高强力复合土工布在软基路堤中的应用

本文结合工程实例介绍采用高强力复合土工布处理软土地基路堤的设计、施工与应用效果     

一种确定高圆簧横向刚度的有效方法

文中将高圆簧简化为等截面弹性直杆，导出高圆簧横向刚度计算式，并用试验结果进行修正，提出高圆横向刚度分析方法。理论分析和试验结果表明：高圆簧横向刚度的大小取愉于高圆簧的自由高度和工作高度，即由其结构几何参数和工作载荷决定。按文中方法确定的高圆簧横向刚度理论值与试验结果间的最大误差不超过１０％，满足工程理论分析要求。     

砂浆锚杆的有限元模拟方法探讨

针对现有砂浆锚杆有限元模拟方法的局限性与不足，在深入探讨砂浆锚杆的力学机理的基础上，提出了一种包含锚杆、砂浆以及接触面的新型复合锚杆单元，该单元不仅能反映锚杆的轴向受力作用，还能反映锚杆的抗弯以及锚杆与岩体接触面的剪切滑移效应，并利用有限元基本理论，推导了新型复合锚杆单元刚度矩阵及相关计算公式，并编制了相应的计算程序，工程实例分析表明：模型能够满足工程要求，具有一定的理论与工程实用价值。     

路堤荷载下管桩复合地基设计理论的试验研究

介绍了管桩复合地基在某高速公路软基试验工程中的应用,并简单分析了其加固效果,进而结合已有的研究成果,提出了一套路堤下刚性桩复合地基的设计理论。通过工程实践表明,该设计理论具有在工程实践中推广运用的价值。     

基于光电复合缆的水声信号采集发射传输系统

众所周知水下电磁环境复杂,在水下采用电缆传输电信号非常容易受到海洋电磁环境干扰,并且随着距离的增加,电信号受到干扰和衰减也就越大.因此水下中长距离的信号传输采用光电复合缆传输是一个比较好的选择,光纤用来传递水声信号,电缆用来传输电力.因此本文设计了一种基于光电复合缆的水声信号采集发射传输系统,能够很好地解决上述问题.本设计将要采集和发射的水声模拟信号在采集发射端和主机端转换成光信号,端到端之间的传输采用光信号,而采集发射端的供电则由光电复合缆的电缆提供.     

桨-舵间距对其组合系统水动力性能的影响

本文通过CFD方法对敞水桨、桨-舵组合以及优化间距的桨-舵组合装置开展了数值仿真研究，分析了桨-舵间距对其组合系统的水动力性能影响。螺旋桨敞水工况的计算值与物理模型试验值吻合良好，验证了数值计算方法的可行性。通过对比桨-舵间距大于推荐值的三个工况，发现在较低进阶系数下系统的节能效率有稍许增加，然而随着间距的增大，节能效率呈现降低的趋势；在高进阶系数下，随间距增大节能效率逐步降低。适当减小桨-舵间距，在较低和中等进阶系数下，随间距减小节能效率呈现逐步升高的趋势，在间距减少10mm时，组合体的节能效率最大可增加1.937%；不过在高进阶系数下，随间距减小节能效率却有下降趋势。     

酚醛树脂复合材料在轨道交通车辆上的应用

介绍了酚醛树脂复合材料试制的主要原材料、主要设备及仪器、试制流程及测试标准。详细阐述了酚醛树脂复合材料的氧指数、燃烧性能、机械性能、低密度等性能。分析了热压时间、热压温度及生产工艺对酚醛树脂复合材料性能的影响。试验证明,酚醛树脂产品的性能较为优良:热压时间控制在1.1~1.4 h时,复合材料的表面性能良好;热压温度为80~100℃时,可以得到表面质量细腻均匀的复合材料;适当调整生产工艺,可以提高酚醛树脂的产品质量、降低生产成本。     

Centrifuge modelling of pipe-soil interaction in clay with crust layer

Seabed in regions, such as the Gulf of Guinea and North West Shelf of Australia, may exhibit a crust layer where the undrained shear strength can be an order of magnitude higher than that of the immediately underlying sediment. This can complicate design of steel catenary risers, where fatigue depends on the cyclic vertical stiffness of the pipe-soil interaction. Potential punch-through of the riser into the underlying soft soil may invalidate design assumptions based on the pipe-soil stiffness within the crust layer. The long-term evolution of pipe-soil stiffness within the crust layer, which exhibits similar properties to an over-consolidated soil, is also poorly understood. This paper describes centrifuge model tests undertaken in a clay sample with a crust layer, simulating the punch-through process of a pipe under load control and investigating the pipe-soil stiffness during long-term cyclic loading tests under displacement control. Results confirm that the potential for punching-through the crust layer depends strongly on the relative ratio of pipe diameter to crust layer thickness. The long-term evolution of pipe-soil stiffness showed a steady increase after an initial remoulding stage in contractile soils (normally consolidated and lightly over-consolidated), but a steady reduction in the heavily over-consolidated, more dilatant, crust. The magnitude of pipe-soil stiffness changes (during both remoulding and reconsolidation) is governed by the over-consolidation ratio of the soil and the amplitude of the cyclic displacements. This study provides insights on the relevant cyclic stiffness to consider when assessing SCR fatigue life in over-consolidated soils and soils exhibiting a superficial crust layer.     

A study on the stability of a motorcycle wheel–swingarm suspension with chain transmission

The present study describes a possible driving mechanism for a self-excited oscillation observed in motorcycle dynamics, often referred to as chatter. This phenomenon, affecting the performance of road racing motorcycles, has been simulated in straight running braking manoeuvres with multibody motorcycle models. It involves rear suspension bounce and driveline oscillation in the frequency range between 17 and 22?Hz. A simplified model of a motorcycle rear suspension with chain transmission is proposed and its stability in equilibrium configurations is studied via eigenvalue analysis. The sensitivity with respect to all its governing parameters is analysed by means of stability maps and the self-excitation mechanism is explained with the aid of energy balance analysis and phase diagrams. It is found that the key role for the instability onset is played by the gradient of the nonlinear characteristic slip function of the tyre.     

基于多种失效模式SPS复合钢板替换船用钢板的优化设计

在SPS复合钢板的设计中获取不同的失效模式。以减重为目标,应用序列二次规划法对SPS复合钢板进行等效船用钢板的优化设计,同时对SPS复合钢板进行多目标优化,应用层次分析法定各目标的权重。在这两种优化方法的基础上,对船用钢板与SPS复合钢板进行了屈曲、弯曲对比数值分析,同时将结果与理论计算结果对比分析。结果表明,SPS复合钢板重量能够减轻37%以上,刚度增加两倍多,但厚度增加70%。