自升式起重平台站立工况总体特性研究

采用有限元计算方法针对起吊能力800t的自升式起重平台站立状态在设计环境载荷作用下的桩腿强度、桩靴支反力、锁紧装置承载力、抗倾稳性及风、浪、流载荷影响因子等内容进行了分析研究,结果表明环境载荷作用方向90°时,桩腿UC值(实际应力与许用应力之比值)最大,对平台桩腿结构最为不利;风、浪载荷对桩腿UC值影响颇大,正确计算风、波浪载荷对平台结构安全评估有重要意义。     

余弦载荷作用下圆锥壳的动力屈曲研究

本文采用数值方法对圆锥壳在余弦载荷作用下的动力屈曲问题进行了探讨.利用非线性几何方程建立了锥壳的基本动力屈曲方程.采用级数展开和伽辽金法等方法对方程进行了简化,使之成为常微分方程.方程的求解则采用龙格库塔法,最后给出临界冲击载荷值.     

Numerical study on the dynamic response of a truncated ship-hull structure under asymmetrical slamming

Dynamic response of ship-hull structure under slamming has tracked widespread attention in the marine structural design. However, our understanding on the dynamic characteristics largely relies on the symmetrical slamming cases. This paper presented a preliminary numerical investigation on the dynamic response of a truncated ship-hull structure under asymmetrical slamming based on the uncoupled CFD-FE method. Asymmetrical slamming loads were predicted through combining the seakeeping analysis and CFD method. In there, three kinds of motions (vertical, horizontal and roll motions) of 2D ship sections were obtained through the seakeeping analysis and then the slamming pressure was predicted through simulating the water entry with various motions based on CFD method. The dynamic response was analyzed through finite element method. Numerical predictions including ship motions, slamming loads and dynamic analysis were validated against published experimental data and numerical calculations. The characteristics of asymmetrical slamming loads were analyzed showing obvious asymmetry in space, and the dynamic characteristic of the ship bow structure was further clarified through discussing the deformation and stress distribution. These results are useful for readers for better understanding the dynamic characteristics of the bow structure under slamming.     

Dynamic response of stiffened plate under internal blast: Experimental and numerical investigation

Stiffened plates are the basic units of ships, aircraft and other structures. The purpose of this paper is to investigate the dynamic response of stiffened plates under internal blast loading. A combined experimental and numerical investigation was carried out on the cabin structures with unstiffened, single-stiffened and double-stiffened plates. The characteristics of internal blast wave, the effects of stand-off distance and the stiffener position on the deflection and failure modes of stiffened plates were sequentially analyzed. It was interestingly found that the deflection first decreased and then increased with the increase of stand-off distance. Additionally, despite of the reinforcement on the deformation resistance, the stiffeners tended to reduce the damage tolerance of the target plates. This research provides the basic data and theoretical support for the blast resistance design of ships, aircraft and other structures.     

Fatigue damage estimation in non-linear systems using a combination of Monte Carlo simulation and the First Order Reliability Method

For non-linear systems the estimation of fatigue damage under stochastic loadings can be rather time-consuming. Usually Monte Carlo simulation (MCS) is applied, but the coefficient-of-variation (COV) can be large if only a small set of simulations can be done due to otherwise excessive CPU time. The reason is that the fatigue damage estimation is very sensitive to the largest values from the simulations. The paper suggests the additional use of the First Order Reliability Method (FORM) to get a better estimation of the tail in the distribution of the estimated fatigue damage and thereby reducing the COV. For a specific example dealing with stresses in a tendon in a tension leg platform the COV is thereby reduced by a factor of three.     

Dynamic behavior of scaled tubular K-joints subjected to impact loads

This paper examines the dynamic behavior of the tubular K-joints in offshore platforms by means of experimental and numerical studies. The structural response is studied through Falling Weight Impact Tester(FWIT) with three different falling heights. A non-direct similitude method is developed and applied to the scaled K-joint models. The experimental results, including final deformed shapes and impact force responses, are reported to be useful for further benchmark studies. The finite element models are then developed by commercial software LS-DYNA, where nonlinear material properties are considered based on the corresponding tensile tests. Good correspondence between the numerical and experimental results is achieved, and relevant sensitivity analyses of numerical results are carried out to verify the reliability of the numerical models. Finally, the influence of the strain-rate definition and the reliability of the similarity are discussed. In general, the impact response in the present study is significantly dependent on the definition of dynamic material characteristics. The results obtained from Cowper-Symonds model with constants derived from the dynamic tensile test yield a good estimation when compared with the experimental results. Besides, scaled models tend to obtain un-conservative prediction results, and the developed non-direct similitude method is appropriate for the application.     

高速船突发载荷的结构响应的近期研究

本文讨论有关于高速船对突发载荷的结构响应的近期研究，评述了世界各国对高速船的碰撞，搁浅，冲击，爆炸等突发载荷时结构的响应方面的研究进展和动态。文中对采用FRP复合材料或夹心析制造的高速船方面的研究作了特别的关注和研讨。     

调速装置的模拟负载系统

在工程中,调速装置所拖动的负载性质是多种多样的,为了研究和试验需要拖动榭以负载,而常规的模拟负载则满足不了要求。本文提出了一种能满足各种工况且能节省能耗的模拟负载系统及其动态参数的计算方法.     

桥梁极限承载力研究现状与发展

结合沪宁高速公路扩建改造工程中桥梁极限承载力的（破坏性）试验研究,对目前桥梁极限承载力研究的国内外现状进行了总结,归纳了模型试验、实桥试验和理论分析等方面的主要研究成果。在此基础上指出了当前桥梁极限承载力研究中存在的主要问题,并提出了该领域未来的研究方向。     

基于连续梁模型的内燃机曲轴载荷计算

以连续梁作为内燃机曲轴的计算模型，以克服简支梁模型由于简化而无法考虑一些较为重要的载荷的缺点，此模型可用于分析曲轴所受轴颈和轴承载荷，任意截面弯矩、扭矩以及这些载荷在一个工作循环中的变化情况。给出了对一种１６缸四冲程Ｖ型柴油机曲轴载荷的算例。