Assessment of the volume of fluid method for free-surface wave flow

This study was concerned with the free-surface wave flow around a surface-piercing foil. The volume of fluid method implemented in a Navier–Stokes computational fluid dynamics code was employed. Three widely used discretization schemes for the volume of fluid method were assessed for a test case that involved general ship waves, spilling breaking waves in front of the leading edge, and bubbly free surfaces in separated regions. A single computational approach was selected for the comparison, and a grid-dependence study was carried out. The computational results were validated against existing experimental data, showing good agreement. The validation results suggest that all three discretization schemes perform well, but the best and most efficient results were obtained using the high-resolution interface capturing scheme.     

路网环境下考虑大型车混入率的事故疏散诱导模型

大型车的混入对高速公路交通流产生了较大的影响，尤其是在交通事故情景下。为了引导事故条件下驾驶人和组织者做出高效准确的决断，将考虑了大型车混入率的动态空间占有率模型引入到交通波模型，构建干涉与非干涉情景下的交通事故影响模型。以郑尧高速为例，对模型的准确性和可行性进行了验证，分别对干涉情景下的疏散时间、疏散量以及事故发生的位置，车辆数等指标与事故影响程度的指标（包含事故最远排队长度，事故持续时间）关系进行分析。研究结果表明：疏散时间与事故影响程度成正相关关系，疏散量与事故影响程度成负相关关系，而事故发生点与上游匝道之间的距离与其关系不大；道路服务水平为0.456，车辆数为1 321 veh·h^-1时，为了使得分合流区不受影响，在不采取任何措施的情景下，应将大型车混入率控制在50.1%以下，使得最远排队长度在10 km内；当大型车混入率大于58%时，将很难通过干涉引导避免对上游分合流区产生影响；在35 min以内采取干涉措施的效果最为明显，而大于35 min时，事故持续时间会发生一个急剧的增加，不利于路网恢复，之后事故恢复时间将趋于平稳；对道路交通量进行模拟可知交通量每增加50 veh，疏散时间和距离增加的范围为[1.5 min，3.6 min]和[1.209 km，1.543 km]。研究结果可为高速公路事故诱导策略制定和疏散效果提升提供参考。     

隧道下穿运营机场跑道的爆破振动安全判据研究

以我国第一座采用钻爆法下穿运营机场跑道的隧道恩施金凤大道许家坪隧道工程为依托,开展对机场跑道的爆破动力安全判据的研究。首先基于应力波传播理论及极限拉应力准则,对爆炸应力波传播至机场跑道上表面(即自由面)处发生的反射进行理论分析,建立基于混凝土跑道结构安全的爆破振动速度判据模型,并提出跑道的爆破振动速度安全阈值;同时,基于数值模拟,从统计角度建立拉应力峰值与质点振动速度峰值之间的函数关系,求解得到机场跑道的爆破振动速度安全阈值。最后,将理论分析结果、数值计算分析与《爆破安全规程》进行对比分析,最终确定机场跑道的爆破振动速度安全判据,为在隧道下穿机场跑道爆破施工提供了依据。     

Investigation of ship waves in a narrow channel

This paper presents a discussion of the characteristics of ship waves in a narrow channel restricted by vertical walls, based on observed data and the results computed by a 2-D model. In the numerical model, the propagation of waves generated by a moving ship is simulated by solving 2-D depth-integrated Boussinesq equations. To get the boundary conditions at the location of the ship, the slender-ship approximation is employed. A field observation was carried out at a straight length of navigation channel. The ships targeted in the observations are two kinds of waterbuses with lengths of 28 and 24 m. The relative depth Froude number for the river current, an appropriate parameter for assessing the influence of the current on ship wave characteristics in a navigation channel, ranged from 0.47 to 0.76. The observed maximum wave height varied between 0.13 and 1.26 m. The maximum wave height of the wave train is sharply increased when the relative depth Froude number exceeds 0.6. The results computed by the present model agree fairly well with the observed data.     

浅谈青岛港集装箱码头轮胎吊自动纠偏技术

为了提高效益,确保安全,青岛港集装箱码头进行了轮胎吊大车行走纠偏技术攻关,对几种自动纠偏方式进行了分析比较,选择超声波技术作为最佳方案。具体介绍了超声波技术方案的实施步骤及出现的几种工况,该方案取得了良好的效果。     

基于MSP430的低功耗水中低频信号采集系统

为了采集水中低频信号,提出基于MSP430F1611单片机和Flash存储器的水中低频信号数据采集与存储系统,实现了水中目标测量中的低噪声、低功耗、智能自动记录和大容量存储等关键技术,海上试验结果表明该系统精度高、性能可靠。     

Response-based extreme value analysis of moored offshore structures due to wave, wind, and current

Floating moored offshore structures have a significant future in offshore operations as an attractive economic alternative to fixed structures in deep waters and/or in areas where there is no existing infrastructure. This paper describes an analysis procedure based on the structure variable approach to estimate load and response values of a moored offshore platform at a given return period by taking into account the joint occurrence of wave, wind, and current. The results show that the most severe mooring loads may not occur when wind, wave, and current are collinear and are at their maximum design values, i.e., the 50- or 100-year case. It is recommended that the extreme mooring design loads for moored offshore systems should be determined through a range of physical or numerical simulations where wave, wind, and current are noncollinear and act with less severe magnitudes than the 50- or 100-year case. This recommendation has also been adopted in the ITTC/Ocean Engineering Committee recommendations to the ITTC Conference held in September 1996.     

IPS式波能转换装置实验研究

介绍了一种新型高效的IPS式波能转换装置,通过不同波况下实验装置输出功率的比较,得出了适合该装置工作的最佳入射波周期,为IPS式波能转换装置的工程应用提供了有益的参考。     

CRH3动车组单车隧道压力波特性估算

采用国内研制的高速列车通过隧道时压力波计算程序,模拟了特定隧道条件下CRH3动车组单车隧道压力波的基本特性,给出了隧道内、车头车尾处的压力波分布情况,以及对应车内处3 s内最大压差值等随车速变化的规律。同时,比较了动车组在德国和我国隧道条件下压力波的异同点。     

毫米波立体成像雷达

毫米波雷达目前是车用探测雷达中最为主要的探测器件,但目前的毫米波雷达是进行二维扫描平面扫描,如何进行立体扫描是毫米波使用的重要研究方向,文章利用波束集中及3D MIMO计算实现了立体点云扫描。