辛泰线危岩落石整治

针对辛泰线危石、落石实际情况,结合《铁路路基设计规范》等相关规范、规则对产生危石、落石的原因进行分析并提出相应的综合整治措施。     

贵阳机场岩溶洼地填筑体变形与稳定性数值模拟

以贵阳龙洞堡国际机场试验段工程为例对岩溶洼地填筑体变形及稳定性进行数值模拟研究。研究结果表明:强夯对岩溶洼地地基土处理具有较好的效果,能有效降低填筑体的沉降量及边坡位移量;填筑体沉降量随着填筑体厚度减小而减小。     

Fault-tolerant control of heavy-haul trains

The fault-tolerant control (FTC) of heavy-haul trains is discussed on the basis of the speed regulation proposed in previous works. The fault modes of trains are assumed and the corresponding fault detection and isolation (FDI) are studied. The FDI of sensor faults is based on a geometric approach for residual generators. The FDI of a braking system is based on the observation of the steady-state speed. From the difference of the steady-state speeds between the fault system and the faultless system, one can get fault information. Simulation tests were conducted on the suitability of the FDIs and the redesigned speed regulators. It is shown that the proposed FTC does not explicitly worsen the performance of the speed regulator in the case of a faultless system, while it obviously improves the performance of the speed regulator in the case of a faulty system.     

Fault classification method for the driving safety of electrified vehicles

A fault classification method is proposed which has been applied to an electric vehicle. Potential faults in the different subsystems that can affect the vehicle directional stability were collected in a failure mode and effect analysis. Similar driveline faults were grouped together if they resembled each other with respect to their influence on the vehicle dynamic behaviour. The faults were physically modelled in a simulation environment before they were induced in a detailed vehicle model under normal driving conditions. A special focus was placed on faults in the driveline of electric vehicles employing in-wheel motors of the permanent magnet type. Several failures caused by mechanical and other faults were analysed as well. The fault classification method consists of a controllability ranking developed according to the functional safety standard ISO 26262. The controllability of a fault was determined with three parameters covering the influence of the longitudinal, lateral and yaw motion of the vehicle. The simulation results were analysed and the faults were classified according to their controllability using the proposed method. It was shown that the controllability decreased specifically with increasing lateral acceleration and increasing speed. The results for the electric driveline faults show that this trend cannot be generalised for all the faults, as the controllability deteriorated for some faults during manoeuvres with low lateral acceleration and low speed. The proposed method is generic and can be applied to various other types of road vehicles and faults.     

基于计算机自动控制技术的多探头测深系统研制与改造

通过加装控制盒的方式,实现单探头测深仪与自动控制探头之间的流畅切换,将传统单探头测深仪改造成具有多探头功能的高效水下测量仪器系统,主要用于航道和码头基床等的水下扫测。利用该系统进行的码头基床扫测已经取得成功,可为同类测量设备的改造提供全新的思路。     

汽车机械故障原因及防范措施

自中国改革开放以来我国的经济得到了飞速的提升,人们的生活质量和生活水平也在日新月异的变化,在现今时代汽车已经普及到了千家万户,成为了人们日常生活的必需品,也正因为如此汽车机械故障的原因及防范措施也逐渐受到了人们的关注,本文也就汽车故障产生的原因进行了分析,并寻找出相对应的解决策略.     

关于气动系统在汽车工装夹具上的应用探讨

本文基于汽车车身工装夹具基础内容展开分析,结合气动系统的基础组成和应用特征.通过研究气缸的应用、控制阀应用、气动三联件、管路应用、消声器应用等内容.其目在于明确气动系统的应用要点,为后续应用体系的完善奠定基础.     

DMIS系统的可靠性和安全性设计

介绍了DMIS(运输调度指挥管理信息)系统在可靠性和安全性方面的设计与实现。     

关于编组站四显示自动闭塞改造工程中咽喉区段信号机布置方案的讨论

本文通过分析实例，对在编组站四显示自动闭塞改造工程中的信号机布置方案提出改进建议，即通过缩短闭塞分区的长度并制定车场内正侧线股道上的信号机显示方案来提高车站的咽喉通过能力。     

浅谈青藏线转辙设备的养护与维修

本文根据CTS2轨枕式转辙机本身的特点以及青藏铁路的管理模式，从养护、维修的角度，简要说明了CTS2轨枕式转辙机需要的养护工作量、故障处理方法、维修特点及在施工中要注意的问题。