岷江上游大型水电站运行对龙溪口下游航道枯水期水位和流量的影响

根据规划,岷江龙溪口—宜宾段将通过航道整治达到内河Ⅲ级航道标准.该河段多年历时保证率95％的流量仅能达到662 m3/s,但是岷江上游紫坪铺、瀑布沟等大型水电站的建成对下游河段通航流量产生了较大影响.根据紫坪铺水电站蓄水前、后高场水文站的径流、泥沙资料,分析紫坪铺等大型水电站建成后对下游河段水沙特性的影响,得知岷江上游...     

带支撑梁的船闸闸室裂缝成因分析

针对某船闸闸室施工期在支撑梁上部出现表面裂缝的问题,基于有限元原理,分析闸室表面裂缝的成因及分布规律,并提出防止表面裂缝产生的温控措施.分析结果表明:早期在支撑梁上部出现表面裂缝主要是因为内外温差以及支撑梁对新浇筑混凝土的约束作用;在控制浇筑温度的基础上,采取表面保温和内部水管冷却相结合的温控措施,可以将表面点的抗裂安全系数提高至1. 40.该方案在后续施工应用后未出现表面裂缝,达到了良好的防裂效果.     

水火弯板线位移视觉测量中的标定精度分析

采用计算机视觉的方法对水火弯板的线位移进行测量,旨在找出板材在水火弯曲成形加工中的变形规律,为实现水火弯板的机械化和自动化提供数字参考。然测量精度的高低直接决定着这些数据的可靠性,而在影响视觉测量精度的诸多因素中,标定块的尺寸精度是一个重要的内容。相对真值可通过损失函数的分析来认定。     

针对儿童座椅拉拽失效的车身结构改进

在乘用车前期设计阶段,为让儿童保护的安全性能得到控制和优化,以某乘用车根据国家安全法规要求进行儿童座椅拉拽台架试验时,ISOFIX固定装置出现焊点从车身上拉脱失效为例,基于焊点热影响区损伤的焊点失效准则和钣金断裂失效准则,运用有限元分析对其进行虚拟评估和结构改进,有限元分析与试验结果吻合良好.改进结构通过了儿童座椅拉拽...     

有轨电车氢燃料电池系统通风散热方法研究

为解决有轨电车氢燃料电池系统的散热问题,文章提出一种新型车载氢燃料电池系统通风散热方法,分析了该方法的散热原理和控制策略,并对通风散热结构进行了详细介绍.该车载氢燃料电池系统通风散热方法提高了系统散热效率,降低了散热风机能耗.     

取样剪切对管输原油流变性的影响

通过实验及理论分析,系统研究了取样剪切对管输原油流变性的影响,根据鲁宁线运行工况,计算了阀门节流剪切及过泵剪切时剪切率的大小.对于鲁宁线,在同一泵站,出站处阀门节流平均剪切率是过泵平均剪切率的3倍左右.     

快速脱缆钩过载问题分析与解决措施研究

本文介绍了巴基斯坦卡西LNG码头双船并靠模式的快速脱缆钩布置和选型方法,介绍了FSRU/LNG船舶的系缆过程以及在这个过程中发生的快速脱缆钩过载停车故障问题,针对停车故障问题,分别进行了三次现场检测研究,通过检测引缆过程中快速脱缆钩绞盘电动机内的电压和电流,计算出电动机的实际功率和实际拉力,并针对检测结果的详细分析研究...     

Corrosion rate measurements in steel sheet pile walls in a marine environment

Corrosion of steel structures in the marine environment is a major problem. The deterioration of this kind of structures is costly and difficult to predict both when designing new structures and when estimating the remaining service life time for existing structures. The aim of this investigation was to find indicative values for the corrosion rate of steel sheet piles on the Swedish west coast. Such corrosion rates (mm/year) can be used both when designing new structures by oversizing the steel thickness and when estimating the bearing capacity of existing sheet pile structures. Earlier investigations on the corrosion rates along the Swedish east coast – with salinity from about 0.2% to 0.8% – are still used today as guidelines for the corrosion rate of all steel structures in the Swedish maritime environment even though the salinity on the west coast can be as high as 3.0%.Steel sheet pile wharfs located in the port of Halmstad on the Swedish west coast were inspected by ultrasonic measurements. Three wharf structures with a total length of about 700 m were inspected. None of the inspected wharfs had or have had cathodic protection. The thickness measurements of the steel sheet pile structures were performed by divers.The age of the three inspected sheet pile structures ranged from 36 to 51 years. The dimensions of the original sheet pile sections are known. One of the quay structures is located along a river. The salinity at all wharfs varied from low values at the surface to approx. 2% at the bottom (also in the river outflow).The measured average corrosion rates were in the same order as the design values in the European code. However, the results indicate increased corrosion rates about 1 m below the mean water surface and at the level of the propellers from the ships berthing the most frequented of the inspected wharfs, 3–6 m below water surface.The tolerances of steel sheet thicknesses – usually in the order of ±6% – are often neglected when investigating the remaining thickness in steel sheet piles. A simple calculation model shows that the sheet pile must be almost 50 years of age before an accurate estimation on the corrosion rate can be made, considering the tolerances, if the true original sheet pile thickness is not known.     

沥青路面运营初期平整度竣工验收标准研究

采用数理统计原理,运用SPSS软件对陕西省7条高速公路交-竣工平整度数据进行分析,得出了陕南、关中和陕北地区路面平整度衰变幅度均值分别为0.39m/km、0.28m/km和0.24m/km,这也将作为计算竣工验收推荐值的依据;再基于交-竣工平整度变化规律,建立了平整度竣工验收推荐值的计算公式:IRIju=IRIji+IRIs,可为今后平整度竣工验收标准提供有效的理论依据。