FRP正弦波形夹心桥面板的等效有限元模型

以FRP正弦波形夹心桥面板作为研究对象,得到等效正交各项异性实心板,通过理论分析和数值对比,证明了方法的可行性;采用该法对一实际的FRP正弦波形夹心板桥进行了模态分析。     

Determination of Critical Slip Surface of Soil Slope

A new complex method is presented considering not only the improvement upon the ＂bad ＂design point, but also the diversity of the newly generated complex, which is obtained by replacing the ＂bad ＂design point with the better design point located at the line between the ＂bad ＂design point and the ceotroid of the remaining design points of the old complex. The new complex method is applied to searching for the critical slip surface of two non-homogeneous soil slopes. The comparison of the results obtained by the new complex method with that by the basic complex method shows that the new complex method is much more likely to find the true critical surface for the randomly generated initial complex.     

基于ANN星识别算法的仿真平台

星敏感器是一种高精确度的姿态测量仪器，它通过对观测到的星点进行识别来计算姿态。为了能够较好地测试和验证星识别系统的性能，设计了一个基于ANN算法的星识别仿真平台。通过对该星识别仿真平台性能的测试，表明该仿真平台能够方便，实时地测试星识别算法的性能与正确性，因此说它是一种具有较好实用价值的星识别仿真平台。     

用高温超导线圈和常导线圈构成的混合式电磁悬浮系统

常导电磁吸力悬浮系统悬浮气隙小、悬浮功率大,电动斥力悬浮系统不能实现静止悬浮、磁场污染大。由于受电流变化率限制,单独采用高温超导线圈构成的电磁吸力悬浮系统不能实现稳定悬浮。经分析比较,提出了一种用高温超导线圈和常导线圈构成的混合式电磁吸力型悬浮系统方案。采用这种混合式悬浮方案可增大悬浮气隙、实现稳态"零"功率悬浮、减轻车体重量、降低制冷费用、且无磁场污染。     

Mixed analysis of shell and solid elements using the overlaying mesh method

 This article presents a mixed method of analyzing shell elements and solid elements using the overlaying mesh method. In the structural design of a ship's hull, the shell elements are used for the global model. However, the solid elements are necessary to analyze the stress concentration zones or the vicinity of a crack. In such cases, the models are analyzed using zooming analysis, in which the results of a global model analysis are transferred to a local model analysis by imposing boundary conditions. This method is more advantageous than zooming analysis in terms of the accuracy of the solution and the modeling flexibility. Some examples of a plate model with a cracked surface or with a projection are shown in order to demonstrate the effectiveness of the method. Received: August 6, 2002 / Accepted: November 25, 2002 Address correspondence to: S. Nakasumi (sumi@nasl.t.u-tokyo.ac.jp) Updated from the Japanese original, which won the 2002 SNAJ prize (J Soc Nav Archit Jpn 2001;189:219–224; and 190:655–662)     

复突触神经网络模型及其稳定性研究

传统的Hopfield网络在联想记忆、优化计算方面发挥了重要作用,但该网络存在一个弊端,即它只能处理线性或二次的最优化问题。因此,本文首先对Hopfield神经网络进行了扩展,将其称为复突触神经网络(或模型),扩展的网络不仅可以解决目标函数或约束中含有高阶的最优化问题,而且还可以处理目标函数含有对数、三角形式等较复杂函数的最优化问题;然后给出了该网络稳定的充分条件并给出了证明,同时对网络中的权矩阵是否对称也进行了讨论;最后结合典型的模糊c均值聚类问题验证了该模型的有效性。     

Numerical simulation of the flow about self-propelling tanker models

A time-marching CFD simulation is performed for self-propelling ships. The flow about the hull is simulated by the finite-volume method, and the propeller action is approximated as a propeller disk for which the solution is given by a simplified propeller model. The interaction of two flow models is treated in a time-marching procedure converging towards the steady self-propelling condition. This method is applied to five tanker models, and detailed comparisons are made between the simulated results and corresponding experimental results. It is shown that the flow field in the self-propelling condition is qualitatively well reproduced in the simulation, and the estimated thrust deduction factors for the five hull forms agree well with measured ones. However, the effective wake factors are underestimated, since the Reynolds number in the simulations differs from that in the experiment.     

船舶压载水不同处理方法的经济性分析

对船舶压载水不同处理方法所需费用和代价进行了简要评述。     

装配式公路钢桥承载力的有限元分析

指出装配式公路钢桥设计中所采用的简化计算方法的不足,使用大型有限元软件ANSYS对其受力情况和承载力进行了分析,并与简化计算方法作了对比,得出了一些规律性的结论,对实际应用具有指导意义。     

成昆线红层地区泥石流沟侵蚀程度量化分析

以成昆铁路红层地区的3个小流域为研究区,计算3个年份的地面割裂度及其年平均变化率,分析用地面割裂度表征泥石流沟侵蚀程度的不足及其原因。基于泥石流沟发育的物理模型,以原来的地面割裂度定义为基础,引入表述沟谷分布零散程度的异型度因子,导出新侵蚀系数公式。以3个小流域固体物质的年平均流失量作为侵蚀程度强弱的标准,采用非参数统计推断方法,将侵蚀系数、地面割裂度的年变化值和固体物质的年平均流失量作秩统计和次序统计。对秩统计参数和次序统计参数比较结果表明:在表征泥石流沟侵蚀程度方面,侵蚀系数优于地面割裂度。