广西普通高等教育经费来源结构的变化与分析——以2001-2011年教育经费统计数据为例

近十年来，广西普通高等教育经费来源结构已呈现出多元化趋势。但是普通高等教育经费总量仍显不足；经费来源结构不尽合理，二元格局明显；科研经费拨款所占比例过小；过于依赖学杂费的增加。广西高等教育未来发展所需的经费保障，要求必须真正实现经费来源的多元化。     

Detection of nonlinearity effects in structural integrity monitoring methods for offshore jacket-type structures based on principal component analysis

The detection of changes in the dynamic behavior of structures is an important issue in structural safety assessment. The development of detection methods assumes greater significance in the case of offshore platforms because the inherent problems are compounded by the harsh environment. Here, we describe an instrumented physical model for the structural health monitoring of an offshore jacket-type structure and the results of tests in several different damage scenarios. In a comparative investigation of two different methods, we discuss the difficulties of implementing damage detection techniques for complex structures, such as offshore platforms. The combined algorithm of a fuzzy logic system and a model updating method are briefly discussed, and a method based on stochastic autoregressive moving average with exogenous input is adopted for the structure. The consideration of uncertainties and the effects of nonlinearity were major objectives. So, the methods were also investigated based on the test scenarios consisting of the physical model with a geometric nonlinearity. The principal component analysis method was utilized for the detection of nonlinearity in the recorded data. The results show that the developed methods are suitable for damage classification, but the quality of the acquired signals must be considered an important factor influencing successful classification. The development of these methods may be extremely useful, as such technologies could be applied for offshore platforms in service, enabling damage detection with fewer false alarms.     

潮位变化对上海某越江盾构隧道变形的影响规律研究

为了探究潮位变化与越江盾构隧道的沉降和收敛变形之间的关联性,采用数据统计分析、相关性分析和周期性分析方法,对上海某越江盾构隧道的监测数据与同时期隧道上部的潮位变化进行研究分析。研究表明:1)江中段隧道在潮位变化的作用下产生均匀沉降,其波动性与潮位起伏具有近似的周期性;2)陆域段隧道沉降变化的波动性程度与河流的距离有关;3)潮位变化引起隧道管片断面的横径和竖径产生循环的收敛变形,其横径收敛变形大于竖径收敛变形。以上研究可为越江盾构隧道设计、施工和运维提供参考。     

大断面异形盾构隧道弯矩传递系数原型加载试验研究

由于异形盾构隧道特殊的结构断面型式,管片设计暂无相关规范可循,故基于原型三环管片力学加载试验对异形盾构管片环向接头弯矩传递系数进行研究,研究结果表明:1)随埋深增加,异形盾构管片结构整体刚度提升,但由于各接头刚度与相邻管片结构刚度比随埋深增加变化规律不一致,异形盾构管片接头弯矩传递能力呈部分减弱部分增强的现象;2)同埋深条件下,随着侧压力系数的增加,除右拱腰处接头外,其余接头弯矩传递能力随着接头刚度与相邻管片结构刚度比的增大而逐渐增强;3)随着埋深增加,各接头弯矩传递能力对侧压力系数的敏感程度逐渐减弱;4)极限破坏后,异形盾构管片内外弧面裂缝的分布规律证明了明显的弯矩传递现象。     

Direct yaw moment control and power consumption of in-wheel motor vehicle in steady-state turning

Driving force distribution control is one of the characteristic performance aspects of in-wheel motor vehicles and various methods have been developed to control direct yaw moment while turning. However, while these controls significantly enhance vehicle dynamic performance, the additional power required to control vehicle motion still remains to be clarified. This paper constructed new formulae of the mechanism by which direct yaw moment alters the cornering resistance and mechanical power of all wheels based on a simple bicycle model, including the electric loss of the motors and the inverters. These formulation results were validated by an actual test vehicle equipped with in-wheel motors in steady-state turning. The validated theory was also applied to a comparison of several different driving force distribution mechanisms from the standpoint of innate mechanical power.     

VVL耦合喷油策略对GDI汽油机混合气形成的影响

利用三维仿真软件Ansys Fluent建立了GDI汽油机的仿真计算模型,就变气门升程耦合不同喷油策略对缸内气流运动和混合气形成的影响进行了模拟计算。结果表明,与大气门升程工况相比,小气门升程工况的缸内湍流运动强度、燃油蒸发和湿壁情况以及点火时刻混合气质量都明显改善;在小气门升程工况,采用两段喷油会缩短油气混合时间,过度推迟二次喷油时刻会恶化混合气质量和燃油湿壁情况;在大气门升程工况,两段喷油会改善混合气均匀性,随着二次喷油时刻推迟,燃油蒸发量增加,湿壁情况加剧,混合气质量得到改善;小气门升程工况下采用二次喷油时刻为470°曲轴转角,前后两次喷油量比例为7∶3的两段喷油方案在燃油蒸发和湿壁以及点火时刻缸内混合气质量这几个方面的效果都很好,是最合理的方案。     

国Ⅴ柴油机SCR系统结构对尿素结晶影响研究

针对某国Ⅴ商用柴油车SCR系统中出现的结晶问题,综合应用CFD模拟和台架试验进行分析研究,提出一系列结构优化和改进方案,改善了SCR前流场状态以及流体的流动均匀性和尿素均匀性,基本消除了排气系统在实际工况下的结晶风险,提高了全系统的抗结晶能力,保证了SCR系统的正常运行。通过对模拟结果和台架试验数据的比对分析,研究了流场分布以及混合器结构对结晶形成产生的影响。     

桥面铺装复合梁的有限元分析

采用三维有限元法,分析了复合梁试件模型和实体桥面铺装模型中沥青混凝土铺装层表面的受力特性及其变化趋势。计算结果表明,复合梁模型和实体桥面铺装模型中的沥青铺装层表面的受力状态相同,变化趋势一致,采用试验可控性较好的复合梁试验能够模拟不同结构组合的桥面铺装层受力特性,为大跨径桥梁桥面铺装层结构设计、材料选择提供依据。     

现浇预应力混凝土连续箱梁桥设计

结合某主线上一座2×30 m现浇连续预应力混凝土葙梁桥的工程实例,较详尽的介绍了该桥的设计和构造特点、上部结构计算及上下部构造设计,并结合实际针对设计时应考虑的一些因素进行了较详细的探讨.     

A data model applied to the knowledge-based ICAS

Image-guided computer aided surgery system (ICAS) contributes to safeness and success of surgery operations by means of displaying anatomical structures and showing correlative information to surgeons in the process of operation. Based on analysis of requirements for ICAS, a new concept of clinical knowledge-based ICAS was proposed. Designing a reasonable data structure model is essential for realizing this new concept. The traditional data structure is limited in expressing and reusing the clinical knowledge such as locating an anatomical object, topological relations of anatomical objects and correlative clinical attributes. A data structure model called mixed adjacency lists by octree-path-chain (MALOC) was outlined, which can combine patient's images with clinical knowledge, as well as efficiently locate the instrument and search the objects' information. The efficiency of data structures was analyzed and experimental results were given in comparison to other traditional data structures. The result of the nasal surgery experiment proves that MALOC is a proper model for clinical knowledge-based ICAS that has advantages in not only locating the operative instrument precisely but also proving surgeons with real-time operation-correlative information. It is shown that the clinical knowledge-based ICAS with MALOC model has advantages in terms of safety and success of surgical operations, and help in accurately locating the operative instrument and providing operation-correlative knowledge and information to surgeons in the process of operations.