大断面水下盾构隧道管片接头抗弯刚度及其对管片内力影响研究

以大断面水下铁路盾构隧道-狮子洋隧道工程为研究对象,运用有限元数值分析方法,并结合管片接头原型抗弯试验,研究环向管片接头抗弯刚度,并运用梁-弹簧模型进行接头抗弯刚度对整环管片结构内力影响的研究.结果表明:该隧道管片接头抗弯刚度的取值范围为50～700MN·m·rad-1,在相同轴力条件下,接头抗弯刚度会随接头弯矩的增加降低1个数量级左右;在相同接头弯矩条件下,接头抗弯刚度随轴力的增加而增大;接头抗弯刚度对管片轴力分布的影响微弱,对管片弯矩的影响显著;随接头抗弯刚度的增大,整环管片的弯矩分布趋于均匀;在抗弯刚度取值范围内,极值弯矩相差最大达80％左右,极值轴力最大减小5％左右,变形最大减小20％左右;基于接头抗弯刚度-弯矩-轴力的非线性关系改进的梁-弹簧模型,更能体现接头对整环管片受力的影响,也更适用于大断面盾构隧道管片内力的计算.     

Numerical investigation of turbulence near a sheared air–water interface. Part 1: Turbulence statistics beneath a flat water surface sheared by wind

Direct numerical simulation (DNS) and large eddy simulation (LES) of turbulent shear flow beneath a flat water surface with imposed wind shear stress are presented. The results of DNS indicate that there are clear differences, and also similarities, between wind-driven flow and the flow near a solid wall. The qualitative structures of turbulence are similar in both types of flow. Low-speed streaks are also present in wind-driven flow. On the other hand, profiles of the mean velocity and turbulence intensities in wind-driven flow are significantly different from those in flow near a solid wall. The differences are attributed to the lack of a viscous sublayer, and to the boundary condition which allows fluctuations of the tangential velocity components at the boundary. LES of the same flow was also carried out to evaluate subgrid-scale models. It was shown that the features of the flow observed in DNS are well simulated by all models tested, and that the discrepancies between DNS and LES with the dynamic mixed model are very small. Received: August 17, 2000 / Accepted: December 22, 2000     

Inhomogeneous wave load effects on a long,straight and side-anchored floating pontoon bridge

In this paper, we present a numerical study on the hydroelastic response of a 4.6 km long fjord crossing floating bridge subjected to wave loads. The bridge is straight in design and supported by 35 pontoons along its full length. To limit the response to horizontal loads, four clusters of deep water mooring lines are engaged to increase the transverse stiffness of the bridge. Owing to the very large span across the fjord, inhomogeneity in the wave field exists. This study examines the various effects of inhomogeneous wave loads on the dynamic responses of the floating bridge. These include the spatial variations of the wave direction, significant wave height and peak period as well as the coherence and correlation of waves along the entire length of the floating bridge. For the purpose of comparison, the dynamic bridge responses under homogeneous wave load cases are also studied. In addition, the effects of wave load components and short-crestedness are presented and discussed.     

不同冷却方式对大尺寸钢板感应加热成形的影响

为有效解决船用中厚钢板复杂曲面加工问题,本文探究了空气冷却、正面水冷和反面水冷方式对大尺寸钢板弯曲成型的影响因素。首先采用COMSOL Multiphysics仿真平台模拟了电磁感应加热和冷却变形多物理场同步耦合过程,然后分析了各种因素对大尺寸钢板弯曲成型影响,最后通过实验验证了有限元模型的可靠性,并对感应加热弯曲成型效果进行评估。研究结果表明:(1)相对于水冷,空冷对钢板Y向位移改变效果显著。(2)相对于空冷,水冷对钢板角位移的改变影响明显。(3)当频率为50kHz时,电流频率对表面温度和角位移影响显著。(4)当钢板长宽比≥1:2时,Y向位移的增加比较显著;当长宽比≈1:1时,角位移的改变比较明显。     

