traffic light corresponding to the shortest predicted average delay. While the local MPC (Hao et al., 2018) only uses local measurements of traffic in the links connected to the intersection in comparing the performance of different scenarios, the CMPC approach improves the accuracy of the performance predictions by allowing a control agent to exchange information about planned switching times with control agents at all neighbouring intersections. Compared to local MPC the offline information on average flow rates from neighbouring intersections is replaced in coordinated MPC by additional online information on when the neighbouring intersections plan to send vehicles to the intersection under control. To achieve good coordination planned switching times should not change too often, hence a cost for changing planned schedules from one decision time to the next decision time is added to the cost function. In order to improve the stability properties of CMPC a prediction of the sum of squared queue sizes is used whenever some downstream queues of an intersection become too long. Only scenarios that decrease this sum of squares of local queues are considered for possible implementation. This stabilization criterion is shown experimentally to further improve the performance of our controller. In particular it leads to a significant reduction of the queues that build up at the edges of the traffic region under control. We compare via simulation the average delay of vehicles travelling on a simple 4 by 4 Manhattan grid, for traffic lights with pre-timed control, traffic lights using the local MPC controller (Hao et al., 2018), and coordinated MPC (with and without the stabilizing condition). These simulations show that the proposed CMPC achieves a significant reduction in delay for different traffic conditions in comparison to these other strategies.     

基于基准有限元模型的箱梁TMD振动控制研究

针对高架桥梁结构引起的振动噪声问题,研究TMD控制箱梁结构振动的特性。为了获得精准的箱梁有限元模型,首先以铁路32 m简支箱梁桥为原型,按10:1的几何相似比设计制作简支箱梁缩尺试验模型,应用ANSYS软件建立初始动力有限元模型;对有限元模型模态分析与试验模型模态测试得到的自由模态信息进行误差分析,并采用基于灵敏度分析的模型修正技术对初始动力有限元模型弹性模量和密度进行修正,得到基准有限元模型,误差确认结果显示修正后的有限元模型更精准地反应箱梁的振动特性;进一步利用基准有限元模型,开展TMD控制简支箱梁桥振动的研究,研究结果表明TMD对于抑制桥梁竖向共振有很好的效果。