管桩加固软土路基桩土相对位移分析

管桩加固软土路基作为一种新的处理方式可以有效地解决路基稳定和总沉降的问题,但是桩顶平面会产生较大的桩土相对位移。对桩土相对位移的形成机理进行分析,利用桩土相对位移的原型观测试验,从变形的角度研究桩土协同工作性状,同时提出了桩土相对位移的控制方法。     

灌注混凝土桩施工方法及工艺的探讨

通过对钻孔灌注桩与沉入桩的对比分析,得出了钻孔灌注桩的优点,并且详细介绍了钻孔灌注桩的施工工艺和方法,总结了提高灌注混凝土桩承载力的方法和灌注桩的检测手段及一般事故处理方法,以供今后类似工程实践参考.     

复杂地质和环境条件下水闸围堰工程设计技术

在河流中建设水闸、船闸,其围堰工程是保证主体工程安全干施工的重要前提和保障。结合某水闸工程设计,针对围堰设计遇到的地质和环境条件复杂、施工场地狭窄、施工期不断流等难题,开展围堰总体布置、纵横向围堰结构设计、支护围堰结构设计、围堰止水墙设计等一系列关键技术问题研究。采用研究成果设计的方案不仅可以减少围堰工程量、节约工期,而且能确保项目顺利安全实施。     

多年冻土区钻孔灌注桩施工过程热力特性研究

钻孔灌注桩水化热会暖化冻土引起桩基承载力下降,以桩基水化热在时间与空间上的影响效应为研究目的,结合青藏公路G214沿线查拉坪旱桥桩基观测数据,分析水化热对地温场的扰动范围以及桩周土回冻时间,给出灌注桩18 d内的养护温度。结果表明:水化热对距桩1.95 m以外地温影响微弱;144 d后桩侧温度降至0℃以下,229 d后桩侧温度低于-0.5℃;2 a后桩侧基本回冻至天然地温,此时承载力已达到设计要求。桩基混凝土养护温度前5 d在10℃以上,5~12 d在5℃以上,12~15 d为2℃以上,15~18 d仍高于0℃。通过数值仿真给出混凝土入模温度及桩基施工时间对桩周温度场的影响,模拟结果显示,该区域的灌注桩施工可以在相应规范规定范围内提高混凝土入模温度;灌注桩施工可以在冷季进行,但要做好5 m以上深度桩基混凝土的温控措施。     

Dynamic stride length adaptation according to utility and personal space

Pedestrians adjust both speed and stride length when they navigate difficult situations such as tight corners or dense crowds. They try to avoid collisions and to preserve their personal space. State-of-the-art pedestrian motion models automatically reduce speed in dense crowds simply because there is no space where the pedestrians could go. The stride length and its correct adaptation, however, are rarely considered. This leads to artefacts that impact macroscopic observation parameters such as densities in front of bottlenecks and, through this, flow. Hence modelling stride adaptation is important to increase the predictive power of pedestrian models. To achieve this we reformulate the problem as an optimisation problem on a disk around the pedestrian. Each pedestrian seeks the position that is most attractive in a sense of balanced goals between the search for targets, the need for individual space and the need to keep a distance from obstacles. The need for space is modelled according to findings from psychology defining zones around a person that, when invaded, cause unease. The result is a fully automatic adjustment that allows calibration through meaningful social parameters and that gives visually natural results with an excellent fit to measured experimental data.     

基于ANN的船舶撞击高桩码头群桩损伤位置预测

本文采用有限元软件ABAQUS建立了船舶撞击高桩码头群桩的空间有限元模型。通过计算评估了撞击力、桩体刚度、撞击位置和撞击角度下对群桩结构损伤位置的影响。基于人工神经网络(ANN)方法,对不同参数组合下的群桩结构损伤位置进行了预测,并对ANN方法的可行性进行了评估。     

桥墩及桩基形式对墩底平转施工转盘设计的影响

以新建福厦(福州—厦门)高速铁路17500 t转体刚构为背景,采用实体有限元方法分析了不同桥墩类型及桩基布置对墩底平转转体中转盘受力的影响,并对桥墩及桩基进行了优化。结果表明:实体墩对上转盘受力最有利,其次是空心墩,最不利的是双薄壁墩;增加墩底实体段能够有效降低空心墩、双薄壁墩上转盘的主拉应力;随着墩底实体段高度的增加,主拉应力降低的幅度逐渐变小;球铰正下方有桩基时对下转盘底部受力更加有利;距离球铰中心越远,桩基受力越小,适当增加中桩桩径,可使各桩基应力状态更加均衡。     

The symmetric intersection design and traffic control optimization

It is well recognized that the left-turning movement reduces the intersection capacity significantly, because exclusive left turn phases are needed to discharge left turn vehicles only. This paper proposes the concept of Left-Hand Traffic (LHT) arterial, on where vehicles follow left-hand traffic rules as in England and India. The unconventional intersection where a LHT arterial intersects with a Right-Hand Traffic (RHT) arterial is named as symmetric intersection. It is only need three basic signal phases to separate all conflicts at symmetric intersection, while it at least need four signal phases at a conventional intersection. So, compared with the conventional intersection, the symmetric intersection can provide longer green time for the left-turning and the through movement, which can increase the capacity significantly. Through-movement waiting areas (TWAs) can be set at the symmetric intersection effectively, which can increase the capacity and short the cycle length furthermore. And the symmetric intersection is Channelized to improve the safety of TWAs. The Binary-Mixed-Integer-Linear-Programming (BMILP) model is employed to formulate the capacity maximization problem and signal cycle length minimization problem of the symmetric intersection. The BMILP model can be solved by standard branch-and-bound algorithms efficiently and outputs the lane allocation, signal timing decisions, and other decisions. Experiments analysis shows that the symmetric intersection with TWAs can increase the capacity and short the signal cycle length.     

地铁供电系统中压开关柜电流分析理论和方法

通过分析地铁供电系统不同电压等级的设备电流特征,确定35 kV电压等级设备电流可构造标准曲线,采用机器智能学习算法分析、测算地铁供电系统中各类开关峰谷时段运行电流,以均值-方差方法确定电流的高度异常偏离点,实现异常点数据周期内统计以及实时提醒功能。应用电流实测值分析电流在工作日、节假日的不同曲线,为负荷预测和非正常运行方式下的负荷叠加风险提供预测和评估依据,保障供电系统的安全运行,提高负荷管控效率。     

海上风电大直径单桩基础固有频率影响因素的数值分析

针对海上风电整机结构其低阶固有频率的控制问题,基于有限元分析技术开展小直径桩土相互作用的数值模拟分析,与试验结果、API规范计算结果进行对比,验证了数值模型的适用性,分析大直径单桩结构桩内土芯、冲刷深度、表层土置换措施对整机固有频率的影响,结果表明,基于有限元实体单元计算所得一、二阶整机固有频率要明显大于传统p-y方法计算结果;桩内土芯对一、二阶整机固有频率影响很小;在一定范围内,随着泥面冲刷深度的增加,一、二阶固有频率降低不明显,认为传统p-y方法对于大直径单桩的适用性有待研究;在实际工程设计中,桩内土芯的影响可忽略;对于大直径单桩,在一定范围内可以忽略冲刷的影响。