关角特长隧道GSM-R系统设计

简要介绍基站和光纤直放站的工作原理,针对西格二线关角特长隧道提出GSM-R系统解决方案,并阐述了光纤直放站在铁路通信中的重要作用。     

高速铁路上郭关隧道施工遭遇大型溶洞的处理方案研究

高速铁路上郭关隧道在施工中遭遇了大型溶洞,溶洞由6个形态各异的溶洞大厅组成,有必要研究既安全又经济的溶洞处理方案。首先根据溶洞大厅的大小与位置,设计现浇套拱衬砌支顶、埋设钢筋混凝土管涵与施作护墙支挡3种处理方案;然后数值模拟不处理溶洞、处理溶洞、处理溶洞并考虑水渗流影响等情况,对比多种工况下的隧道受力变形,分析溶洞处理效果,并提出施工建议;最后将溶洞处理方案应用于工程实践。结果表明:隧道变形在安全范围内,隧道顺利通过岩溶区,证明采取的溶洞处理方案切实可行。     

兰渝铁路杨家坪隧道1号横洞工区大变形成因机制探析

通过分析成兰铁路杨家坪隧道1号横洞工区的地层岩性、地质构造、地应力场、工程地质条件及工程设置、施工组织顺序等的基础上,研究1号横洞工区大变形产生的成因机制。结果表明:杨家坪隧道1号横洞工区大变形的产生是各种影响因素共同作用的结果;复杂的地质构造及高地应力条件和软弱破碎的地层岩性条件为其大变形客观成因,而岩层结构面与洞轴线的不利组合、小间距隧道结构和不合理的施组顺序及左右线不对等的支护措施等不利条件为其主观成因。与大变形的主客观成因相对应,其力学机制主要呈现为应力扩容型的构造应力机制和结构变形型的结构面型机制的混合机制。     

Integrated design optimization of spar floating wind turbines

A linearized aero-hydro-servo-elastic floating wind turbine model is presented and used to perform integrated design optimization of the platform, tower, mooring system, and blade-pitch controller for a 10 MW spar floating wind turbine. Optimal design solutions are found using gradient-based optimization with analytic derivatives, considering both fatigue and extreme response constraints, where the objective function is a weighted combination of system cost and power quality. Optimization results show that local minima exist both in the soft-stiff and stiff-stiff range for the first tower bending mode and that a stiff-stiff tower design is needed to reach a solution that satisfies the fatigue constraints. The optimized platform has a relatively small diameter in the wave zone to limit the wave loads on the structure and an hourglass shape far below the waterline. The shape increases the restoring moment and natural frequency in pitch, which leads to improved behaviour in the low-frequency range. The importance of integrated optimization is shown in the solutions for the tower and blade-pitch control system, which are clearly affected by the simultaneous design of the platform. State-of-the-art nonlinear time-domain analyses show that the linearized model is conservative in general, but reasonably accurate in capturing trends, suggesting that the presented methodology is suitable for preliminary integrated design calculations.     

浮冰冲击作用下的乙烯运输船体 舷侧结构强度分析

对无限航区的21000m3乙烯运输船舷侧结构,分别采用纵骨架式和横骨架式冰区加强设计。根据FSICR规范要求,更新舷侧冰带区域内构件尺寸,并针对艏部冰带区域内船体结构,分别建立了原始的、纵骨架式的和横骨架式的冰带结构设计有限元模型。通过强度计算,认为艏部冰带区新结构满足规范设计载荷要求。在此基础上,单独建立艏货舱冰区舷侧外板板架有限元模型,研究两种新设计形式适用的外板在更大浮冰冲击载荷作用下塑性变形。计算结果表明:纵骨架式结构外板塑性变形明显低于横骨架式。     

采用C型独立液货舱的超大型乙烷运输船(VLEC)研究

美国的页岩气繁荣发展在中短期内将造成乙烷供应的不断增长,将带来对欧洲及亚洲地区大宗出口的机遇;而全球乙烷运输需求的增长和船东对船舶经济性要求的提高,让超大型乙烷运输船(VLEC)应运而生。论文对VLEC的船型方案进行了比较分析,重点研究采用C型独立液货舱围护系统的VLEC的液罐设计方法,通过对采用碟形封头的总舱容为81 500 m3和采用球形封头的总舱容为75 500 m3的VLEC船型进行方案设计和研究,论证了论文提出的采用C型独立液货舱的超大型乙烷运输船这一方案的可行性。